WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Chevrolet Silverado

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

3099 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
PIP5212B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have run hot and or has a tick noise. Technician should inspect the head gaskets to ensure are not installed backwards. Technician should replace the head gasket if they are found installed backwards.
PIP5503A2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the dealer additional information on checking for the engne crankcase being overfull on oil causing an engine vibration concern. The technician is advised to inspect for contaminnants and adjust the engine oil level as needed.
PIP5540B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP5382K2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication advises the technician that generation 5 engines with Regular Production Option Code L83, L86, or LV3 may have an oil consumption concern were one quart in 2000 miles is being used. Dealer will confirm oil level was properly checked per Owner's Manual, and check the bolt torque on the Valve Lifter Oil Manifold Assembly, before doing any repairs to the vehicle.
PIP4925B2019-03-18. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This preliminary information document communicates a tip on the way to diagnose possible induction or exhaust air leaks using the evaporative emission cart smoke machine and ultrasonic leak detector tools.
PIP5540D2019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP56282019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates information that will need to be provided to TAC to aid in diagnosing if a vehicle comes in with misfire and DTC Codes P0300 - P0308 and/or P050D
PIT5391E2019-03-11. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that have a no crank or a start and then immediate stall, Service Engine Soon Malfunction Indicator lamp may not be on when the ignition is in the run position. Technician may find Diagnostic Trouble Codes P0513 and or P262B may also be set. Technician will pulled the driver sill plate and inspect the wiring for damaged or corroded circuits. Technician will repair any damaged or corroded circuits.
PIP5554A2019-03-11. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates P0016 setting after internal engire repair. The engine Base timing is not being set correctly. The information in this PI will be helpful in setting the timing in the vehicle.
PIT5350B2018-12-17. Service bulletin. ENGINE. This Preliminary Information communication advises the technician that there have been some reports that the current engine hours are not correct and display 0.0. Technician will need to program the Instrument Panel Cluster using Service Programming System.
PI1164A2018-12-10. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM:RADIATOR ASSEMBLY; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This preliminary bulletin provides information on how to check for ice and/or snow build up and to install a radiator cover to correct the customers concern of reduced engine power and service engine message on.
PIP5159C2018-11-26. Service bulletin. ELECTRICAL SYSTEM; ENGINE. This Preliminary Information communication provides information to the technician about vehicles that may have a Service Engine Soon Malfunction Indicator Lamp on and Diagnostic Trouble Code P0300 - P0308 may set. Technician will inspect for lose sparkplug wire. If a spark plug wire is found lose check for a missing ?C? clip on the wire end for the ignition coil. If the clip is missing replace the wire.
PIP4138R2018-11-13. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have a Service Engine Soon Malfunction Indicator Lamp on, engine misfire, and/or engine noise. Technician may find Diagnostic Trouble Codes P0300-P0308. If published Service Information diagnostics does not isolate the cause of this concern technician should check for a worn camshaft lobe and/or lifter roller, a sticking valve, valve leakage, a broken valve spring, and a collapsed active fuel management lifter.
182362018-11-13. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE; ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER. 18236 - Special Coverage - On some vehicles, equipped with the LML (DURAMAX 6.6L V8 TURBO Diesel) engine, the exhaust turbocharger outlet pipe may have a bad weld. Smoke may be noticed from under the hood at a stop or while driving. The customer may also smell exhaust gas. Dealers are to replace the exhaust turbocharger outlet pipe. The repairs will be made at no charge to the customer.
PIP5163D2018-09-17. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.
PIP5370D2018-09-17. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. This Preliminary Information communication provides information to the technician that some vehicle may have an “Exhaust Fluid Quality Poor” on the Driver Information Center or a diesel exhaust fluid warning lamp on or other exhaust fluid quality related concerns. Technician will inspect the diesel exhaust fluid for contamination. Technician should use Service Information for Contaminants in Diesel Exhaust Fluid Diagnosis and use special tool J26568 or EN50422 Diesel Exhaust Fluid Refractometer for fluid testing.
