WenmarOpen by Wenmar Pro

Service bulletins for the 2014 Audi A8

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

1325 on file from NHTSA, as of 2026-10-19.

By type

By component

By trouble code

By topic

Only bulletins with component: Transmission and driveline are shown. Show all

Bulletins, newest first
A301519 2019850-2018-02-05. Service bulletin. EQUIPMENT; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; POWER TRAIN. Supersedes Technical Service Bulletin Group 30 number 11-10 dated December 2, 2011. Clutch is not operating properly. Clutch has a burnt smell. Clutch pedal does not fully return to starting position. Incorrect shifting, the revolutions of clutch plate and engine input shaft differ too much, excessive slipping of the clutch, and when the clutch is pressed and an incorrect lower gear is selected, can result in clutch damage.
A301722 2019850-2018-02-05. Service bulletin. POWER TRAIN:CLUTCH ASSEMBLY. This technical service bulletin provides guidelines for diagnosing the clutch plate.
A371448 2030007-2017-12-05. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 37 number 12-65 dated September 25, 2012. Customer may report harsh shift concerns, but the customer is unable to determine the shift point because there is no gear indicator in the cluster. The concern can be reproduced. No faults are stored. TAC must be contacted before any repairs are attempted. Specific information about the concern must be gathered (as described in the Service portion of this bulletin) before TAC is contacted.
A371309 2028715-2017-12-05. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 37 number 12-40 dated February 28, 2012. Rough gear changes, both when accelerating and when slowing down. There is a rough driving power disruption that occurs sporadically and lasts for less than a second. After a mechatronics, torque converter, or complete gearbox replacement, the clutches must be adapted to the new component. This requires a gradual move of the clutch linings toward the optimal operating points in the most diverse load conditions. As a result, sporadic driving power disruptions lasting for less than a second or reduced shift comfort are possible over the first 500 miles. This is normal, and these issues will decrease over time. The issues can also occur if the adaptation values of the gearbox were deleted.
A661330 2030471-2017-11-17. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:TORQUE CONVERTER. Supersedes Technical Service Bulletin Group 66 number 12-24 dated August 24, 2012. Customer may report the license plate attachment screws do not install properly. The license plate brackets are designed to be used with the appropriate length screw installed by hand with a screwdriver. Damaged warranty parts have been returned to Audi of America with evidence of excessive torque used when installing the screw and/or excessive screw length.
A371437 2037137-2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Customer may report feeling a slight hesitation or delay at 5-9 mph after accelerating from a stop. Incorrect software calibration in the engine control module (ECM), J623, and transmission control module (TCM). New software in the ECM and TCM addressed the condition.
A371436 2037151-2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). DTC P174900 (Automatic transmission control module incorrect code) appears in the Transmission Control Module (TCM) after an SVM update. The self-coding function of the TCM may not complete during a software update.
A371430 2003658-2017-11-08. Service bulletin. POWER TRAIN:CLUTCH ASSEMBLY:PEDAL/HAND LEVER(MOTORCYCLE). Supersedes Technical Service Bulletin Group 37 number 13-07 dated May 29, 2013. Customer states that the engine returns to idle speed of approximately 1,400 RPM although the accelerator is depressed, and/or the vehicle hesitates (lacks power on take-off). No DTCs are stored. This condition may be caused when the brake pedal and the accelerator pedal are depressed simultaneously. Drivers who drive with their left foot resting on the brake pedal are prone to experience this condition.
A971442 2036764-2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 97 number 14-41 dated March 18, 2014. The MIL is on. Vehicle will not start. DTC P068A00 is stored in the engine control module (ECM), J623 (address word 01). Numerous unrelated DTCs are also stored in the system, including: P056200, P057100, P068700, P068A00, P162400, P190C00, U010000, U010100, U012100, U014600, U015500, U021200, U101100, U102600, U111100, U111300, U140000, VAG00003, VAG00185, VAG00263, VAG00317, VAG00384, VAG00446, VAG00456, VAG00457, VAG00466, VAG00473, VAG00532, VAG00565, VAG00591, VAG00714, VAG00819, VAG00955, VAG01217, VAG01299, VAG01314, VAG01315, VAG01317, VAG01320, VAG01330, VAG01331, VAG01332, VAG01334, VAG01333, VAG01336, VAG01705, VAG01964, VAG02067, VAG02072, VAG02095, VAG02103, VAG02203, VAG02214, VAG02635, VAG02812, VAG02874, VAG03041, VAG03157, VAG03166, VAG03220, VAG03278, and/or VAG03531. The motronic engine control module power supply relay, J271, is not functioning properly. Because the J271 relay controls battery voltage (Terminal 30) via a ground signal sent from the ECM, numerous faults can occur in multiple control modules when it is not functioning properly.
