# Service bulletin S2023000042

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10224035
- Published by NHTSA: 2022\-10\-17
- Manufacturer's number: S2023000042
- Manufacturer's date: 2020\-11\-13
- NHTSA component: BACK OVER PREVENTION

## NHTSA's summary

Wind Noise From Upper Corners Of Sliding Doors

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2020/MC-10224035-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2020/MC-10224035-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Driver assistance, Backup camera

## Vehicles listed

- 2017 to 2020 CHRYSLER PACIFICA

## Recalls for the same vehicles and component

- [26V327000](/recalls/nhtsa/26V327000.md), 2026-05-21: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA
- [20V191000](/recalls/nhtsa/20V191000.md), 2020-09-10: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA
- [19V886000](/recalls/nhtsa/19V886000.md), 2019-12-12: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.

## Other bulletins for the same vehicles and component

- [S2208000045 REV.B](/bulletins/11011774.md), 2024-12-11, Service bulletin: BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING. Backup Camera Poor Image Quality Inspection
- [9004452](/bulletins/10248516.md), 2024-01-08, Service bulletin: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
- [1802123](/bulletins/10248033.md), 2024-01-02, Service bulletin: ELECTRICAL SYSTEM; EXTERIOR LIGHTING; BACK OVER PREVENTION; POWER TRAIN. Flash: Powertrain Control Module \(PCM\) Updates Customers may experience a Malfunction Indicator Lamp \(MIL\) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes \(DTCs\) have been set: Major monitor \(misfire\) and other diagnostics are disabled on a pending DTCs P0335 and P0339. ? \*\*P0335 \- Crankshaft Position Sensor Circuit \(NA Only\). ? P0339 \- Crankshaft Position Sensor Intermittent \(NA Only\).\*\* ? P06E4 \- Control Module Wake\-Up Circuit Performance. Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module \(EBBM\). ? AntiLock Brake System Module \(ABS\). ? Hybrid Control Processor \(HCP\) and Auxiliary Hybrid Control Processor \(AHCP\) or also known as a Power Inverter Module \(PIM\).
- [0804523](/bulletins/10248014.md), 2024-01-02, Service bulletin: BACK OVER PREVENTION:SOFTWARE. Radio Over The Air Updating to 34.42 Software Version ? Mobile Wi\-Fi inoperative upon start up. ? Hotspot gives 9No Internet9 connection message on phone when trying to connect to a device. This bulletin provides information regarding the latest Firmware Over The Air \(FOTA\) update and provides the service technician an overview of the steps a customer will need to take to complete the update. The radio software will be updated from 34.4 to 34.42.
- [S1408000384](/bulletins/10247948.md), 2024-01-02, Service bulletin: BACK OVER PREVENTION; LANE DEPARTURE. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor \(IBS\) State of Charge \(SOC\) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes \(DTCs\), or Battery Warning Lamp On
- [9003357](/bulletins/10247905.md), 2024-01-02, Service bulletin: BACK OVER PREVENTION. ADAPTER, Engine Oil Filter \(Pentastar V6\) For all 2014MY replace the Oil Filter Adapter \(OFA\). For any other MY \(with mileage above 30,000\) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1\) Remove OFA 2\) Replace only the oil inlet O\-ring and gaskets \(seals kit in SOL above\). 3\) Re\-install the OFA. For 2023MY and beyond use black O\-ring. For 2022MY and prior use red O\-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
- [9004452](/bulletins/10244355.md), 2023-10-30, Service bulletin: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
- [S1808000152](/bulletins/10243131.md), 2023-10-02, Service bulletin: VEHICLE SPEED CONTROL:ACCELERATOR PEDAL; BACK OVER PREVENTION. CEL \(Check Engine Lamp\) Illuminated, P057B Brake Pedal Position Sensor Performance
- [9100133](/bulletins/10239854.md), 2023-07-31, Service bulletin: BACK OVER PREVENTION. ROCKER ARM ASSY \- ROLLER ROCKER Case 1.\- Before replacing the intake or exhaust rocker arms due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head \(no need to replace rocker arms\). The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes \(DTC\)s present. Case 2.\- If the INTAKE camshaft or INTAKE rocker arm has excessive wear on the high lift profile \(Rocker arm: slider, Camshaft: central lobe\), replace the intake camshaft \(1\) in that cylinder head and all intake rocker arms \(6\).
- [1802023](/bulletins/10234505.md), 2023-04-17, Service bulletin: BACK OVER PREVENTION; EXTERIOR LIGHTING; ELECTRICAL SYSTEM; POWER TRAIN. Flash: Powertrain Control Module \(PCM\) Updates Customers may experience a Malfunction Indicator Lamp \(MIL\) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes \(DTCs\) have been set: ? P0335 \- Crankshaft Position Sensor Circuit \(NA Only\). ? P0339 \- Crankshaft Position Sensor Intermittent \(NA Only\). Major monitor \(misfire\) and other diagnostics are disabled on a pending DTCs P0335 and P0339.\*\* Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module \(EBBM\). ? AntiLock Brake System Module \(ABS\). ? Hybrid Control Processor \(HCP\) and Auxiliary Hybrid Control Processor \(AHCP\) or also known as a Power Inverter Module \(PIM\).

JSON: [/v1/bulletins/10224035](/v1/bulletins/10224035)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20S2023000042&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10224035&vehicle=Service%20bulletin%20S2023000042)