Service bulletin LI27.60-P-078599

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

NHTSA's summary

Complaint A harsh 5-4 downshift can be felt during deceleration while braking or coasting. It may be mistaken for a hard brake engagement Cause In certain driving scenarios, the transmission torque adaptation for the 5-4 downshift is recorded at a higher value. This skews the learning which leads to harsh engagement of the B06 clutches, creating the harsh 5-4 downshift Remedy "Phase 1" software was released 11/14/2024 to slow the adaptation process and reduce the frequency of the complaint. However, it was possible that the client’s driving style could cause suboptimal adaptations, and this would result in the concern returning sooner than anticipated for some vehicles. "Phase 2" software has been released as of 09/04/2025 and will correct the root cause of the poor adaptation learning. See software list below. (format: Hardware - Old SW >> New SW) A0009011705 - A0019021614 >> A0019021721 A0009011705 - A0019021914 >> A0019021821 A0009011705 - A0019021714 >> A0019021921 A0009011705 - A0019022014 >> A0019022021 A0009011705 - A0019021814 >> A0019022121 Please follow IPR recommended procedures. IPR has been trained to recognize this pattern and will advise the necessary steps below. ***ALL STEPS MUST BE PERFORMED TO REMEDY THE CONCERN*** As of 03/06/2025 ALL warranty claims must include a print out of the IPR screen showing a check mark next to each required step as an indication that all steps have been completed in order to be approved and paid. See attached example of needed IPR screenshot 1. Perform resetting of learned values "deceleration mode" (VGS > Special Procedures > Special procedure > Resetting learned values Deceleration mode) 2. Perform 5 standstill adaptions in a row followed by 5 torque converter adaptations 3. Perform software update for the VGS Control Unit 4. Clear all faults 5. Perform final QC test drive & confirm normal operation of all shifts If issues arise during the process or the concern has returned with phase 2 software, please submit a TIPS case to the Powertrain inbox with the following information: - Initial Quick Test w/ freeze frame data - VGS Control Unit Log - Initial EEPROM data (before any procedures) - Current EEPROM data (after LI/IPR procedures) - Relevant screenshots (standstill adaptations, software update, etc)

The document

• NHTSA's copy of the document (PDF)
• If that address does not open, try this one

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline

Listing a model year does not mean every vehicle of it is concerned: the document says which.

• Bulletins for another vehicle
• Report an error on this page
• Report an error by email