Service bulletin 68253737A
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10219751 |
| Published by NHTSA | 2022-09-15 |
| Manufacturer's number | 68253737A |
| Manufacturer's date | 2016-03-16 |
| NHTSA component | FUEL SYSTEM, DIESEL |
NHTSA's summary
DEF Tank
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Fuel system
| CHRYSLER 200 | 2014, 2015 |
|---|---|
| CHRYSLER 300 | 2014, 2015 |
| CHRYSLER 300C | 2014, 2015 (the catalog's model; the bulletin names a series or trim of it) |
| CHRYSLER GRAND VOYAGER | 2015 |
| CHRYSLER TOWN AND COUNTRY | 2014, 2015 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 0815223 | 2023-08-21. Service bulletin. Fuel Pump Connector Replacement The technician may experience a crank/no start after the fuel pump module was replaced. This bulletin involves replacing the fuel pump connector harness (pigtail) when replacing the fuel pump module. |
|---|---|
| 9004509 | 2023-01-09. Service bulletin. Oil Filter If a Mopar Oil Filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils. Recommended Brands: Wix, Purolator, and NapaGold |
| 9003665 | 2022-10-31. Service bulletin. Fuel Tank and Fuel Evap System Components 1) For JK MIL On ? P0441: Before replacing this part due to fault code P0441, check for restriction due to plastic over-flash in the Purge Hose Port of the Intake Manifold. If there is flash in the Purge Hose Port of the Intake Manifold and the vehicle is 2016 MY then replace the Intake Manifold and send to QEC. Otherwise, remove the flash with a 5/32? drill bit and clean the Intake Manifold of any flash debris. If the fault code P0441 continues after repairing the Intake Manifold, then send Freeze Frame data of P0441 to Michael.Ade@FCAgroup.com and contact Sylvia Lopez at cell number (248) 520-9734. If you don`t receive response within 15 minutes, please continue with the normal repair procedure. 2) For RT MIL On ? P0456: If ESIM needs to be replaced for fault code P0456, check the Vapor Line, Fresh Air Filter and the Black Frame Rail Blocker for water ingestion. If water ingestion is found, then replace the ESIM part number 04861962AB and the Jumper, Vent Recirculation Tube part number 04721757AI. Please contact Release Engineer Alfredo Salituro @ 213-700-5359 before performing repair service. If you do not receive a response within 15 minutes, please continue with the normal repair procedure. |
| 2500216 | 2022-10-17. Service bulletin. Replace Purge Control Valve Hose This bulletin involves replacing the purge control valve hose assembly. The customer may describe a slight noise coming from the engine compartment at the purge control valve area on the engine. |
| 9004268 | 2022-10-17. Service bulletin. THROTTLE BODY For clarification, only use 68414676A$ on 2010 & earlier vehicles as supply is limited. |
| 9004509 | 2022-10-17. Service bulletin. Oil Filter If a Mopar Oil Filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils. Recommended Brands: Wix, Purolator, and NapaGold |
| 9003704 | 2022-09-26. Service bulletin. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
| S2208000131 | 2022-09-26. Service bulletin. No Start Condition After A Fuel Pump Replacement, Multiple Fuel System Level Related DTC?s Setting |
| 2400614 | 2022-09-26. Service bulletin. Poor AC Performance This bulletin involves inspecting the A/C condenser for leakage and replacing if required. The customer may experience poor A/C performance from the HVAC system due to refrigerant loss through the condenser. |
| 9004509 | 2022-09-26. Service bulletin. Oil Filter If a Mopar Oil Filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils. Recommended Brands: Wix, Purolator, and NapaGold |