Service bulletin SSM 53860
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 11018778 |
| Published by NHTSA | 2025-06-02 |
| Manufacturer's number | SSM 53860 |
| Manufacturer's date | 2025-05-30 |
| NHTSA component | VEHICLE SPEED CONTROL |
NHTSA's summary
Some 2025 Bronco vehicles may exhibit an illuminated anti-lock brake system (ABS) warning indicator with diagnostic trouble code (DTC) U3012:68 stored in the ABS module. The vehicle may also exhibit any of the following symptoms: a soft brake pedal following vehicle start-up, various brake system illuminated warning lamps and/or brake-related messages displayed in the instrument panel cluster (IPC).
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Throttle and cruise control
Trouble codes named
U3012
| FORD BRONCO | 2025 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| SSM 54772 | 2026-04-28. Service bulletin. Some 2025-2026 Bronco vehicles may exhibit various cruise control, pre-collision and/or front stabilizer bar disconnect related warning messages displayed in the instrument panel cluster (IPC) with diagnostic trouble code (DTC) U0418:86 stored in the image processing module A (IPMA) and no wheel speed sensor specific DTCs present in the anti-lock brake (ABS) module. DTC U0415:00 may also be stored in the CHCM. If a vehicle exhibits this condition, carefully inspect the rear wheel speed sensors for correct installation with the rear wheel speed sensor body seated flush against the axle housing. Repair or replace the affected rear wheel speed sensor as needed, clear the DTC, and retest. Refer to Workshop Manual (WSM), Section 206-09. If the condition persists, advise the customer that Engineering is working on a software robustness solution that is expected to be available Q2 2026. <br /><br /> This condition does not affect vehicle durability, and additional diagnosis or service is not recommended at this time. Replacement or reprogramming of the IPMA and/or ABS modules will not resolve this condition. |
|---|---|
| SSM 54673 | 2026-04-06. Service bulletin. Some 2025-2026 Bronco Badlands and Raptor only vehicles may exhibit a "Cruise Control Not Available" or "Active Cruise Control Not Available" message displayed in the instrument panel cluster (IPC) with diagnostic trouble code (DTC) U0418:86 stored in the image processing module A (IPMA) and no DTCs present in the anti-lock brake (ABS) module. |