WenmarOpen by Wenmar Pro

Other B064325

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeOther
NHTSA id11022869
Published by NHTSA2025-09-06
Manufacturer's numberB064325
Manufacturer's date2025-08-19
NHTSA componentENGINE

NHTSA's summary

Oil Line Return

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine

Vehicles listed
BMW 330I2025
BMW 430I2025
BMW 530I2025
BMW X12025
BMW X22025
BMW X32025
BMW X42025
BMW X62025
BMW Z4 M40I2025

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20263312026-07-08. Engine

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
B1103262026-08-26. Service bulletin. This Service Bulletin provides instructions to clean the intake valves using the BMW Carbon Blaster Tool P/N 81 29 2 208 034 and the S68T / XB1T Kit P/N 83 30 5 BAD 3D5. Refer to SI B04 12 11 for existing documentation about the carbon blaster tool and SI B04 02 26 for the S68T /XB1T tool kit.
B0103242026-08-03. Warranty extension. The EVAP systems purge (vent) valve limited warranty for defects in materials and / or workmanship has been extended to 15 years / 150,000 miles as determined from the original first in-service / delivery date.
B0639262026-08-03. Other. Starter Generator Return
B1203262026-07-31. Emissions. Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.
B1103262026-07-31. Service bulletin. This Service Bulletin provides instructions to clean the intake valves using the BMW Carbon Blaster Tool
B120626DCS2026-06-02. Other. Update - Variable Valve Timing
B1206262026-06-01. Service campaign. DELIVERY STOP: VARIABLE VALVE TIMING
InVeh-InApp-Comm2026-03-30. Over-the-air update. It was determined that the oil return line for the turbo charger was installed with a bolt of the wrong size. The bolt for the oil return line needs to be replaced.
InVeh-InApp-Comm2026-03-30. Over-the-air update. It was determined that due to a manufacturing defect, there may be a peeling of the sliding layer of the main bearing shells. The peeling may cause engine damage to your vehicle in some cases. The main bearing shells will need to be replaced.
B1203262026-03-30. Emissions. PROGRAM CONTROL UNITS (OBD)