WenmarOpen by Wenmar Pro

Service bulletins for the 2013 Audi S8

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

809 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Bulletins, newest first
27 14 23 20363922022-05-31. Service bulletin. STRUCTURE; EQUIPMENT. Vibrations felt at 1000 rpm and 3000 rpm
27 14 22 20363922022-05-31. Service bulletin. ENGINE AND ENGINE COOLING. Vibrations felt at 1000 rpm and 3000 rpm
27 14 21 20363922022-05-31. Service bulletin. STRUCTURE; EQUIPMENT ADAPTIVE/MOBILITY. Vibrations felt at 1000 rpm and 3000 rpm
27 13 19 20290102022-05-31. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Low battery charge: excess current draw location
A9022582059335_32022-05-05. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL. This bulletin contains information on noises from the instrument cluster installation area.
A8722252010146172022-05-05. Service bulletin. VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM. This bulletin contains instructions for properly cleaning and removing a musty odor from the heating and ventilation system.
A4022382024318122022-05-05. Service bulletin. WHEELS. This bulletin describes the proper procedure to address a clicking or clacking noise from the wheel bearing
A9022572032113_62022-05-05. Service bulletin. EQUIPMENT:ELECTRICAL. This is an informational bulletin containing information about the outside temperature reading.
A4622302034181202022-05-05. Service bulletin. SERVICE BRAKES. This technical service bulletin provides troubleshooting for brake noise.
37 14 42 20290272022-05-02. Service bulletin. ELECTRICAL SYSTEM:IGNITION; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction.
37 14 30 20036582022-05-02. Service bulletin. ELECTRONIC STABILITY CONTROL (ESC):CONTROL MODULE:SOFTWARE; POWER TRAIN. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine electronic control system software. Customer states that the engine returns to idle speed of approximately 1,400 RPM although the accelerator is depressed, and/or the vehicle hesitates (lacks power on take-off).
37 14 29 20290272022-05-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE; ELECTRICAL SYSTEM; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. The DTCs are stored due to an issue with the transmission control module software.
37 13 78 20316752022-05-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). The entry P060A00 with DFCC 12480 can be logged in the TCM. This fault is only a diagnostic error. The fault will not affect vehicle performance.
37 13 17 20290272022-05-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). The DTCs are stored due to an issue with the transmission control module software. Specific DFCCs are stored as a result of the following situations: ? DTC P060A00 with DFCC 8692 can be logged when a driving mode (Drive or Reverse) is selected within one second of selecting Neutral, while the vehicle rolls at a speed less than 2 mph (such as when the vehicle is being maneuvered in or out of a parking spot). ? DTC P060A00 with DFCC 8694 can be logged when the gear is quickly changed from Park to Neutral, due to a low diagnosis threshold. ? DTC P060A00 with DFCC 12480 can be logged when the gear is changed using the Tiptronic function, due to a low diagnosis threshold.
37 13 07 20336582022-05-02. Service bulletin. SERVICE BRAKES. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who consciously or unconsciously drive with their left foot resting on the brake pedal are prone to experience this condition. With the introduction of Electronic Power Control (EPC) (no accelerator cable) to fuel injection systems, an engine RPM control feature has been incorporated into the engine electronic control system software. As a result, application of the brake and accelerator pedals at the same time (brake pedal with left foot and accelerator pedal with right foot) results in the following: ? Brake pedal function (normal at all times) overrides any throttle application. ? Diagnostic Trouble Codes (DTCs) will not be stored. ? When the brake pedal is applied while the accelerator is depressed, engine RPMs will return to idle speeds of 1400 RPMs after approximately two seconds. ? When the accelerator is applied while the brake pedal is depressed, the vehicle accelerates slower than usual (reduced engine torque).
37 13 02 20290272022-05-02. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. The DTCs are stored due to an issue with the transmission control module software. Specific DFCCs are stored as a result of the following situations: ? DTC P060A00 with DFCC 8692 can be logged when a driving mode (Drive or Reverse) is selected within one second of selecting Neutral, while the vehicle rolls at a speed less than 2 mph (such as when the vehicle is being maneuvered in or out of a parking spot). ? DTC P060A00 with DFCC 8694 can be logged when the gear is quickly changed from Park to Neutral, due to a low diagnosis threshold. ? DTC P060A00 with DFCC 12480 can be logged when the gear is changed using the Tiptronic function, due to a low diagnosis threshold.
37 13 01 20289852022-05-02. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). The fault occurs with ATF temperature below 60o C. Check for this temperature range in the extended environmental conditions of the diagnosis protocol. This TSB only applies if the ATF level is correct and there are no leaks.
27 14 23 20363922022-05-02. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. The basic settings of the active engine mounts in the subframe mount control module, J931, are deactivated when work is done on either of the vehicle electrical system control modules, J519 and/or J520 (for example, when a key is programmed). As a result, the vehicle vibrates or judders when cylinders are actively switched off.
27 14 22 20363922022-05-02. Service bulletin. STRUCTURE; ELECTRICAL SYSTEM. The basic settings of the active engine mounts in the subframe mount control module, J931, are deactivated when work is done on either of the vehicle electrical system control modules, J519 and/or J520 (for example, when a key is programmed). As a result, the vehicle vibrates or judders when cylinders are actively switched off.
27 14 21 20363922022-05-02. Service bulletin. ELECTRICAL SYSTEM; STRUCTURE. The basic settings of the active engine mounts in the subframe mount control module, J931, are deactivated when work is done on either of the vehicle electrical system control modules, J519 and/or J520 (for example, when a key is programmed). As a result, the vehicle vibrates or judders when cylinders are actively switched off.
DC_202203292022-04-05. Service bulletin. EQUIPMENT. Dealer Communication: Vehicle Sales Reporting, Reinstatement, and Audit Policy
A4022372024318112022-04-05. Service bulletin. SUSPENSION:FRONT:WHEEL BEARING. This bulletin describes the proper procedure to address a clicking or clacking noise from the wheel bearing
A1722192040644132022-04-05. Service bulletin. ENGINE AND ENGINE COOLING; ENGINE. This bulletin provides repair instructions on diagnosing and replacing a leak in the crankcase breather module.
A2122392044640_12022-04-05. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin contains repair instructions for when the engine cannot be started or it is difficult, there is unusual noises when accelerating and/or there is reduced engine performance.
A1722172060750_32022-04-05. Service bulletin. ENGINE AND ENGINE COOLING. This bulletin contains instructions for using the UV additive to find engine oil leaks.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.