WenmarOpen by Wenmar Pro

Service bulletin 2310423

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10247471
Published by NHTSA2023-12-18
Manufacturer's number2310423
Manufacturer's date2023-10-07
NHTSA componentVEHICLE SPEED CONTROL

NHTSA's summary

Front Side Window Contour Seal Deformation One or both front door side window seals are deformed Fig. 1. This bulletin involves replacing the window seal and glass.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Throttle and cruise control

Vehicles listed
JEEP RENEGADE2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
23017232024-01-02. Service bulletin. Lack of assembly of door trims The customer may describe the door moldings are missing. This bulletin involves installing missing door molding.
23017232023-04-17. Service bulletin. Lack of assembly of door trims The customer may describe the door moldings are missing. This bulletin involves installing missing door molding.
23035142023-02-21. Service bulletin. Driver Door Lock Cylinder
23020152023-01-09. Service bulletin. Replace Missing Manual Release Cover For The Electric Fuel Door This bulletin involves installing a cover for the fuel door manual release cable. The customer may describe a loose cable hanging in the right rear of the cargo compartment area.
08021162022-10-31. Service bulletin. Flash: BCM Diagnostic And System Improvements This bulletin involves reprogramming the Body Control Module (BCM) with the latest available software. The customer may describe one or more of the following: · **Rear interior overhead lamps remain illuminated after exiting vehicle and locking from the driver's or passenger's door lock buttons. This is causing the vehicle battery to go dead.** · The door locks are inoperative when locking/unlocking remotely. · False activation of the vehicle security alarm. · False exterior light failure messages being displayed in the instrument cluster.
06106092A2022-09-26. Service bulletin. Seat Relay For a Jeep Renegade or Fiat 500X ONLY, if the driver's power seat will not move in any axis and the key is in the on position with the door open: 1. Please take a Vehicle Scan Report, taking note of any active or stored DTC's, especially in the Body Control Module (BCM). 2. Before replacing the relay, call Rick Gordon at cell (248) 630-6281. If no answer leave a message and if after 15 minutes, there is no return call, proceed with the repair. 3. In the event there is no call-back, please email the Vehicle Scan Report to rick.gordon@fcagroup.com
90034132022-09-15. Service bulletin. Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
23-035-142022-08-22. Service bulletin. Driver Door Lock Cylinder This bulletin involves replacing the driver door lock cylinder housing. The plastic cover of the driver door lock cylinder may be loose or fall off.
23-002-21 REV. A2022-07-18. Service bulletin. Incorrect or Missing Hood Decal This bulletin involves inspecting and if necessary replacing the hood decal. Some of the PHEV vehicle hood decals may be missing or has the incorrect decal been installed.
23-002-212022-07-18. Service bulletin. Incorrect or Missing Hood Decal This bulletin involves inspecting and if necessary replacing the hood decal. Some of the PHEV vehicle hood decals may be missing or has the incorrect decal been installed.