Service bulletins for the 2021 Bentley Bentayga
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
757 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
Only bulletins with component: Body and frame are shown. Show all
| 2061582/4 | 2021-08-06. Service bulletin. LATCHES/LOCKS/LINKAGES; STRUCTURE. Driver/Passenger door/s creak on close. Customer statement / workshop findings Driver or Passenger door creak during the Close function. Technical background VERY IMPORTANT: Refer to the vehicle repair history to check and confirm any previous work done regarding door latch replacement noting the following: -Upon first complaint of a door latch creaking - Replace all four door latches -For any complaints of the same symptom that occur after this - Only replace the door latch which is exhibiting the symptom -Figure 1 shows and example of the door latch |
|---|---|
| 2063726/1 | 2021-07-02. Service bulletin. STRUCTURE. Discolouration around the sunroof aperture. Customer statement / workshop findings: Discolouration around the sunroof aperture, Refer to the examples shown in Figure 1. Technical background: Discolouration may become visible around the sunroof aperture, this is mainly evident if vehicles are left for a reasonable period prior to the PDI being conducted. This is a known condition that was traced to the overspray of sunroof sealant primer during sunroof installation. |
| 2063240/1 | 2021-06-04. Service bulletin. STRUCTURE. Creaking noise from the rear seats (5 and 7 seat variants only). Customer statement / workshop findings: Noise/Creak from the rear seat/s at speeds up to 70 mph And/or Creaking from rear seat/s between 0-20 mph during gentle acceleration and braking Technical background: This TPI applies to all 5 and 7 seat variants This TPI does not apply to 4 seat variants Noises and creaks originating from the rear seat/s as a result of seat location pegs and mega bracket interference while driving at speeds up to 70 mph and gentle acceleration and braking between 0-20 mph should be resolved by following the instructions within the Measure section. |
| 2062622/1 | 2021-04-07. Service bulletin. EQUIPMENT; STRUCTURE. Water leak/wind noise diagnosis. Customer statement / workshop findings: Water leak/wind noise evident Technical background: The instructions within the Measure section should be followed to assist in the diagnosis of water leaks or wind noise |
| 2061582/2 | 2021-04-07. Service bulletin. LATCHES/LOCKS/LINKAGES; STRUCTURE:BODY:DOOR. Driver/Passenger door/s power latch creak on close. Customer statement / workshop findings: Driver or Passenger door creak during the power latch Close function Technical background: IMPORTANT: Refer to the vehicle repair history In the event that all four door latches have been replaced previously, only the individual/faulty latch should now be replaced (See example of door latch in Figure 1) |
| 2057988/4 | 2021-02-03. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. Bentayga Hybrid - Accessory Embargo. Customer statement / workshop findings Customer request to install fixed sill steps, deploying sill steps or Illuminated tread plates to Bentayga Hybrid vehicle. Technical background Due to the routing and proximity of high voltage cables it is strictly prohibited to install the following accessories on Bentayga Hybrid vehicles. -Fixed sill steps. -Deploying sill steps. -Illuminated tread plates NOTE: Tow bars cannot be fitted to Bentayga Hybrid vehicles due to certification IMPORTANT: Bentayga Styling Specification MUST NOT be fitted to Bentayga Hybrid vehicles from 19 to 20 Model year due to certification reasons However From 21 Model year onwards the Bentayga Styling specification can be fitted Note: Failure to observe these instructions may invalidate certain aspects of the vehicle warranty |
| 2061582/1 | 2021-01-08. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES. Driver/Passenger door/s power latch creak on close. Customer statement / workshop findings Driver or Passenger door creak during the power latch Close function Technical background IMPORTANT: Refer to the vehicle repair history. In the event that all four power latch drive units have been replaced previously, only the individual/faulty drive unit should now be replaced Measure Ensure the fault is as described within the Customer statement, refer to the video on the Bentley Hub referencing TPI 2052394/- |
| 2052394/10 | 2020-12-03. Service bulletin. STRUCTURE:BODY:DOOR; LATCHES/LOCKS/LINKAGES. New Continental GT - New Continental GTC and Bentayga Driver/Passenger door power latch creak on close. Customer statement / workshop findings: Driver or Passenger door creak during the power latch Close function. Technical background: Refer to the Measure section of this TPI |
| 2060895/1 | 2020-12-02. Service bulletin. STRUCTURE:BODY:DOOR; ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Rear tail lamp flashes - After opening an exterior door - With the vehicle unlocked. Technical background: Should the car go into bus silence with the car unlocked, on door opening, there is a <100ms flash of the rear lamps. Due to BCM2 supplying power to the rear lamp immediately, there is a delay in establishing communication, which causes the tailgate lamp to activate for <100ms. A software fix for this issue adds a 1 second delay upon power being supplied to the lamp |
| 2060581/1 | 2020-10-06. Service bulletin. STRUCTURE; LATCHES/LOCKS/LINKAGES; ELECTRICAL SYSTEM. Bentayga - Boot open/close function inoperative. Boot operational issues For example: The boot does not open/close as expected Technical background: NOTE: The operative MUST submit the following information to a new DISS or existing DISS query relating to boot operational issues: Completed check list Images of the vehicle condition - In particular the boot area (Ensure license plate and VIN details are not visible) Video of the failure NOTE: Please capture (when possible) the rear of the vehicle for at least one open/close operation before zooming in or moving closer to the issue, the video MUST be recorded in a quiet environment Battery health as Rep.Gr 27 - Print out of the results and attach to the DISS query NOTE: Please ensure any other findings or issues relating to the boot are clearly described within the DISS query Do No |
| 2054210/3 | 2020-08-07. Service bulletin. STRUCTURE:BODY:ROOF AND PILLARS; EQUIPMENT:MECHANICAL; EQUIPMENT. Noises from Panoramic sun roof. Customer statement / workshop findings: Noises from the Panoramic sun roof when driving. The noises occur mainly when the sun roof is closed. Technical background: Mechanical system of sun roof frame not or insufficiently lubricated. |
| 2054084/2 | 2020-08-06. Service bulletin. STRUCTURE. Bullseye air outlets - chrome finisher detached. Customer statement / workshop findings: Air vent chrome finisher has detached from vane. Technical background: It is possible that using aftermarket clip on devices such as mobile phone holders, air freshener holders or chewing gum dispensers may result in the chrome air vent finisher becoming detached from the vane. Measure: Please advise the Customer that the use of aftermarket clip on devices is not recommended and continued use may result in repeat failures. Damage caused by the use of aftermarket clip on devices will not be covered under vehicle warranty. |
| 2057841/2 | 2020-08-05. Service bulletin. STRUCTURE. Windscreen replacement criteria whilst under manufacturers warranty. Customer statement / workshop findings: Windscreen cracked/damaged Technical background: Please refer to the instructions within the Measure section of this TPI in the event that a windscreen is cracked/damaged |
| 2056582/3 | 2020-08-05. Service bulletin. STRUCTURE. Interior trim - Creak and rattle - Noise identification. Customer statement / workshop findings: Noise complaint from the interior Workshop findings: The noise can be reproduced and clearly assigned to the interior Prior to starting the instructions within this TPI, the Retailer must check and confirm the vehicle is in standard factory condition and has not had any non-approved aftermarket modifications conducted Should any aftermarket modifications be found, the Retailer must make Product Support aware by raising a DISS query to report the details of the modification, you must then await feedback from Product Support before conducting any further work |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.