Service bulletin LI91.10-P-080033

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

NHTSA's summary

Complaint The seat cushion upholstery is visible when the seat cushion fore/aft adjustment (SKTV) is completely extended. Cause The stretch part of the seat cushion cover does not completely cover the padding. Remedy An adaptation must be made to the seat bolster in the form of a cutout. To do this, please proceed as follows: • Extend the seat cushion fore/aft adjustment (SKTV) 2 times • Trim the foam to reduce its height by 5 mm. Remove material along the front section up to the start of the profile (approximately 85 mm), then gradually taper the cut toward the rear. • Extend SKTV 5 more times and check whether visibility is still ensured • If necessary, lightly rework again Note: If too much of the foam part is removed, there is a risk that the stretch will become too wavy when retracted. Do not treat the stretch material in the seat cushion fore/aft adjustment area of the seat cushion cover with steam or hot air.

The document

• NHTSA's copy of the document (PDF)
• If that address does not open, try this one

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Seats

Listing a model year does not mean every vehicle of it is concerned: the document says which.

• Bulletins for another vehicle
• Report an error on this page
• Report an error by email