Service bulletin 9907
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 604816 |
| Published by NHTSA | 1999-05-14 |
| Manufacturer's number | 9907 |
| Manufacturer's date | 1999-02-25 |
| NHTSA component | ENGINE AND ENGINE COOLING:EXHAUST SYSTEM |
NHTSA's summary
SERVICE ACTION SUPPLEMENT A REGARDING FEDERAL EXHAUST SYSTEM INSTALLED ON VEHICLES EQUIPPED WITH CALIFORNIA EMISSION. *TT
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine, Exhaust and emissions
| DODGE DAKOTA | 1999 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 68332810 | 2022-10-17. Service bulletin. Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.]. |
|---|---|
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 1100605 | 2006-01-27. Service bulletin. ILLUMINATED MIL AS THE RESULT OF A DIAGNOSTIC TROUBLE CODE (DTC) P0420 - CATALYST EFFICIENCY, OR MAY HAVE FAILED A CALIFORNIA SMOG OR STATE I/M TEST BUT WITHOUT AN ILLUMINATED MIL, OR A RATTLING SOUND FROM THE UNDERSIDE OF THE VEHICLE. CATALYTIC CONVERTER EXTENDED WARRANTY TO REPLACE THE CATALYTIC CONVERTER. *TT |
| 1800402 | 2002-03-27. Service bulletin. SUBJECT REGARDING 1999 MY ENGINE SPARK KNOCK. *TT |
| 2500401 | 2001-07-11. Service bulletin. SUBJECT REGARDING ADDITIONAL DIAGNOSTIC FOR DIAGNOSTIC TROUBLE CODES CAUSED BY AN EVAPORATIVE SYSTEM LEAK. *TT |
| 180600C | 2001-03-08. Service bulletin. SOME VEHICLE ENGINES MAY EXHIBIT A LIGHT TO MODERATE SPARK KNOCK CONDITION DURING ACCELERATION (UNDER LOAD). *TT |
| 180600A | 2000-12-01. Service bulletin. SOME VEHICLE ENGINES MAY EXHIBIT A LIGHT-TO-MODERATE SPARK KNOCK CONDITION DURING ACCELERATION (UNDER LOAD). *TT |
| 180600B | 2000-12-01. Service bulletin. SOME VEHICLE ENGINES MAY EXHIBIT A LIGHT-TO-MODERATE SPARK KNOCK CONDITION DURING ACCELERATION (UNDER LOAD). *TT |
| 082400 | 2000-11-29. Service bulletin. ON SOME VEHICLES THE ENGINE CRANKS BUT DOES NOT START OR STARTS AND STALLS. *TT |
| 180600 | 2000-09-29. Service bulletin. SUBJECT REGARDING 1999 MODEL YEAR ENGINE SPARK KNOCK. *TT |