# Service bulletin S1908000108

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10224026
- Published by NHTSA: 2022\-10\-17
- Manufacturer's number: S1908000108
- Manufacturer's date: 2020\-11\-10
- NHTSA component: VEHICLE SPEED CONTROL

## NHTSA's summary

\(Rev. A\) Intermittently the vehicle will not crank or start, the RKE, door locks, and remote start will not operate. Multiple U\-codes are present

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2020/MC-10224026-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2020/MC-10224026-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Throttle and cruise control

## Vehicles listed

- 2017 to 2019 JEEP COMPASS

## Other bulletins for the same vehicles and component

- [1808222](/bulletins/10228037.md), 2022-12-19, Service bulletin: ELECTRICAL SYSTEM; POWER TRAIN; AIR BAGS; EQUIPMENT; VEHICLE SPEED CONTROL; WHEELS; EXTERIOR LIGHTING. Flash: Powertrain Control Module \(PCM\) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp \(MIL\) illumination. Upon further investigation the technician may find that one or more of the following DTCs have been set: DTC P1DD2 will be stored in the Transmission Control Module \(TCM\) however no DTCs will be stored in the PCM. Verify no unrelated codes are stored in the PCM before flashing. If codes are stored in the PCM, normal diagnosis should be performed.B25C9 \- Driver Door Ajar Switch 2 Stuck Closed. P061A \- Level 2 Torque Performance. P06E9 \- Engine Starter Performance\(North America Only\). C050D \- Wheel Speed Signal Left Rear Rationality. C0501 \- Wheel Speed Signal Left Front Rationality. C0507 \- Wheel Speed Signal Right Front Rationality. C0513 \- Wheel Speed Signal Right Rear Rationality. P1DD2 \- Torque Request Signal From TCM Denied will be present, set by the TCM and the vehicle will be in limp home mode\(Sales Codes DF5 and DF7 \- Automatic Transmission Vehicles Only\). U1428 \- Inaccurate Engine Torque Received\(Sales Codes DF5 and DF7 Only\). Customers may also comment on one of the following:Long engine cranking prior to vehicle start more noticeable when the outside temperature is above 40°c \(104°f\)\(EMEA with Sales Code ED6 only\). Poor shift quality. Lack of vehicle speed. Vehicle will intermittently not start\(South Korea Only\). The vehicle is in limp home mode \(shift RPMs are limited\) with no DTCs set \(Sales Code DE1 \- Manual Transmission Vehicles Only\).
- [S1923000011RevE](/bulletins/10223941.md), 2022-10-17, Service bulletin: AIR BAGS; VEHICLE SPEED CONTROL; ELECTRICAL SYSTEM. ESS Stop Start Disabled DTC B25C9 Driver Door Ajar Switch 2 Stuck Closed
- [S1808000031RevA](/bulletins/10223923.md), 2022-10-17, Service bulletin: VEHICLE SPEED CONTROL; LANE DEPARTURE; AIR BAGS. Power Windows, Door Locks, Mirrors, Operate Intermittently, Driver Door Ajar Warning Lamp On, Stop Start Feature Disabled
- [9003825](/bulletins/10219998.md), 2022-09-15, Service bulletin: SEATS; VEHICLE SPEED CONTROL; ELECTRICAL SYSTEM; AIR BAGS; BACK OVER PREVENTION. LATCH, Hood For the following concerns, please verify secondary plunger switch before replacing hood latch with primary switch. Please refer to service information for complete diagnostics of the secondary plunger switch which is located in the left front under hood on RU, MP, and WK/WD and left rear under hood on KL. 1\) Electronic Stop Start Message on Cluster or DTC P152F without hood ajar illuminated. 2\) KL Hood ajar light is on or unlatched hood due to high closing effort. \(KL hood may have a higher closing effort to latch the hood as rubber bumper interference is set purposely high to prevent hood flutter at highway speeds\) If stop start message or DTC P152F is present on vehicles without a hood ajar light illuminated, the issue is not related to the primary hood latch switch.
