Service bulletins for the 2013 Audi A6
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
1666 on file from NHTSA, as of 2026-10-19.
By type
By component
By trouble code
By topic
| A011329 2033223- | 2017-10-31. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 01 number 13-73 dated March 7, 2013. The engine warning light is on after engine replacement. The engine is not running roughly. However, the engine control module, J623 (01), is storing one or more of the following engine misfire fault codes: DTCs P0300 - P0304. The fault codes occur at light load, between 8% and 14% accelerator pedal position. The programmed values for the misfiring recognition are not automatically reset by deleting the memory once. |
|---|---|
| A631305 2035502- | 2017-10-31. Service bulletin. STRUCTURE:BODY:BUMPERS. This bulletin is informational only for repairs made to the rear bumper. Under the rear bumper cover, two shields are fitted below the Lane Change Assistance control units. The shields are in place to prevent unwanted reflections from special aftermarket accessories fitted on this vehicle. These reflections can interfere with the function of the Lane Change Assistance system. The shields are in place to prevent unwanted reflections from special aftermarket accessories fitted on this vehicle. These reflections can interfere with the function of the Lane Change Assistance system. |
| A571397 2022032- | 2017-10-31. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 57 number 13-92 dated August 1, 2013. The customer inquires about the operation of the vehicle locking, and may suggest that the vehicle ?locked itself?. The lock command history is stored in the convenience system control module (J393). |
| A371318 2034863- | 2017-10-31. Service bulletin. STEERING:GEAR BOX (OTHER THAN RACK AND PINION). Supersedes Technical Service Bulletin Group 37 number 13-10 dated July 31, 2013. Customer may report that the gearbox warning message is on. DTC P0706 (driving mode sensor, implausible signal) is stored in the transmission control module (TCM), J217 (address 02). There is a reaction between the TCM and the automatic transmission fluid (ATF) in vehicles within a specific VIN range. |
| A271319 2029010- | 2017-10-31. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Supersedes Technical Service Bulletin Group 27 number 12-13 dated March 22, 2012. The customer may report a discharged battery when trying to start the vehicle. The condition results in a no start. |
| A271318 2023282- | 2017-10-31. Service bulletin. ELECTRICAL SYSTEM:12V/24V/48V BATTERY. Supersedes Technical Service Bulletin Group 27 number 12-10 dated February 13, 2012. Battery testing and charging for vehicles equipped with a Battery Data Manager (BDM - J367). When the InCharge 940 is used as a battery charger in auto mode, it performs a battery condition test and may prematurely fail the battery if the charging takes place at the jumper posts in the engine compartment. This is due to the added resistance in the system between the battery and jumper posts. When the InCharge 940 is used as a battery charger in manual mode, the battery condition test is not performed. |
| A201327 2035073- | 2017-10-31. Service bulletin. ENGINE. MIL on. DTC P045600 (EVAP System Leak Detected NVLD (very small leak)) is stored in the engine control module (ECM), J623 (address word 01). Drivability is not affected. |
| A171344 2035463- | 2017-10-31. Service bulletin. ENGINE AND ENGINE COOLING. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine, and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner?s Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, and the ambient temperature and road conditions. Additional factors include the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. Utilizing the advanced sensor technology integrated in models equipped with the 3.0 TFSI engine, it is possible to measure oil consumption electronically via a Guided Function test plan. If the electronic oil consumption test is not available for this model, perform the test with the conventional scale/oil weighing method. See TSB 2018550 for instructions for the conventional scale/oil weighing method. |
| A011334 2033919- | 2017-10-31. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 01 number 13-26 dated August 29, 2013. MIL on. DTCs are stored in the engine control module. There may be slight power reduction at high RPMs. One of the vacuum actuators on intake runner bank 1 or bank 2 is defective. It is possible that the membrane on the vacuum actuator may tear. As a result, the intake manifold flaps do not function. |
| Executive Servic | 2017-10-27. Service bulletin. SERVICE BRAKES, HYDRAULIC:FLUID; ENGINE AND ENGINE COOLING; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; STEERING:HYDRAULIC POWER ASSIST:POWER STEERING FLUID. This document contains a fluid capacity chart as well as a chart that contains the parts and part numbers needed for service. |
| A971550 2034863- | 2017-10-27. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). Supersedes Technical Service Bulletin Group 37 number 13-18 dated October 16, 2013. Customer may report that the gearbox warning message is on. DTC P0706 (driving mode sensor, implausible signal) is stored in the transmission control module (TCM), J217 (address 02). There is a reaction between the TCM and the automatic transmission fluid (ATF) in vehicles within a specific VIN range. |
| A911598 2018187- | 2017-10-27. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 91 number 14-50 dated July 10, 2014. Customer may report that cracking, grinding, rattling, humming, whining, or similar interference is coming from one or more speakers. Parts of the speakers (such as the brackets, cables, or covers) or parts of the interior fittings (such as door covers, rear shelf, facings, or covers) can vibrate at certain frequencies, causing noises. The radio tuner or other control modules may be affected by electromagnetic interference from aftermarket electronic devices. |
| A911595 2040926- | 2017-10-27. Service bulletin. ELECTRICAL SYSTEM:SOFTWARE. The navigation map update database 8R0051884CJ cannot be activated using Software Version Management. |
