# Service bulletin S2108000015

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10215870
- Published by NHTSA: 2022\-07\-18
- Manufacturer's number: S2108000015
- Manufacturer's date: 2021\-01\-16
- NHTSA component: BACK OVER PREVENTION:SOFTWARE

## NHTSA's summary

Uconnect Box Requires Service Message

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2021/MC-10215870-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2021/MC-10215870-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Driver assistance, Backup camera

## Vehicles listed

- 2021 CHRYSLER PACIFICA
- 2021 DODGE DURANGO

## Recalls for the same vehicles and component

- [24V436000](/recalls/nhtsa/24V436000.md), 2024-06-13: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA

## Other bulletins for the same vehicles and component

- [103289](/bulletins/11014887.md), 2025-03-04, Service bulletin: BACK OVER PREVENTION: WARNINGS; LANE DEPARTURE: BLIND SPOT DETECTION. CAMERA \- REAR VIEW
- [S2208000045 REV.B](/bulletins/11011774.md), 2024-12-11, Service bulletin: BACK OVER PREVENTION: REARVIEW SYSTEM BRAKING. Backup Camera Poor Image Quality Inspection
- [9004452](/bulletins/10248516.md), 2024-01-08, Service bulletin: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
- [S2108000015](/bulletins/10247955.md), 2024-01-02, Service bulletin: BACK OVER PREVENTION. Uconnect Box Require Service Message
- [S1408000384](/bulletins/10247948.md), 2024-01-02, Service bulletin: BACK OVER PREVENTION; LANE DEPARTURE. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor \(IBS\) State of Charge \(SOC\) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes \(DTCs\), or Battery Warning Lamp On
- [9003357](/bulletins/10247905.md), 2024-01-02, Service bulletin: BACK OVER PREVENTION. ADAPTER, Engine Oil Filter \(Pentastar V6\) For all 2014MY replace the Oil Filter Adapter \(OFA\). For any other MY \(with mileage above 30,000\) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1\) Remove OFA 2\) Replace only the oil inlet O\-ring and gaskets \(seals kit in SOL above\). 3\) Re\-install the OFA. For 2023MY and beyond use black O\-ring. For 2022MY and prior use red O\-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
- [0901923](/bulletins/10247472.md), 2023-12-18, Service bulletin: BACK OVER PREVENTION. Cold Engine Ticking Noise From Exhaust Manifold Area The customer may describe an ticking noise from the exhaust manifold location\(s\) when cold. This bulletin involves replacing the exhaust manifolds.
- [S238A000047](/bulletins/10247435.md), 2023-12-18, Service bulletin: BACK OVER PREVENTION. Humming Noise Through Speakers While Vehicle Is Off
- [9004452](/bulletins/10244355.md), 2023-10-30, Service bulletin: BACK OVER PREVENTION: SENSING SYSTEM: CAMERA. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
- [9100133](/bulletins/10239854.md), 2023-07-31, Service bulletin: BACK OVER PREVENTION. ROCKER ARM ASSY \- ROLLER ROCKER Case 1.\- Before replacing the intake or exhaust rocker arms due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head \(no need to replace rocker arms\). The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes \(DTC\)s present. Case 2.\- If the INTAKE camshaft or INTAKE rocker arm has excessive wear on the high lift profile \(Rocker arm: slider, Camshaft: central lobe\), replace the intake camshaft \(1\) in that cylinder head and all intake rocker arms \(6\).

JSON: [/v1/bulletins/10215870](/v1/bulletins/10215870)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20S2108000015&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10215870&vehicle=Service%20bulletin%20S2108000015)