Service bulletins for the 2013 Cadillac ATS
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
2400 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Electrical system are shown. Show all
| 13-00-89-008 | 2018-04-02. Service bulletin. ELECTRICAL SYSTEM:WIRING. This informational bulletin provides information for GM wiring repair. |
|---|---|
| PIP5529A | 2018-03-12. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. This Preliminary information communicates additional diagnosticsand repairto assist in resolving a malfunction indicator lampillumination due to any combination of diagnostic trouble codes P0068 P0101 P0106 P0171 P0131 P0137 P0324 P0326 P0331 P0506. |
| PIP5180B | 2018-03-12. Service bulletin. ELECTRICAL SYSTEM:STARTER ASSEMBLY. This Preliminary Information communication provides information to the technician about vehicles that have hard start, extended crank, or black smoke from the exhaust when starting. Technician will need to perform fuel quality test, spark test, and a compression test. Technician should also install a vacuum gauge prior to cold start and watch needle for signs of a sticking valve. |
| PIP4670E | 2018-03-12. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about a no start or another concern after swapping an Engine Control Module or other modules from one vehicle to another. The Global Architecture electrical system associated with these vehicles does not allow controller swaps between vehicles. |
| PIC5891E | 2018-02-21. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that the voice recognition is inoperative. Technician will need to toggle through all languages then back to the desired language. |
| PIT5468 | 2018-01-22. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This Preliminary Information communication provides information to the technician about a connectivity concern with Bluetooth after phone software is updated or after any vehicle updates for the radio or Human Machine Interface has taken place. Technician should delete all Bluetooth pairings and then reboot the Bluetooth device and the vehicle. After the vehicle and radio is booted back up repair the Bluetooth device. |
| PIC6102A | 2018-01-22. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that may have intermittent or no audio. Technician should inspect the amplifier for water damage. Technician should also inspect the wire harness that enters at the right wheelhouse in front of the amplifier. Ensure the grommet is properly installed as water may wick into the harness of the amplifier. Technician should also check for a water leak around the tail lamps, and make sure the sunroof drain tubes are fully connected and not damaged if equipped. |
| PIC6085A | 2018-01-22. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that are unable to access XM Weather. If the system responds by highlighting the XM Weather Icon but it does not enter the application technician should replace the Human Machine Interface module for this concern. |
| PIT5464 | 2018-01-22. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that the incoming caller ID may no longer be available or displayed after the Canada OnStar upgrade. Dealer should communicate to the customer that we apologize for this inconvenience and that General Motors is working on a solution for this concern. |
| PIP4112Q | 2018-01-22. Service bulletin. ELECTRICAL SYSTEM:STARTER ASSEMBLY. This Preliminary Information communication provides information to the technician of a complaint of a sag or hesitation when accelerating. The concern is present when coasting at low speeds of less than 15 miles per hour and then aggressively applying the throttle, or after making a hard stop followed by an aggressive throttle. This is considered normal operation of the vehicle the throttle is delayed and opened slowly up to .7 seconds to help minimize driveline lash and clunking or will have approximately .5 seconds of zero torque to allow the transmission to shift to first gear. |
| PIC4740F | 2018-01-22. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician for multiple concerns including service engine soon light, reduced power, no crank or start, multiple warning lights on, transmission shifts hard, or the door locks cycle while driving. The transmission control module or engine control module may not communicate with the scan tool. This could be caused by unseated pin or pins in the transmission connector. The technician should inspect the transmission connector X1 terminals by disconnecting it and carefully tugging on each wire to ensure the pins are fully seated. On the Cadillac ATS and CTS only the check the harness securing bracket on the passenger side of the vehicle were the transmission bell housing is attached to the engine block the harness should hang below the securing bracket. The harness should also be checked for chaffing. |
| PIC5650D | 2018-01-16. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, and/or B3935. Technician should not replace any parts for this concern. If unable to duplicate the concern ask if the customer uses any Radio Frequency Identification Devices when the concern is present. Dealer should also direct their customers to the appropriate section in the Owner manuals that references that the device complies. |
| PIC5491K | 2018-01-16. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have an OnStar system that will not power up. Technician should turn off the ignition and cancel retained accessory power. After the vehicle has powered down remove power to the OnStar module for five minutes. After the power has been removed for five minutes, if the OnStar system is working release the vehicle. If the OnStar system is still inoperative continue with published Service Information diagnostics. |
| PI0799A | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT:ELECTRICAL. This preliminary informational bulletin adds the 2014 - 2016 model years to cleaning information to correct a customer concern of seeing a white film/residue on the IP pad and/or door trim panels. |
| 15-NA-030 | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. This informational bulletin provides information to dealership personnel on the use of non-GM approved battery chargers and booster packs. |
| PIE0348 | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM. This engineering information bulletin is requesting information from dealers on a customer concern of loss of audio, chimes or turn signal click/clack with DTC U0180 or B1325 sym03 set. |
| 15-06-03-001A | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM. This informational bulletin provides information that may be useful in diagnosing/testing batteries that have set for a long period of time and/or set in cold weather climates to correct a customer concern of symptoms that include, but not limited to, a slow or no crank condition that may be caused by a discharged battery. |
| PI1126E | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. This preliminary information bulletin provides a procedure on reprograming the HMI module to repair the customers concern of the blank screen after start up, Rear view camera on, touch screen inop, bluetooth and navigation concerns. |
| 100089005D | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:WIRING. This warranty informational bulletin advised the technician that when performing a wiring repair, more information is required. |
| PI1103E | 2017-12-22. Service bulletin. SEATS; ELECTRICAL SYSTEM. This preliminary informational bulletin provides a procedure for the technician to test the power seats, the outside power mirriors, shorts in the wiring and the MSM, and reprogram the module if shorts weren't found, for the customers concern of the mirriors and/or seat inoperative. |
| 030846004M | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This informational bulletin provides information on part restriction and ordering process information for onstar vehicle communication interface modules. |
| 080846004A | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This informational bulletin provides information regarding the aftermarket device interference with onstar diagnostic service. |
| 17-NA-244 | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. This informational bulletin provides information on Information on How to Prevent Inadvertent Vehicle Starting from Key Fob or OnStar Mobile Application and where to locate the information for future use. |
| 11-08-49-001V | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. This technical bulletin provides information on Transport Mode On Message Displayed in Driver Information Center (DIC) and/or Battery Light is Flashing and the procedures to turn the transport mode message on and off. |
| PIP5209 | 2017-12-22. Service bulletin. ELECTRICAL SYSTEM. This Preliminary Information communication provides information to the technician about vehicles that have Diagnostic Trouble Code P00C6 and/or P228C set. Technician will need to inspect the terminals at the Engine Control Module for fit and tension as well as the crimp to wire connection. Terminals to inspect in the ECM are connector x2 terminals 3, 18, and 19 for the fuel rail pressure sensor. Also connector x3 terminals 16 and 32 for the high pressure fuel pump. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.