| A911590 2040406- | 2017-10-27. Service bulletin. ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 91 number 15-87 dated May 18, 2015. When the vehicle is started, the GPS location or vehicle direction indicated on the MMI navigation map does not match the vehicle?s actual location or direction of travel for a long period of time (often as long as 10 minutes). The issue occurs in open sky, with no large buildings obstructing the sky view. The issue is intermittent, but it can occur for long periods of time during a single day. The issue typically happens on very warm days when the HVAC system blower is at a medium to high setting (auto or manual), with air being directed out of the panel vents. When the issue occurs, the GPS navigation system satellite reception shows 0 satellites. Due to the infrequency of the issue, this might not be verifiable. (To view the number of satellites being received, go to Nav >> Route >> Select Current Position (first item in list) and scroll up. No DTCs related to the GPS antenna or MMI system are present. The vehicle is an A4 (including S4 and allroad variants), A5 (including Cabriolet, S5, and RS 5 variants), A6 (including S6 variant), A7 (including S7/RS 7 variants), A8 (including long wheelbase, S8, or W12 variants) or Q5 (including SQ5 and hybrid variants). Q7 and Q3 vehicles are not affected by this condition. The failure can happen at start-up or while the vehicle is being driven. The issue typically starts when the vehicle is driven on curvy or circular roads, driven in circles (such as when driven around a parking lot), or driven on or off an expressway. |
| A911500 2039515- | 2017-10-27. Service bulletin. EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Supersedes Technical Service Bulletin Group 91 number 15-85 dated May 15, 2015. The customer complains that the Audi connect Online service in their 2012-2013 A6 or A7 vehicle only reaches 2G service when in metropolitan areas. This bulletin applies only to model year 2012-2013 A6 and A7 vehicles. For other vehicles, see TSB 2039476. |
| A901555 2030193- | 2017-10-27. Service bulletin. BACK OVER PREVENTION: CAMERA SYSTEM. Supersedes Technical Service Bulletin Group 90 number 12-31 dated July 16, 2012. Customer states all or part of the picture generated from the top view camera system has an unnatural hue. To achieve a natural-looking top view camera image, the camera system constantly adjusts the displayed colors based on environmental conditions. In certain lighting conditions, the system responds to vibrant nearby colors (from the vehicle or other objects) by automatically adding a complementary color to rebalance toward white, which can lead to color deviations. For example, a red object can cause the system to add a green hue. The strength of the added color depends on the brightness of the object and the ambient light. |
| A871564 2010146- | 2017-10-27. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. Supersedes Technical Service Bulletin Group 87 number 15-63 dated May 18, 2015. There is an unpleasant, musty odor coming from the heating and ventilation system. The odor usually occurs when the vehicle has been sitting unused for five hours or more. The odor usually occurs within 20 to 60 seconds after the vehicle is started. Condensation, which is a normal condition in all A/C systems, can cause a musty odor. |
| A661554 2025323- | 2017-10-27. Service bulletin. VISIBILITY. Supersedes Technical Service Bulletin Group 66 number 12-20 dated April 9, 2012. A loud noise is heard when the outside mirrors are folded in or out. The noise originates in the metal spring inside the hinge area of the mirror housing. This spring is used for stabilizing the mirror when the vehicle is driven over rough roads to minimize mirror glass shake. When the mirror housing is folded in or out, the spring must turn or twist with the movement of the housing. The bottom and the top of the spring sit on a plastic base and due to increased friction at these contact points, the spring will skip along the plastic base during the folding operation and creates the noise. The normal functionality of the mirror is not affected. |
| A461515 2033674- | 2017-10-27. Service bulletin. SERVICE BRAKES. Supersedes Technical Service Bulletin Group 46 number 14-75 dated March 12, 2014. Customer may complain about brake squeak or squeal with light to moderate pedal pressure. |
| A171563 2038129- | 2017-10-27. Service bulletin. ENGINE. Supersedes Technical Service Bulletin Group 17 number 14-53 dated November 7, 2014. A check with the engine oil service dipstick T40178 is necessary, but the adjustment values for the dipstick are not available in the Elsa repair manual. Because of a system change, the adjustment values for the service dipstick T40178 were removed from the repair manual. |
| A011526 2041120- | 2017-10-25. Service bulletin. POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM). The MIL is on. DTC P042000 and/or P043000 (Catalyst system Bank 1/2, Efficiency below threshold) is stored in the engine control module (ECM), J623 (address word 01). The diagnostic limitations were too narrow. |
| A911594 2036576- | 2017-10-25. Service bulletin. EQUIPMENT:ELECTRICAL. Supersedes Technical Service Bulletin Group 91 number 14-28 dated March 6, 2014. MMI freezes or crashes and restarts when telephone address book is searched. This condition occurs because special characters (including symbols, emoticons, or map icons) are stored in the name field of a phonebook contact. |
| A011524 2040491- | 2017-10-25. Service bulletin. ENGINE AND ENGINE COOLING. The MIL is on. "Coolant System: Fault Turn Off Engine" and the coolant symbol appears in the information panel. DTC P1B1C00 is stored in the ECM. |
| A941560 2017806- | 2017-10-25. Service bulletin. EXTERIOR LIGHTING; ELECTRICAL SYSTEM. Supersedes Technical Service Bulletin Group 94 number 14-32 dated January 23, 2014. The light bulb warning light is displayed in the instrument cluster with the following message: "Vehicle lights: malfunction". DTCs are stored in the vehicle electrical system control module. Exterior lights are functioning properly. |
| A661546 2030471- | 2017-10-25. Service bulletin. EQUIPMENT ADAPTIVE/MOBILITY. Supersedes Technical Service Bulletin Group 66 number 13-30 dated June 4, 2013. Customer may report that the license plate attachment screws do not install properly. License plate mounting bracket threaded inserts stripped. |
The summaries are NHTSA's. Each bulletin's page links NHTSA's copy of the manufacturer's document.