Service bulletin LI67.30-P-076917

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

NHTSA's summary

Complaint Rear side window reversed when opening/closing soft top - Convenience closing Cause 1. Rear side window setting 2. Damage to inner rear side window sealing rail (abrasion marks at sealing rail, see picture, folding of the sealing lip, see picture 2) 3. Body-in-white side wall shaft width too low. To this end, check the shaft width of the side wall for dimensional accuracy; see picture 3 Note: Inner and outer sealing rail are removed 4. Window divider at rear side window, metal insert sticks out, see picture 5 Remedy • SCN coding N22/6 (CRCM238) If SCN coding does not remedy the issue, consider the following points 1. Adjust the rear side window according to the specifications in the WIS. Note: Rear side window/center setting to shaft center of body-in-white side wall 2. Check inner sealing rail for damage. Replace in the event of damage 3. Enlarge shaft width of side wall of body-in-white; see picture 4. Information: Measuring point 1 at 0 cm: Nominal dimension 37.7 mm Measuring point 2 at 22 cm: Nominal dimension 31.0 mm Measuring point 3 at 34 cm: Nominal dimension 33.5 mm 4. Replace rear side window

The document

• NHTSA's copy of the document (PDF)
• If that address does not open, try this one

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Glass, wipers and mirrors, Wipers and washers

Listing a model year does not mean every vehicle of it is concerned: the document says which.

• Bulletins for another vehicle
• Report an error on this page
• Report an error by email