WenmarOpen by Wenmar Pro

Service bulletins for the 2019 Chevrolet Silverado

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

2229 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
PIP56072018-11-26. Service bulletin. ENGINE. This Preliminary information communicates that GM engineering is investigating the root cause of DTCs P24B3 and / or P24B5 setting.
PIP56062018-11-26. Service bulletin. ENGINE. This Preliminary information communicates A vehicle may have a tick noise from the engine cold, initial start in the morning. A lifter may not have sufficient amount of oil during cold start operation (not pumped up). As information comes in the Pi will be updated and when the final repair is out this this PI will be changed to a Bulletin
PIT5630A2018-11-26. Service bulletin. EQUIPMENT; EQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM. This Preliminary information communicates the possible setting of B101D-39 in the OnStar module and advises of byte info to retrieve while engineering completes further investigation.
PIT56382018-11-26. Service bulletin. SERVICE BRAKES. This Preliminary information communicates an issues with a Service Brake Assist Message With DTC C053D or C058E and that engineering is working on updated software to correct this issue.
PIT5438E2018-11-26. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that have a click, rattle or a squeak nose coming from the dash. Technician will use Service Information to locate the Accessory AC and DC Power Control Module located to the right of the steering column. Remove the power inverter module and apply two sided tape to the module bracket to insulate it from the mount. The instrument panel accessory bezel will also need to be removed. Apply flocking tape to the instrument panel accessory bezel retainers. Also the instrument panel extension will need to be removed. Apply foam tape around connectors located under grill to prevent them from rattling on grill. Apply flocking tape to the instrument panel extension retainers and apply a strip of foam tape along the edge of the grill to isolate the grill from the dash.
PIP5159C2018-11-26. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on and Diagnostic Trouble Code P0300 - P0308 may set. Technician will inspect for lose sparkplug wire. If a spark plug wire is found lose check for a missing ?C? clip on the wire end for the ignition coil. If the clip is missing replace the wire.
PIP5579A2018-11-26. Service bulletin. STRUCTURE. This Preliminary information communicates that the front and rear axle assemblies are restricted from dealer ordering or replacing to assist engineering in identifying any issues.
PIT5633A2018-11-13. Service bulletin. VISIBILITY. This Preliminary information communicates an issue with the power folding outside mirrors not stopping at the correct location when the mirror is power folded. Repair is to perform a mirror reset.Engineering is working on an updated mirror pivot detent.
PIT5392C2018-11-13. Service bulletin. SERVICE BRAKES. This Preliminary Information communication provides information to the technician about vehicles that have a detent / click with a feel of increased resistance when the accelerator pedal is about ¾ of the way. The new accelerator pedal design has a built-in detent position near the last 1/4 of pedal travel. Dealer should communicate to the customer this is a normal operating characteristic of the vehicle and no repair attempts should be performed.
PIT56372018-11-13. Service bulletin. EQUIPMENT. This Preliminary information communicates normal radio display operation when shifting into reverse. Per FMVSS 111 an image must be displayed when shifted into reverse even when a vehicle is not equipped with a backup camera.
PIP55942018-11-13. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the dealer technician that there may be a possibleMis-build of the Diesel Exhaust Fluid (DEF) Injector if it was built before provided break point.
PIP56002018-11-13. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicatesA vehicle may come in with a DTC P0011 set,A sticking oil control solenoid for the cam actuator.Since the L84/L87 is on exchange,(PIP5567)engineeringhas decided that we will authorize the replacement of the OCV valve bolt for P0011 DTC’s.
PIT5298C2018-11-13. Service bulletin. EQUIPMENT. This Preliminary Information communication provides information to the technician on installing Regular Production Option Code 9L7 Up-fitter Auxiliary Switches. Technician will need to reference the latest version of General Motors Up-fitter Integration Bulletin 110. The information can be found at http://www.gmupfitter.com/ under the "Technical Bulletin" Tab and then "Show all bulletins."
PIT56362018-11-13. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE. This Preliminary information communicates an issues with a SES MIL and DTC P1005. GM Engineering is working to root cause this issue.
