WenmarOpen by Wenmar Pro

Service bulletins for the 2015 Cadillac CTS

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1797 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
19NA2192020-04-06. Service bulletin. ENGINE; EQUIPMENT. This diagnostic tip provides additional information on how to diagnose a possible valve, lifter or camshaft issue.
20NA0292020-03-30. Service bulletin. EQUIPMENT; ENGINE. This technical bulletin provides a Service Procedure to correct a Condition of Ticking, Tap or Rattle Noise from Engine.
18NA0732020-03-30. Service bulletin. EQUIPMENT; ENGINE. This Bulletin provides graphics, information and guidelines for engine component wear to assist service personnel as a guideline to perform necessary engine repairs and prevent unnecessary engine replacement.
15NA0102020-03-02. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL. This informational bulletin provides information to dealership personnel for new vehicles with less than 1,000 miles that may not pass California smog inspection or smog inspection in other states.
PIP5540F2020-02-10. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
PIP5531A2020-02-10. Service bulletin. ENGINE; POWER TRAIN:AUTOMATIC TRANSMISSION. This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015?0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that "mating" surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped
19NA2562019-12-16. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ENGINE. This technical bulletin provides a procedure to perform inspections to determine if the engine needs to be replaced as opposed to just internal parts for knocking, rattle, squeak and/or squeal type noises from engine.
010601011K2019-11-25. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides guidelines and diagnostic/repair information to technicians regarding vehicle engine oil consumption.
PIP5402E2019-11-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides the technician with the diagnosis and repair steps for a vehicle with a check engine light on with Diagnostic Trouble Code P015B or a reduced engine power message with Diagnostic Trouble Code P1101. Technician should look for a missing or damaged O-ring seal in the charge air cooler coupler.
PIP5540E2019-11-12. Service bulletin. ENGINE. This Preliminary information communicates to the technician the need to inspect the induction system for potential icing issues in very cold ambient temperatures. To allow the ice to melt so that it can be drained from the related components. That any of the listed DTC's may set with or without poor engine performance.
19NA2192019-10-28. Service bulletin. ENGINE AND ENGINE COOLING. This diagnostic tip provides additional information on how to diagnose a possible valve, lifter or camshaft issue.
PIP5528D2019-10-15. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates the repair recommendations for misfire in HFV6 re-manufactured engines.
090604026R2019-09-23. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
070601016F2019-09-23. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
000601026M2019-09-23. Service bulletin. ENGINE AND ENGINE COOLING. This informational bulletin provides information on replacing the intake manifold when the engine is replaced after severe internal engine damage.
PIP4158H2019-09-16. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY; ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that have low oil pressure, no oil pressure, and/or engine noise. Technician will need to replace the oil pump, flush the oil cooler lines.
PIC6123D2019-09-16. Service bulletin. ELECTRICAL SYSTEM; LANE DEPARTURE; ENGINE; FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL. This Preliminary Information communication provides information to the technician for the adaptive cruise control or lane keep assist unavailable message in the driver?s information center after the vehicle has been parked in direct sunlight and high ambient temperatures. The cameras electronic control unit?s internal operating temperature range is -40 degrees Celsius to 85 degrees Celsius. If the temperature of the electronic control unit of the camera module exceeds 85 degrees Celsius the image processor will no longer function resulting in adaptive cruise control and lane keep assist to be unavailable until the temperature falls to below the maximum operating temperature range
PIP5257C2019-08-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician on the steps to diagnose and repair vehicles that may have oil mixed in with the engine coolant. Technician will need to inspect the oil cooler if equipped for possible leaking into the cooling system through the radiator. If no issue found replace the engine as well as all rubber coolant hoses.
PIC6137F2019-08-12. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary Information communication provides information to the technician about vehicles that the engine stops running after extended idle with shifter in park. Dealer should communicate to the customer this condition is a normal operating characteristic of their vehicle. If the customer exits the vehicle with the fob in their possession while the engine is running and the shifter is left in park, the engine will shut off after 1 - 2.5 hours depending on model year. If the customer is sitting in the vehicle with the engine running and the fob is in the vehicle, the Passive Entry Passive Start system will reach out and look for the fob after 1 - 2.5 hours depending on model year. If the fob is located, the timer will reset an additional 1 - 2.5 hours depending on model year.
090604026Q2019-07-29. Service bulletin. ENGINE; EQUIPMENT. This informational bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
19NA1042019-07-29. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM:RADIATOR ASSEMBLY. This informational bulletin provides information for dealers/technicians and customers on steam/vapor coming from the front grille or radiator area.
PIP5528C2019-07-08. Service bulletin. ENGINE AND ENGINE COOLING. This Preliminary information communicates the identification process for High Feature V6 camshafts in re-manufactured engines.
18NA2462019-07-01. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV). This technical bulletin provides a procedure to change the oil if excessive fuel has been found in the oil and the cause of the DTC set. Also replacing the PCV valve in camshaft cover and updating the ECM with latest software.
16NA3832019-07-01. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. This informational bulletin advises of a new fuel injection kit used for decarbonizing the intake valves, and explains how toptier fuels should be used to reduce carbon build up.
PIP56402019-06-10. Service bulletin. ENGINE. This Preliminary Information communication provides information to the technician to not remove the torque converter bolts and start the engine as this may cause damage to the torque converter of the crankshaft on vehicles equipped with an automatic transmission.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.