Service bulletin 181899
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 607620 |
| Published by NHTSA | 1999-09-30 |
| Manufacturer's number | 181899 |
| Manufacturer's date | 1999-08-13 |
| NHTSA component | ENGINE AND ENGINE COOLING:ENGINE:GASOLINE |
NHTSA's summary
CONDITIONS WITH ENGINE ROUGHNESS / MISFIRE USUALLY ONLY APPARENT ON INITIAL COLD ENGINE START. *TT
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine
| DODGE NEON | 1997, 1998, 1999 |
|---|---|
| PLYMOUTH NEON | 1997, 1998, 1999 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 68332810 | 2022-10-17. Service bulletin. Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.]. |
|---|---|
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 0900800 | 2001-04-12. Service bulletin. THIS BULLETIN INVOLVES INSTALLATION OF A NEW COMPONENT TO ASSIST CAM SEAL RETENTION. *JB |
| 090600 | 2000-05-09. Service bulletin. SUBJECT PERTAINS TO CHANGES TO THE TIMING BELT TENSIONER COMPONENTS. *TT |
| 180100 | 2000-04-12. Service bulletin. SUBJECT REGARDING MISDIAGNOSED LEAK DETECTION PUMP SYSTEMS WITH DIAGNOSTIC TROUBLE CODES P1494, P0442 P0455, OR P0456. *TT |
| 182497 | 2000-01-11. Service bulletin. INFORMATION ON NO START DIAGNOSTIC CAM/CRANK SENSOR $01 AND $28. *NLM |
| 181797 | 2000-01-11. Service bulletin. INFORMATION ON LEAK DETECTION PUMP (LDP) DEALER TEST MODE. *NLM |
| 090997 | 2000-01-10. Service bulletin. INFORMATION ON GASKET SURFACE PREPARATION ON ALUMINUM ENGINE COMPONENTS. *NLM |
| 070797 | 2000-01-07. Service bulletin. CONCERNS WITH VEHICLE OVERHEATS (RADIATOR FAN INOPERATIVE) OR RADIATOR FAN RUNS CONTINUOUSLY. *NLM |
| 070397 | 2000-01-07. Service bulletin. CONCERNS WITH ENGINE COOLANT USAGE. *NLM |