Service bulletin 110198
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 600476 |
| Published by NHTSA | 1998-05-18 |
| Manufacturer's number | 110198 |
| Manufacturer's date | 1998-01-30 |
| NHTSA component | ENGINE AND ENGINE COOLING:EXHAUST SYSTEM |
NHTSA's summary
EXHAUST DRONE AND/OR VIBRATION FELT AT 1600-2000 RPM UNDER A LOAD. *AK
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine, Exhaust and emissions
| CHRYSLER CONCORDE | 1998 |
|---|---|
| CHRYSLER LHS | 1998 |
| DODGE INTREPID | 1998 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 68332810 | 2022-10-17. Service bulletin. Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.]. |
|---|---|
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 2500102A | 2004-04-21. Service bulletin. MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATION, DIAGNOSTIC TROUBLE CODE (DTC) P0442, P0455, OR P0456 - LEAK DETECTION PUMP (LDP), LEAK DETECTED. THIS BULLETIN SUPERSEDES 25-001-02 DATED FEB 11, 2002. *TT |
| 0900204 | 2004-03-04. Service bulletin. SHORT DURATION COLD ENGINE START-UP TICKING LIKE SOUND. THIS BULLETIN APPLIES TO VEHICLES BUILT PRIOR TO MARCH 31, 2003. *MN |
| 0900503 | 2004-02-20. Service bulletin. SHORT DURATION COLD ENGINE START-UP TICKING LIKE SOUND. *TT |
| 0900203 | 2003-08-20. Service bulletin. ENGINE STUMBLE AND/OR MISFIRE - MALFUNCTION INDICATOR LAMP ILLUMINATION. *TT |
| 1802302 | 2002-10-30. Service bulletin. CONCERNS WITH MALFUNCTION INDICATOR LAMP ILLUMINATION WITH A CATALYST EFFICIENCY FAILURE DIAGNOSTIC TROUBLE CODE (DTC P0420) RECORDED IN THE POWER TRAIN CONTROL MODULE (PCM). *TT |
| 0700202 | 2002-03-27. Service bulletin. SUBJECT REGARDING LOW OR NO CABIN HEAD, ENGINE COOLING SYSTEM SYSTEM FILL PROCEDURE. *TT |
| 01015 | 2001-09-04. Service bulletin. ADVANCE SERVICE INFORMATION REGARDING A NO-START CONDITION WHICH MAY EXIST FOLLOWING A HOT SOAK. *TT |
| 070200 | 2000-09-29. Service bulletin. SOME VEHICLES MAY EXHIBIT ENGINE OVERHEATING AND / OR COOLANT BOTTLE FAILURES AFTER SERVICE HAS BEEN PERFORMED ON THE ENGINE COOLING SYSTEM. *TT |