WenmarOpen by Wenmar Pro

Warranty extension 26-01-064G TSB

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeWarranty extension
NHTSA id11036094
Published by NHTSA2026-08-11
Manufacturer's number26-01-064G TSB
Manufacturer's date2026-07-30
Campaign id or software versionLA18
NHTSA componentENGINE

NHTSA's summary

Certain 2026MY G70 (IK) and 2027MY G80 (RG3) vehicles may exhibit a water-flowing or gurgling noise from the front center air vents during engine start-up. This condition may be caused by trapped air within the engine cooling system. Follow the procedure below to properly bleed the cooling system and remove any trapped air.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine

Vehicles listed
GENESIS G802027
GENESIS GV702026

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
26-01-064G DCS2026-08-11. Warranty extension. Certain 2026MY G70 (IK) and 2027MY G80 (RG3) vehicles may exhibit a water-flowing or gurgling noise from the front center air vents during engine start-up. This condition may becaused by trapped air within the engine cooling system. Technical Service Bulletin (TSB) 26-01-064G provides instructions to properly bleed the cooling system and remove any trapped air.
26-HA-002G TSB2026-06-16. Service bulletin. Some Genesis vehicles (listed below) equipped with Lambda-III 3.5T-GDI engines may exhibit reduced heater performance due to engine coolant deposits clogging the heater core. This bulletin provides instructions to verify the concern and to replace the front and rear heater core (if applicable).
26-EM-008G TSB2026-03-11. Service bulletin. Some GV70 (JK1A) vehicles equipped with 2.5T engines may display a check engine light with DTC P04F000 (EVAP System High Load Purge Line 'A' Performance) due to debris inside the dual purge ejector assembly and/or intercooler outlet hose. This bulletin provides instructions to perform a DTC check, and if necessary, replace the dual purge ejector assembly and intercooler outlet hose.