WenmarOpen by Wenmar Pro

Service bulletins for the 2008 Audi TT

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

408 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

Only bulletins with component: Engine are shown. Show all

Bulletins, newest first
1339202478432022-08-01. Service bulletin. BACK OVER PREVENTION; ENGINE AND ENGINE COOLING. Deposits or coolant residues obstruct the electric transition on the sensor in the reservoir. This affects the coolant level display
1453203812922022-08-01. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
1450203812912022-08-01. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
A1722172060750_32022-04-05. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin contains instructions for using the UV additive to find engine oil leaks.
A1922282025303132022-02-04. Service bulletin. ENGINE AND ENGINE COOLING; EQUIPMENT. This bulletin contains instructions for identifying and mixing factory fill coolants.
A1922272025303122022-02-04. Service bulletin. ENGINE AND ENGINE COOLING:COOLING SYSTEM; EQUIPMENT. This bulletin contains instructions for identifying and mixing factory fill coolants.
A1021222018288_92021-06-03. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING. This technical service bulletin reminds the reader to check for metal debris when replacing an engine.
A1721122060750_22021-03-04. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin contains instructions for using the UV additive to find engine oil leaks.
A1720112060750_12020-11-05. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION; EQUIPMENT. This bulletin contains instructions for using the UV additive to find engine oil leaks.
A9020652032113_42020-09-03. Service bulletin. EQUIPMENT; ENGINE AND ENGINE COOLING:COOLING SYSTEM. This information bulletin contains a background on the outside air temperature reading.
A3720992060148_12020-08-06. Service bulletin. ENGINE AND ENGINE COOLING:ENGINE:OIL/LUBRICATION: OIL COOLER; POWER TRAIN:MANUAL TRANSMISSION:INTERNAL:GEARS. This informational bulletin states to not replace parts for the beveling groove as it is normal.
A1920042025303_12020-07-07. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin contains instructions for identifying and mixing factory fill coolants.
A1915612025303-52018-02-05. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 19 number 14-50 dated June 20, 2014. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
A171782 2010043-2018-02-05. Service bulletin. ENGINE. This informational bulletin contains all the the Audi Oil Quality Standards that should be used when doing an oil change.
A171453 2038129-2017-12-05. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 17 number 14-50 dated August 15, 2014. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
A011403 2033223-2017-12-05. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 01 number 13-29 dated September 16, 2013. The engine warning light is on after engine replacement. The engine is not running roughly. However, the engine control module, J623 (address word 01), is storing one or more engine misfire fault codes. The fault codes occur at light load, between 8% and 14% accelerator pedal position. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once.
A011370 2018260-2017-11-17. Service bulletin. ENGINE; ELECTRICAL SYSTEM:WIRING. Supersedes Technical Service Bulletin Group 97 number 10-06 dated June 4, 2010. MIL on. A number of incident memory entries with regard to the throttle valve are stored in the ECM. In most cases, the entries are sporadic. Contact resistance in the ECM wiring - throttle valve.
A011386 2033630-2017-11-17. Service bulletin. EQUIPMENT:ELECTRICAL; ENGINE. MIL on. Rough idle. DTCs are stored in the Engine Control Module (ECM), J623 (address word 01). Engine may have reduced performance without significant loss of power or stalling. Because there are a number of different misfire faults (unrelated to ignition coil operation) that could cause the MIL to illuminate, proper Guided Fault Finding (GFF) misfire diagnosis must be followed before any ignition coils are replaced.
A011373 2033223-2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING. The engine warning light is on after engine replacement. The engine is not running roughly. However, the engine control module, J623 (01), is storing one or more of the following engine misfire fault codes: DTCs P0300 - P0304. The fault codes occur at light load, between 8% and 14% accelerator pedal position. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once.
A171338 2012913-2017-11-17. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 17 number 10-07 dated June 3, 2010. Oil filter cartridge requires replacement.
A191335 2025303-2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 19 number 11-19 dated February 10, 2011. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
A191562 2025303-2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 19 number 15-61 dated July 7, 2015. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
A171565 2038129-2017-11-17. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 17 number 15-63 dated June 2, 2015. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual.
A191341 2025303-2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING. Supersedes Technical Service Bulletin Group 19 number 13-35 dated March 25, 2013. Discontinuation and mixing of Audi-approved engine coolants. G11, G12, and G12+ coolants have been replaced by an improved version. G12++ coolant (for service available) has been introduced in MY 2005 for all engines. G13 has been introduced in MY 2008 as factory filling and service.
A211315 2027585-2017-11-17. Service bulletin. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Supersedes Technical Service Bulletin Group 21 number 12-09 dated May 16, 2012. Rattling and/or jarring noises heard from the engine compartment/exhaust system between 1800 and 2900 rpm. Because of exhaust gas pulsations, the wastegate flap and rods vibrate at the start of the boost air control. This vibration causes rattling or jarring noises.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.