Service bulletin 180498
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 600343 |
| Published by NHTSA | 1998-05-11 |
| Manufacturer's number | 180498 |
| Manufacturer's date | 1998-02-13 |
| NHTSA component | ENGINE AND ENGINE COOLING:ENGINE; FUEL SYSTEM, GASOLINE |
NHTSA's summary
SUBJECT ON ERRONEOUS MIL ILLUMINATION WITH HEX CODE $76, I/M FAILURE AND DRIVEABILITY IMPROVEMENTS. *YC
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine, Fuel system
| CHRYSLER SEBRING | 1998 |
|---|---|
| DODGE AVENGER | 1998 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 1998090 | 1998-05-05. Engine |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 68332810 | 2022-10-17. Service bulletin. Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar® Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 N·m [21 ft. lbs.]. |
|---|---|
| R2118796A | 2021-05-03. Service bulletin. Valve Body. These may cause over drive cycling. |
| 1802001 | 2001-10-26. Service bulletin. EXHIBITING ROUGH IDLE, HARD START AND START & STALL.*CLS |
| 182699 | 2000-04-12. Service bulletin. SOME VEHICLES MAY EXPERIENCE NOX EMISSION FAILURE WHEN PERFORMING AN ASM TYPE INSPECTION / MAINTENANCE (I/M) EMISSION TEST. *TT |
| 180100 | 2000-04-12. Service bulletin. SUBJECT REGARDING MISDIAGNOSED LEAK DETECTION PUMP SYSTEMS WITH DIAGNOSTIC TROUBLE CODES P1494, P0442 P0455, OR P0456. *TT |
| 140897 | 2000-01-11. Service bulletin. INFORMATION ON POOR DRIVABILITY WITH HIGH DI (DRIVABILITY INDEX) FUEL. *NLM |
| 090997 | 2000-01-10. Service bulletin. INFORMATION ON GASKET SURFACE PREPARATION ON ALUMINUM ENGINE COMPONENTS. *NLM |
| 090798 | 1999-11-17. Service bulletin. SUBJECT REGARDING OIL SEEPAGE AT CAM POSITION SENSOR / MISINTERPRETED HEAD GASKET LEAK. *YC |
| 083298 | 1999-11-15. Service bulletin. NEW VEHICLE PREP PROCEDURES - COMPASS CALIBRATION / HVAC OPERATION. *YC |
| 9841 | 1999-11-15. Service bulletin. SOME VEHICLES MAY EXHIBIT A WHINE OR MOAN NOISE COMING FROAM THE FUEL TANK AREA. *YC |