Service bulletins for the 2013 Audi Q5
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1621 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
Only bulletins with component: Electrical system are shown. Show all
| A871342 2020124- | 2017-11-17. Service bulletin. EQUIPMENT:APPLIANCE:AIR CONDITIONER; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Supersedes Technical Service Bulletin Group 87 number 12-37 dated November 16, 2012. Air conditioning is inoperative. The HVAC blower functions normally. Battery discharged; however, when charged, there is no bus silence when vehicle ignition is off. The A/C pressure/temperature sensor, G395, leaks refrigerant. This causes sensor G395 to show an incorrect or implausible value when reading MVBs. An incorrect signal or a low refrigerant level in the system can cause the air conditioning compressor to deactivate. The LIN cable connecting the vehicle electrical system control module, J519, to sensor G395 is pinched or cut. This affects the A4/S4, A5/S5 Coupe and Cabriolet, and Audi Q5 vehicles. The A6 and A8 are not affected by this type of failure. The pressure sensor G395/G65 sends an incorrect signal that prevents bus silence and the battery is discharged. Sensor G395 is a LIN slave of the vehicle electrical system control module. The vehicle electrical system control module transfers the information provided by the sensor via the comfort data bus to the climate control module, J255. |
|---|---|
| A961364 2029384- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 96 number 12-32 dated April 27, 2012. The customer is able to program one or more of the Homelink buttons using their garage door remote, but after a few days or weeks, one or more of the programmed Homelink buttons no longer function. The LED on the Homelink button that is no longer functioning now flashes slowly, indicating that no programming is stored. The customer?s transmitter operates at 295Mhz. At the workshop, the Homelink system can be programmed to the workshop garage door successfully. No trouble is found. No DTCs are stored in any control units. The garage door opener control module, J530, was designed with an operational frequency range in which the 295Mhz frequency works correctly during the initial programming of the system. Over time, the transmitting frequency can drift out of range (especially in warmer climates), causing the system to lose its programming. |
| A961365 2033943- | 2017-11-17. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 96 number 13-60 dated May 23, 2013. Audi Lane Change Assistant (Side Assist) deactivates or is sporadically inoperative when the vehicle is driven in slow-moving, stop-and-go traffic or when it is driven for long periods of time on open roads that have no traffic. A warning message is seen in the instrument cluster driver information system stating ?Audi side assist unavailable: Sensors blocked?. The system is able to be activated approximately ten minutes after the traffic condition is removed, or after an ignition cycle. Audi Lane Change Assistant can be activated without issue. No obstructions can be found. DTCs are stored in the Lane Change Assistance control module. No damage is found to the rear bumper area, inside and outside (If any damage is found, it is not covered under warranty). The control unit mounting brackets are securely fastened to the lower rear bumper, and they are not lose or broken. If a loose bracket is found, repair as necessary using the ElsaWeb Repair Manual. Submit a separate warranty claim, as this TSB does not cover this repair. The software of the Lane Change Assistance control module can deactivate the Audi Side Assist system in certain normal driving conditions because the nature of these driving conditions make it difficult for the Audi Side Assist system to track vehicles. |
| A371273 2031775- | 2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); POWER TRAIN; ELECTRICAL SYSTEM. Customer may report transmission warning lamp illuminated in instrument cluster. DTC P074100 (Torque Converter Clutch Circuit Performance or Stuck Off) is stored in TCM. Diagnostic error in TCM software. |
| A461227 2031850- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; ENGINE. Engine and ignition shut off when driver? s door is opened. Electronic Parking Brake (EPB) activates when driver? s door is opened (A6/A7/S6/S7 only). |
| A941296 2027773- | 2017-11-08. Service bulletin. EXTERIOR LIGHTING:HEADLIGHTS; EQUIPMENT; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 94 number 12-69 dated March 15, 2012. Part or all of the daytime running lights do not work on vehicles with LED DRLs. For vehicles with halogen DRLs, please reference TSB 2017488, 94 Halogen Daytime running lights do not work. In the past, the daytime running light bulbs were a serviceable part. In this application, the LED strip cannot be replaced, and may have an associated control module. This TSB is for servicing information only. |
