Service bulletin 1801701A
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 628330 |
| Published by NHTSA | 2002-03-07 |
| Manufacturer's number | 1801701A |
| Manufacturer's date | 2001-12-07 |
| Replaces | 1801701 |
| NHTSA component | ENGINE AND ENGINE COOLING:ENGINE:GASOLINE |
NHTSA's summary
SOME VEHICLES MAY EXHIBIT ENGINE IDLE UNDERSHOOT/PERFORMANCE. *TT
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine
| DODGE NEON | 2000, 2001 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 68332810 | 2022-10-17. Service bulletin. Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.]. |
|---|---|
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 0900301 | 2001-10-05. Service bulletin. THIS BULLETIN REINFORCES A REQUIREMENT TO CEASE THE CURRENT PRACTICE OF USING SUPPLEMENTAL OIL ADDITIVE TREATMENTS IN ALL DAIMLERCHRYSLER ENGINES. *TT |
| 1801701 | 2001-09-04. Service bulletin. ON SOME VEHICLES, THE ENGINE MAY UNDERSHOOT THE NORMAL IDLE SPEED WHEN BRAKING THE VEHICLE TO A STOP WITH THE CLUTCH DEPRESS AND / OR EXHIBIT ENGINE ROUGHNESS IMMEDIATELY AFTER MANUALLY SWITCHING THE A/C SYSTEM OFF. *TT |
| 1802000 | 2001-05-03. Service bulletin. SOME VEHICLES MAY EXHIBIT A COLD START TIP IN HESITATION WHEN ACCELERATING FROM A STOP IN AMBIENT TEMPERATURES BETWEEN 10 DEGREES C AND 27 DEGREES C (50 DEGREES C AND 80 DEGREES F). *TT |
| 1801900 | 2001-05-03. Service bulletin. SOME VEHICLES MAY EXHIBIT HIGH ALTITUDE ENGINE HESITATION FROM A STANDING START, HIGH LOAD BUMP / SURGE, ENGINE BUCK BOBBLE OR BOUNCE AND SHAKE, LIGHT LOAD SURGE AND / OR HEAVY LOAD SURGE. *TT |
| 181600 | 2000-12-01. Service bulletin. SOME VEHICLES MAY EXHIBIT POOR A/C OR ENGINE PERFORMANCE. *TT |
| 0043 | 2000-11-30. Service bulletin. DUE TO A DELAMINATION PROBLEM, THE ACCESSORY DRIVE BELT FOR THE POWER STEERING PUMP AND A/C COMPRESSOR MAY REQUIRE REPLACEMENT. *TT |
| 8331/8332 | 2000-10-03. Service bulletin. EMISIONS RECALL 8331/8332 REGARDING EXCESS HYDROCARBONS. *TT |
| 090600 | 2000-05-09. Service bulletin. SUBJECT PERTAINS TO CHANGES TO THE TIMING BELT TENSIONER COMPONENTS. *TT |