- [9003413](/bulletins/10219831.md), 2022-09-15, Service bulletin: VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.
- [08\-068\-21](/bulletins/10194077.md), 2021-05-24, Service bulletin: POWER TRAIN; EXTERIOR LIGHTING; FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE; VEHICLE SPEED CONTROL; BACK OVER PREVENTION; PARKING BRAKE; ELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING; STRUCTURE; WHEELS; AIR BAGS. Flash: Body Control Module \(BCM\) Updates This bulletin involves reprogramming the BCM with the latest available software. Customers may experience a Malfunction Indicator Lamp \(MIL\) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Codes \(DTCs\) have been set: P0563\-00 \- System Voltage High\(2020 M6 Vehicles equipped with 2.0L I4 Turbo Diesel Engine W/ESS \(Sales Code EBS only\)\). P21CC?00 \- Reductant Control Module Supply Voltage High\(2020 M6 Vehicles equipped with \(Sales Code EBS only\)\). P1515\-00 \- Plausibility Check R1 Stuck Closed Or Vsensing Short To Battery In Engine Running\(2019 M6 only\). B25C9 \- Driver Door Ajar Switch 2 Stuck Closed \(Module, Powertrain Control \(PCM\)\). Stored DTC only, this update isnotfor active fault.If B25C9 is an active fault normal diagnostic must be performed. This software update will not correct active DTC. P26E4\-64 \- Starter Control 2 Circuit\-Signal Plausibility Failure. In addition, customers or technicians may comment on one or more of the following:Engine Stop/Start \(ESS\) not functioning properly\(2020 M6 Vehicles equipped with \(Sales Code EBS only\). Four wheel drive not functioning\(2020 M6 Vehicles equipped with \(Sales Code EBS only\). No start condition if the vehicle has both P1515\-00 and P26E4\-64 DTCs\(2019 M6 only\). Park assist LED does not turn on\(2019\-20 MP/M1 and 2019 M6 only\). The key fob does not work for power lift gate \(Sales Code JRC\)\(2019\-20 MP/M1 and 2019 M6 only\). Vehicle Theft Alarm \(VTA\) sounding after remote start time out\(2019\-20 MP/M1 and 2019 M6 only\). VTA triggers randomly. The vehicle will not restart when in Engine Stop/Start \(ESS\) mode. Customers will have to shift into park and cycle the ignition to get the vehicle to start again. The vehicle cranks but fails to start, the customer will see a message on the Instrument Panel Cluster \(IPC\) "press brake and push ignition button to start" after this happens they must perform a key cycle
- [08\-024\-20 REV. A](/bulletins/10175570.md), 2020-05-26, Service bulletin: VEHICLE SPEED CONTROL. Connected Services Including Mobile App Services \- Inoperative This bulletin involves performing a proxi configuration, then perform a proxi alignment. The customer may comment on the following:All Connected Services are not enabled."Examples of connected services could include the "Send N Go" feature and the"Search N Go" feature."SOS soft key does not appear.Remote operations from the Uconnect app, listed below, are inoperative:Door Lock. Door Unlock. Remote Start. Remote Start Cancel.
- [9003413](/bulletins/10138856.md), 2018-06-04, Service bulletin: VEHICLE SPEED CONTROL:ACCELERATOR PEDAL. Accelerator Pedal Before replacing accelerator pedal, be sure to follow fault code diagnostic procedures in service manual. Make sure to check wiring and connectors. P2122 and P2127 will set if accelerator pedal connector is disconnected during diagnosis. Make sure codes are active before replacing pedal. DTC P2299 is usually caused by a two footed driver and accelerator pedal should not be replaced for this fault.

JSON: [/v1/bulletins/10224026](/v1/bulletins/10224026)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20S1908000108&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10224026&vehicle=Service%20bulletin%20S1908000108)