Service bulletin SSM 51788
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10239479 |
| Published by NHTSA | 2023-07-20 |
| Manufacturer's number | SSM 51788 |
| Manufacturer's date | 2023-07-14 |
| NHTSA component | STRUCTURE:BODY:DOOR; ELECTRICAL SYSTEM:SOFTWARE |
NHTSA's summary
Some 2020-2023 Aviator vehicles built on or before 12-Oct-2022 may exhibit a door ajar or door fault warning message present in the message center with diagnostic trouble codes (DTCs) B1175:19, B1176:19, B11C0:19 and/or B11C1:19 present in door latch control module E (DCME), door latch control module F (DCMF), door latch control module G (DCMG) and/or door latch control module H (DCMH). This may be due to low battery voltage and DTC thresholds being too low and not a fault in the door latch assembly. To correct the condition, reprogram and re-configure the the affected module using the latest level of the Ford Diagnosis and Repair System (FDRS). For claiming use causal part 54264A27 and applicable labor times found in Section 10 of the Service Labor Time Standards (SLTS) Manual.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Body and frame, Electrical system, Software
Trouble codes named
B1175, B1176, B11C0, B11C1
| LINCOLN AVIATOR | 2022, 2023 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 23B49 S1 | 2023-12-05. Service bulletin. Certain 2021 - 2023 Model Year Aviator Vehicles Equipped With SYNC - Reprogram Accessory Protocol Interface Module |
|---|---|
| TSB 23-2307 | 2023-11-02. Service bulletin. Some 2019-2020 Edge/F-150/Fusion/Continental/MKZ/Nautilus, 2019-2021 Mustang/Ranger/Transit Connect, 2020-2021 EcoSport/Escape/Expedition/Explorer/F-Super Duty/Aviator/Corsair/Navigator, 2021 Bronco Sport and 2020-2022 Explorer/Aviator vehicles with SYNC 3 may experience various SYNC performance related concerns. This may be due to the SYNC Software. To correct the condition, follow the Service Procedure to update the SYNC module (APIM) software. |
| TSB 22-2078 | 2022-03-08. Service bulletin. Some 20202022 Escape/Aviator plug-in hybrid electric vehicle (PHEV) and 20212022 Corsair PHEV vehicles may exhibit a FordPass or LincolnWay App message notification indicating deep sleep mode and connectivity is temporarily unavailable while the vehicle is plugged in during high voltage battery charging. The vehicle may also exhibit an inoperative remote start feature and/or lock and unlock functionality. This may be due to the software in the telematics control unit (TCU). To correct this condition, follow the Service Procedure to reprogram the TCU. |
| SSM 50388 | 2022-02-04. Service bulletin. Some 2020-2022 F-Super Duty/Explorer/Aviator and 2021-2022 F-150 vehicles may exhibit a Front Camera Fault, Lane Keeping Fault, and/or Collison Warning Not Available message with various diagnostic trouble codes (DTC) stored in the image processing module A (IPMA). If programming fails or Ford Diagnosis and Repair System (FDRS) states a file failed to flash after replacing the IPMA or reprogramming IPMA software, test the battery using any approved Rotunda tool including the GR-190, GRX-3590, and DCA-8000. Fully recharge or replace the battery according to results of the tool. Set the battery charger to maintain battery voltage between 12.6 and 13.6 volts during the entire programming procedure. The IPMA programming procedure may take several hours to complete due to the size of the software files required. |