| A961245 2031095- | 2017-11-08. Service bulletin. ENGINE; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 96 number 12-43 dated October 12, 2012. Audi Side Assist deactivates itself immediately following the engine starting. The DTC entry "Control unit 2 for lane changing assistant - restricted function because of low voltage, sporadic" is logged in the control unit ? 3C ? Lane Change Assistant? . The control unit ? 3C ? Lane Change Assistant? checks voltage after each engine on cycle and during this check the voltage can be incorrectly reported which causes the DTC to set. |
| Dealer Letter - | 2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM; EQUIPMENT; STEERING; EXTERIOR LIGHTING:HEADLIGHTS. This document contains information on delivering the perfect audi vehicle and to pay special attention to completing any update technical bulletins that are active on the 2013 model year vehicles. |
| Update Bulletin | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM. This Update has been proactively released to adjust the vehicle departure deactivation and the electromechanical parking brake. Engine and ignition will no longer shut off when exiting the vehicle. If the engine is off (due to Start-Stop) when the door is opened, the ignition will shut off to prevent battery drain. The parking brake will not activate when the ignition is switched off. (A6/A7/S6 Only) This Update is in effect until removed. Procedure is valid only for vehicles that show the 97Y7 code in the ElsaWeb Campaign/Action Information screen on the day of repair. Vehicle must be in New Vehicle Inventory. Procedure must be performed within the allotted time frame stated in this Technical Service Bulletin. Procedure must be performed on applicable vehicles in dealer inventory prior to sale. Enhancements based on consumer feedback. |
| A011256 2031368- | 2017-11-08. Service bulletin. FUEL SYSTEM, GASOLINE; ELECTRICAL SYSTEM. MIL on. Engine misfire. Poor performance. Unnecessary High Pressure Fuel Pumps replacement due to Guided Fault Finding test plans not being performed or interrupted when the following DTC?s are present in the engine control module. |
| A461226 2031135- | 2017-11-08. Service bulletin. LANE DEPARTURE; PARKING BRAKE; ELECTRICAL SYSTEM. The customer may state the yellow warning for electric parking brake (EPB) appeared once in the instrument cluster, but the warning turned OFF after cycling the ignition and there have been no additional occurrences. The customer may state the adaptive cruise control (ACC) was inoperative once, but resumed operating properly after cycling the ignition and there have been no additional occurrences. DTC is stored in the EPB module. Internal code Param_InterFaultID 24 or 25 may be in the extended environmental conditions. The concern is due to a software glitch in the EPB control module. Concerns related to this software glitch can only occur once. Replacing the EPB module may cause an additional occurrence. |
| A911263 2021151- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT:APPLIANCE:AIR CONDITIONER. Supersedes Technical Service Bulletin Group 91 number 11 ? 83 dated April 15, 2011. The customer may report that the illumination of the dash insert, the air conditioning control panel or the inside light flickers when briefly pressing the accelerator in P or N or when shifting down while driving downhill. Only vehicles with PR number 8GH may be affected. When high electricity consumers are switched off and the battery is fully charged, the energy generated by the alternator is sometimes too great for the power system to absorb. This may lead to briefly increased voltage, and the lights mentioned above may briefly flicker. This characteristic is caused by the alternator design and is a normal condition of the vehicle. |
| A941295 2029782- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; EXTERIOR LIGHTING. Supersedes Technical Service Bulletin Group 94 number 12-78 dated June 4, 2012. A ? bulb out? warning is active in the instrument cluster?s Driver Information System (DIS) display and one or both of the rear side marker lights are burnt out. Moisture and debris can enter into the lower taillight housing causing one or more of the bulbs to burn out. |
| A371276 2029305- | 2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 37 number 12-74 dated November 28, 2012. Customer may report harsh downshifts while braking or harsh 1-2 upshift under acceleration. Further TCM software calibration to improve shift concerns. |
| A851210 2032226- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM; ENGINE AND ENGINE COOLING. Grinding noise coming from the HVAC blower motor. The plastic stop on the adapter of the fresh air blower motor is damaged in production. As a result, the blower moves within its housing. This allows the blower impeller to make contact with the blower motor housing. |
