# Service bulletin S2508000051

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 11019594
- Published by NHTSA: 2025\-06\-17
- Manufacturer's number: S2508000051
- Manufacturer's date: 2025\-06\-12
- NHTSA component: WHEELS
- Manufacturer's system: Wheel End Disconnect

## NHTSA's summary

Malfunction Indicator Lamp \(MIL\) on, Wheel End Disconnect \(WED\) Diagnostic Trouble Codes \(DTCs\)

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2025/MC-11019594-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2025/MC-11019594-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Wheels

## Vehicles listed

- 2024 to 2025 DODGE CHARGER EV
- 2024 to 2025 JEEP WAGONEER S

## Other bulletins for the same vehicles and component

- [02\-007\-26](/bulletins/11036350.md), 2026-08-26, Service bulletin: SUSPENSION; WHEELS. Front Wheel Bearing Click Noise Issue Customers may comment on the following: SYMPTOM: ● Single or multiple clicking noises from the front wheels during static or very low speed steering maneuvers \(left or right\). NOTE: The noise may also occur when driving slow over speed bumps, traversing uneven road surfaces, or entering or exiting an inclined area or driveway. This bulletin involves removing and retorquing the front hub to knuckle fasteners.
- [19\-005\-25 REV. A](/bulletins/11025018.md), 2025-11-05, Service bulletin: WHEELS. Vehicle Pulls Right Customers may comment on the following: ● The vehicle pulls to one side during straight driving. This bulletin involves checking if the front end alignment is set to nominal specs and possibly adjusting the front toe and front camber/cross camber to achieve nominal specification and also possilbly updating the Electronic Power Steering \(EPS\) software.
- [S2522000003](/bulletins/11024311.md), 2025-10-15, Service bulletin: WHEELS. Tire Pressure Monitor \(TPM\) Warning Lamp On Or Flashing. Sensor\(s\) Not Reading And Or Showing Dashes.
- [S2522000001](/bulletins/11022183.md), 2025-08-27, Service bulletin: WHEELS. TPMS Handling \& Installation Best Practices
- [08\-261\-25 REV. A](/bulletins/11022167.md), 2025-08-27, Service bulletin: WHEELS; ELECTRICAL SYSTEM. Front Wheel Disconnect Inoperative Customers may experience the following: ● Switching from 2WD to AWD inoperable. ● Wheel hub harness connector wires will have damage This bulletin involves replacing both front hub wire harnesses.
- [19\-004\-25](/bulletins/11018866.md), 2025-06-02, Service bulletin: STEERING; WHEELS. "Rear Toe Out Of Specification Customers may comment on the following: ● The vehicle wobbles when driving 80\-96 kph \(50\-60 mph\). This bulletin involves performing a rear toe adjustment and wheel alignment."
- [08\-026\-25 REV. A](/bulletins/11014365.md), 2025-02-19, Service bulletin: ELECTRICAL SYSTEM; WHEELS; UNKNOWN OR OTHER. "Customers may experience a Malfunction Indicator Lamp \(MIL\) illumination and the vehicle mayexhibit/set one or more of the following Diagnostic Trouble Codes \(DTCs\):● C10F8\-00 \- Left Front Wheel Hub Disconnect Actuator Position Sensor Circuit Range/Performance.● C10F9\-00 \- Right Front Wheel Hub Disconnect Actuator Position Sensor Circuit Range/Performance.● P061B\-00 \- Internal Control Module Torque Calculation Performance.Customers may also comment on one or more of the following:● Wrench icon is illuminated on the Instrument Panel Cluster \(IPC\).● Turtle icon is illuminated on the IPC.● Vehicle enters into limp home mode. This bulletin involves reprogramming the BPCM, MCP A, MCP B and the EVCU with the latest available software and then, if needed, performing a Wheel End Disconnect Position Learn routine"

JSON: [/v1/bulletins/11019594](/v1/bulletins/11019594)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20S2508000051&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F11019594&vehicle=Service%20bulletin%20S2508000051)