# Service bulletin S2418000007

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 11001000
- Published by NHTSA: 2024\-06\-05
- Manufacturer's number: S2418000007
- Manufacturer's date: 2024\-05\-18
- NHTSA component: ENGINE
- Manufacturer's system: Engine Control Module: O2 Sensor

## NHTSA's summary

MIL/Cel On

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2024/MC-11001000-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2024/MC-11001000-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Engine

## Vehicles listed

- 2024 ALFA ROMEO STELVIO
- 2024 DODGE HORNET

## Other bulletins for the same vehicles and component

- [S2609000010](/bulletins/11034921.md), 2026-07-08, Service bulletin: ENGINE. Mis\-Machined Engine Block
- [9100852](/bulletins/11034918.md), 2026-07-08, Service bulletin: ENGINE. When long block is received, inspection needs to be performed per SOL S2609000010 before the repair begins. If the block machining is not complete according to information in SOL, a new long block will need to be ordered.
- [112639](/bulletins/11034912.md), 2026-07-08, Service bulletin: ENGINE. THROTTLE BODY – NONE
- [112640](/bulletins/11034911.md), 2026-07-08, Service bulletin: ENGINE. THROTTLE BODY – NONE
- [112842](/bulletins/11034335.md), 2026-07-02, Service bulletin: ENGINE. BOLT \- HEX FLANGE HEAD
- [01\-001\-26](/bulletins/11032849.md), 2026-05-20, Service bulletin: ENGINE. Oil Change Monitor Displaying Prematurely Customers may experience the following: ● The oil change light illuminated on the dash shortly after taking delivery of the vehicle within 6,437 Km \(4,000 miles\) This bulletin involves resetting the oil life monitor and if necessary changing the engine oil and filter.
- [S2607000003](/bulletins/11028893.md), 2026-02-19, Service bulletin: ENGINE. GMET4 DOHC Water Pump Coolant Leak Inspection
- [9100723](/bulletins/11025520.md), 2025-11-13, Service bulletin: ENGINE. 1.Identify Customer Concern Check for small traces of coolant near the water pump, especially around the weeper chamber. Confirm if coolant is visibly dripping from the weeper chamber. 2.Root Cause identification The weeper chamber is designed to collect small amounts of coolant \(\< 3 ml/h\) that pass through the dynamic seal. Red traces or shadows around the chamber may appear during initial operation due to seal adaptation or vapor condensation. These traces are not necessarily signs of a leak. Continuous dripping of coolant, however, indicates a malfunction. 3.Service Repair Procedure Lift the vehicle using an elevator. Verify if coolant is actively dripping from the weeper chamber. Run the engine at idle, alternating speed between 2000 4000 rpm for 15 minutes. Observe the weeper chamber during this test: If coolant continues to drip: Replace the water pump \(possible permanent damage to the dynamic seal\). If dripping stops: No further action is needed; the vehicle can be returned to the customer. 4.Clarify Leak Sources Do not confuse leaks from: The Press\-In\-Place rubber gasket \(between water pump and engine block\), or The inlet pipe nipples with leaks from the weeper chamber.
- [9100325 Rev 1](/bulletins/11024035.md), 2025-10-08, Service bulletin: ENGINE. Before replacing any parts please refer to SOL S2518000008 if it applies to the vehicle you are working on based on a VIN search in Service Library. Before replacing this part due to Engine Light On with P1CEA \(Boost Side EVAP Purge System Performance\), check for: 1\) Improperly connected or kinked/pinched Purge Hoses at the Ejector Tees on the Air Box or Duct. 2\) Improperly connected or kinked/pinched Purge Hose at the Purge Solenoid or OBD Valve. 3\) Improperly connected or kinked/pinched Purge Hose at the Intake. 4\) Check for the correct Purge Hoses installation.
- [09\-013\-25 REV. B](/bulletins/11019431.md), 2025-06-10, Service bulletin: ENGINE. "Oil Leakage From The Timing Cover Customers may experience the following: ● Oil leaking from the timing cover. Once the claimed fault is confirmed, check the severity of the leak and replace the timing cover sealant, if necessary, according to the Repair Procedure."

JSON: [/v1/bulletins/11001000](/v1/bulletins/11001000)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20S2418000007&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F11001000&vehicle=Service%20bulletin%20S2418000007)