170672018-08-20. Service bulletin. FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. 17067 - Product Emissions Recall. General Motors has decided to conduct a Voluntary Emission Recall on certain vehicles equipped with a 6.6L diesel (LML) engine and dual fuel tanks (N2N). Under certain driving conditions, fuel may not be transferred from the rear fuel tank to the front fuel tank at a sufficient rate. If this occurs, the diagnostic trouble code (DTC) P2636 will set, the malfunction indicator lamp will illuminate, the fuel gauge will display empty, and the transfer pump will be disabled until serviced. If the vehicle continues to be driven, it will run out of fuel in the front tank and stall. Dealers are to replace fuel line connections to allow the rear tank, in addition to the front tank, to directly supply fuel to the engine. The engine control module (ECM) will also be reprogrammed with calibrations necessary to support this new connection.
PIP5121C2018-08-06. Service bulletin. EQUIPMENT; ENGINE; EQUIPMENT ADAPTIVE/MOBILITY. This Preliminary Information communication provides information to the technician about vehicles that have the oil pressure gauge jumps from approximately 40 lb. to 60 lb. The 4.3L (LV3), 5.3L (L83), 6.2L (L86) engines are equipped with a two stage oil pump. Dealer should advise the customer this is normal operation for these engines.
PIP5370C2018-08-06. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM; FUEL SYSTEM, DIESEL. This Preliminary Information communication provides information to the technician that some vehicle may have an “Exhaust Fluid Quality Poor” on the Driver Information Center or a diesel exhaust fluid warning lamp on or other exhaust fluid quality related concerns. Technician will inspect the diesel exhaust fluid for contamination. Technician should use Service Information for Contaminants in Diesel Exhaust Fluid Diagnosis and use special tool J26568 or EN50422 Diesel Exhaust Fluid Refractometer for fluid testing.
PIP5151E2018-08-06. Service bulletin. FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that may have a hard start, no start, rough running, or low fuel pressure. Technician may find Diagnostic Trouble Codes P0087, P0088, P0191 and P128E during the inspection. If during the inspection of the fuel system contamination is found the complete fuel system will need to be cleaned and flushed. After the fuel system is cleaned out test the fuel using the latest version of PIT3173.
PIP5498K2018-08-06. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates. A vehicle may have a concern ofDTCP050D setting along with a P0300 after a cold start up. White smoke and/or coolant odor may come from exhaust for an extended period of time at cold start as well. Cause Coolant getting into the cylinders, and provides direction for the repair.
PIP5498J2018-08-06. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates. A vehicle may have a concern of DTCP050D setting along with a P0300 after a cold start up. White smoke and/or coolant odor may come from exhaust for an extended period of time at cold start as well. Cause Coolant getting into the cylinders, and provides direction for the repair.
170672018-08-06. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:DIESEL; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL; ELECTRICAL SYSTEM:SOFTWARE; FUEL SYSTEM, DIESEL:STORAGE:TANK ASSEMBLY; FUEL SYSTEM, DIESEL. 17067 - Product Emissions Recall. General Motors has decided to conduct a Voluntary Emission Recall on certain vehicles equipped with a 6.6L diesel (LML) engine and dual fuel tanks (N2N). Under certain driving conditions, fuel may not be transferred from the rear fuel tank to the front fuel tank at a sufficient rate. If this occurs, the diagnostic trouble code (DTC) P2636 will set, the malfunction indicator lamp will illuminate, the fuel gauge will display empty, and the transfer pump will be disabled until serviced. If the vehicle continues to be driven, it will run out of fuel in the front tank and stall. Dealers are to replace fuel line connections to allow the rear tank, in addition to the front tank, to directly supply fuel to the engine. The engine control module (ECM) will also be reprogrammed with calibrations necessary to support this new connection.
PI1214A2018-06-25. Service bulletin. ENGINE AND ENGINE COOLING. The purpose of this document is to provide the Service Personnel with a guide to determine which Service Information documents and scan tool parameters to reference when encountering an: Exhaust Fluid Quality Poor Message Displayed, and a Reductant Fluid Quality Test Status that will Pass, Time Out, Fail or Interrupt and other DEF Messages that may be observed.
PIP5498H2018-06-18. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. This Preliminary information communicates A vehicle may have a concern of DTCP050D setting along with a P0300 after a cold start up. White smoke and/or coolant odor may come from exhaust for an extended period of time at cold start as well. Cause: Coolant getting into the cylinders, and provides direction for the repair.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.