| A901238 2032113- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; EQUIPMENT. The customer may state that the outside ambient temperature display is incorrect. To achieve a smoothening effect of the displayed outside ambient temperature, the value shown does not instantaneously follow the temperature sensor measurement. The display will not change faster than 4° F (2° C) per minute. This concept applies to both falling and rising temperatures. A programming strategy is also implemented to avoid incorrect readings on a parked vehicle, due to the temperature sensor being affected by outside influences such as radiant heat from the engine bay, elevated road surface temperatures, etc. |
| A911270 2032240- | 2017-11-08. Service bulletin. EQUIPMENT; ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. The Google Earth map will not load. The display shows an active data connection, and ? Google? is almost fully white. Customer has active Audi Connect subscription. All other Audi Connect functions operate normally. The concern only occurs if the vehicle is started in a 2G cellular zone. The system operates normally if started in a 3G cellular zone. The vehicle has MMI software 0566 installed. Certain Audi Connect partner carriers are transmitting data that is not supported by the MMI. The data disrupts the loading process of Google Earth and causes it to not completely load. |
| A961246 2032225- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM; LANE DEPARTURE. The customer complains of the warning message in the Driver Information Center of ? Lane change assistant not available? and the button on the mirror does not stay lit. Audi Side Assist is inoperative. Along with the customer complaint, either one or all of the two following DTC? s must be present in the system. Diagnostic Address 19 ? Gateway Control Module (J533) - 02849 Lane Change Assistance Control Module ? J769- 004 No signal/communication - 001 Sporadic. Diagnostic Address 19 ? Gateway Control Module (J533) - 02001 Data Bus Distance control - 004 No signal/communication - 001 Sporadic. Diagnostic Address 3C ? Lane Change Assistance Control Module (J769) - 02071 Local data bus 014 Faulty ? 001 Sporadic. Incorrect component installed at the factory. |
| Dealer Letter - | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM. The purpose of this communication is to outline a recent improvement to the start-stop-system as well as new information and retail sales process suggestions to help you and your customers realize the benefits and convenient operation of this technology. |
| A571402 2022032- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 57 number 13-97 dated October 29, 2013. The customer inquires about the operation of the vehicle locking, and may suggest that the vehicle ?locked itself?. The lock command history is stored in the convenience system control module (J393). |
| A461484 2031135- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 46 number 13-57 dated August 16, 2013. The yellow warning for electromechanical parking brake (EPB) appeared once in the instrument cluster. The warning turned off after the ignition was cycled, and there have not been additional occurrences. EPB function was not affected. The adaptive cruise control (ACC) was inoperative once, but it resumed proper operation after the ignition was cycled, and there have not been additional occurrences. DTCs are logged in the EPB control module. |
| A011485 2036761- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 01 number 14-71 dated March 13, 2014. The MIL is on. DTC P164B(00) is stored in the engine control module.The oil pressure switch is defective. |
| A001466 2037949- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. A DTC with the description ?Invalid Data Record? is stored after an ECU has been replaced or updated. This DTC is normal. It indicates that the parameter data has not been properly programmed into the ECU by SVM. |
| A001465 2011732- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. Supersedes Technical Service Bulletin Group 00 number 12-32 dated February 7, 2012. This Technical Service Bulletin (TSB) details the general process for carrying out a Software Version Management (SVM) software update for any TSB or Update. |
| A371429 2029027- | 2017-11-08. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 37 number 13-17 dated September 11, 2013. Customer may report transmission warning light is illuminated. In some cases, the vehicle will not move after being started and placed into gear. After key cycle, the vehicle drives without restriction. DTCs are stored in the transmission control module (TCM). If DFCCs do not match exactly, this TSB does not apply. The DTCs are stored due to an issue with the transmission control module software. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.