A011461 2035235-2017-11-08. Service bulletin. ENGINE; POWER TRAIN. Supersedes Technical Service Bulletin Group 01 number 13-36 dated October 9, 2013. The customer reports that the engine warning light illuminates sporadically. The engine may have reduced performance without significant loss of power or stalling. Noise is heard coming from the engine compartment, specifically from the High Pressure Fuel Pumps 2. DTCs are stored in the ECM.
A001458 2026692-2017-11-08. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION; ENGINE. Supersedes Technical Service Bulletin Group 00 number 12-43 dated December 21, 2012. If a 2012 - 2015 Audi A8 L W12 arrives at an Audi dealership and requires diagnosis or repair, a Repair Authorization must be obtained. Prior to any repair, a Technical Assistance Center (TAC) ticket must be created for engine and transmission concerns only. Routine maintenance and PDI do not require prior authorization or a Technical Assistance Center (TAC) ticket. These procedures are mandatory until further notice. Warranty repairs without repair authorization via a TAC contact will not be reimbursed.
A011328 2033224-2017-10-31. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION. Supersedes Technical Service Bulletin Group 01 number 13-10 dated June 24, 2013. If a model year 2014 Q5 TDI, A6 TDI, A7 TDI, or A8L TDI clean diesel (engine code CPNA or CPNB) requires diagnosis or repair of the engine, diesel fuel delivery, exhaust after-treatment (SCR/AdBlue and emissions) systems, or transmission, a Repair Authorization is necessary prior to repair. This also applies to any messages related to AdBlue shown in the DIS. These procedures are mandatory until further notice. Routine maintenance, PDI, and repair of other systems do not require prior authorization or a TAC ticket. Any repairs related to the engine, diesel fuel delivery, exhaust after-treatment (SCR/AdBlue or emissions) systems, or transmission completed without Repair Authorization via a Technical Assistance Center (TAC) contact will not be reimbursed. In an effort to gain information on the systems listed above, we are asking that you contact TAC before replacing any parts. This will assist us in diagnosing any potential issues.
Executive Servic2017-10-27. Service bulletin. STEERING:HYDRAULIC POWER ASSIST:POWER STEERING FLUID; SERVICE BRAKES, HYDRAULIC:FLUID; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; ENGINE; POWER TRAIN. This document contains a fluid capacity chart as well as a chart that contains the parts and part numbers needed for service.
A011526 2041120-2017-10-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). The MIL is on. DTC P042000 and/or P043000 (Catalyst system Bank 1/2, Efficiency below threshold) is stored in the engine control module (ECM), J623 (address word 01). The diagnostic limitations were too narrow.
A261525 2036070-2017-10-25. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 26 number 14-21 dated February 3, 2014. Various noises, such as humming, vibration, and/or rattling are heard coming from under the vehicle or from near the center console area. The noises may appear when the vehicle is driven at highway speeds, during hard acceleration when RPMs are high, during deceleration from 40 mph, or during acceleration from a stop.
A011508 2030580-2017-10-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ENGINE. Supersedes Technical Service Bulletin Group 01 number 15-06 dated January 16, 2015. The customer complains that the vehicle sporadically cannot be started. The yellow gearbox warning light may be illuminated. DTC P157000 and/or DTC P170100 present in the ECM and the transmission control module, respectively.
A271525 2036392-2017-10-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ENGINE. Supersedes Technical Service Bulletin Group 27 number 14-23 dated April 24, 2014. Vibrations are felt at 1000 rpm and 3000 rpm. DTCs may be stored in the subframe mount control module. Optimized J931 control module software.
A151526 2039995-2017-10-25. Service bulletin. ENGINE; POWER TRAIN. Rattling noises are heard from the timing chain drive for about 1-3 seconds after the first engine start of the day. The noises are caused by one of the upper chain tensioners. The noises do not lead to damage. Improved chain tensioner.
A391515 2028902-2017-10-21. Service bulletin. POWER TRAIN. Supersedes Technical Service Bulletin Group 39 number 14-14 dated May 5, 2014. A squealing, howling, or whistling noise may be heard coming from under the vehicle. The condition is typically noticed when the vehicle is cold (normally below freezing) and is moving at speeds of 5 - 60 mph. The noise is from the intermediate bearing of the propeller shaft.
A011521 2040508-2017-10-21. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM:SOFTWARE. The MIL is on. DTC P046100 is stored in the ECM. DTC P046100 can be caused by miscalculations within the ECM software.
A371668203000752017-03-10. Service bulletin. POWER TRAIN:MANUAL TRANSMISSION:COLUMN SHIFT ASSEMBLY. THIS BULLETIN PROVIDE INSTRUCTIONS FOR WHEN THERE ARE HARSH GEAR SHIFTS BUT THERE IS NO FAULTS STORED AND YOU CAN DUPLICATE THE CONCERN.

The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.