PIT5359C2018-11-13. Service bulletin. EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that may have a radio backlighting will stay on even after the ignition has been turned off and the key has been removed for several minutes, eventually the battery will drain. Technician may find following fuses F23DL F22DL F30DL F31DL F32DL with the ignition key in the off position to have voltage. Technician should not replace the Transfer Case Control Module. Technician will need to install a diode, part number 12112422, across the coil of the solenoid. It is important that the striped end of the diode be connected to the positive terminal of the coil and the other end of the diode be connected to ground.
PIT5544B2018-11-13. Service bulletin. STEERING; STEERING:ELECTRIC POWER ASSIST SYSTEM. This Preliminary information communicates information on ahydrauilc rush type noise from the power steering gear. This noise is a characteristic of the new Active Hydraulic Assist System RPO NV8 and no repairs should be made. The noise is most noticeable in the cab at idle, in park, with all accessories turned off.
PIP5491A2018-11-13. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. This Preliminary information communicates to the technician when diagnosing intermittent circuit concerns to look at the connector for missing weather pack seals that could allow water intrusion into the connector and lead to corrosion on the terminals.
PIP5570A2018-11-13. Service bulletin. STEERING:GEAR BOX:SHAFT PITMAN; STEERING:GEAR BOX:SHAFT SECTOR. This Preliminary information communicates to the dealer a conditionwhere a tick noise may be present inside a vehicle while driving. This may be the result of a deformed or improperly seated steering shaft seal allowing engine compartment sounds into the vehicle. Dealers are instructed to replace or reinstall the boot as needed and are informed the condition is being reviewed by engineering.
PIT56342018-11-13. Service bulletin. SERVICE BRAKES. This Preliminary information communicates and issue with acustomer concern of a SES MIL, Reduced Engine Power, Service Brake System, and/orSpeed Limited message,a lack of brake assist making the brake pedal hard andDTCP0606. These issues can be caused by a low voltage conditions, but the EBCM incorrectly sets a DTC P0606 for aControl Module Processor Performance error. If the SI diagnostics are followed for DTC P0606 it can leadto amisdiagnosis and an incorrect repair. Dealers are advised to inspect for a low voltage condition and follow SI diagnostics forDTC P0562 "System Voltage Low". Engineering is trying to determine next steps in the resolution of this issue. It will likely be an update to SI or a change to the EBCM Calibration or both.
PIT4322J2018-10-15. Service bulletin. ELECTRONIC STABILITY CONTROL (ESC). This Preliminary Information communication provides information to the technician about vehicles that have an unwanted Stability Activation and/or a Service Stability message on the Driver Information Center. Technician may find a Diagnostic Trouble Code C0710. Technician should inspect for vehicles modifications before any in-depth diagnostics are performed.
PIT56312018-10-15. Service bulletin. ELECTRICAL SYSTEM. This Preliminary information communicateanissuewith theVideo Processing Control Module setting a false DTC U0020 and advises dealership to ignore it.
PIT5403E2018-10-15. Service bulletin. SUSPENSION. This Preliminary Information communication provides information to the technician with the steps to diagnosis and repair vehicles with various handling, vehicle dynamics concerns, noises from the suspension or underbody, or issues related to damaged suspension components. Before any in-depth diagnostics are performed, be aware that various issues could occur if the vehicle has been modified and inform the customer the conditions noted may not be covered under warranty. Technician will inspect for installed aftermarket suspension components. Also inspect for improperly adjusted torsion bars.
PIT5576B2018-10-15. Service bulletin. STRUCTURE. This Preliminary information communicates and issue with the hood ajar message being displayed when the hood is not ajar. Inspect the body ground strap to insure it is connected in the proper locations and the strap eyelets are tight and do not rotate.
PIP55852018-10-15. Service bulletin. ELECTRICAL SYSTEM. This Preliminary information communicates As part of our ongoing quality improvement efforts the Engine Control Module (ECM) E90 part numbers 12690383will be placed on a parts restriction through the Product Quality Center (PQC)This parts restriction will assist Engineering with product feedback
PIT5361D2018-10-15. Service bulletin. SERVICE BRAKES. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have issues were the customer will need increased effort to depress the brake pedal. Technician may find fluid in the brake booster and/or the booster vacuum line. Technician will need to replace Vacuum Pump, Brake Booster, Master Cylinder, Vacuum Pump Belt and the Vacuum Line between the booster and the pump.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.