Service bulletin SSM 50826
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10213707 |
| Published by NHTSA | 2022-06-17 |
| Manufacturer's number | SSM 50826 |
| Manufacturer's date | 2022-06-03 |
| NHTSA component | ELECTRICAL SYSTEM:WIRING; POWER TRAIN; EQUIPMENT |
NHTSA's summary
Some 2022 Maverick vehicles may exhibit an illuminated MIL with diagnostic trouble codes (DTCs) P025A, P025B, P00C6, P008A, P0627 and/or U0109 stored in the powertrain control module (PCM). This may be due to an intermittent or partial disconnect of the harness, connector pin push-outs or loose/corroded grounds to the fuel pump control module (FPCM) connector, PCM connector and/or battery junction box connector. Inspect the following connectors: C1381B (2.5L hybrid) or C1551B (2.0L engine), C1035A, C4033, C219, and C405. Verify the connections are fully seated, without damage and/or pushed out pins/terminals prior to performing Workshop Manual (WSM) diagnostics or replacing any components. Inspect G406 and verify it's clean and secure. If any connector damage is found, repair as necessary. Refer to Wiring Diagram, Cell 005.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Equipment and accessories, Transmission and driveline, Wiring and fuses
Trouble codes named
P008A, P00C6, P025A, P025B, P0627, U0109
| FORD MAVERICK | 2022 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| SSM 50458 | 2022-02-16. Service bulletin. Some 2020-2021 Explorer/Aviator/Escape/Corsair, 2021-2022 Bronco Sport, and 2022 Maverick vehicles may exhibit an inoperative driver door window control switch (windows inoperative, mirror control unresponsive, etc.). Diagnostic trouble code (DTC) B1088:87 may be present in the driver door module (DDM). This may be due to the software in the DDM. To correct the condition, reprogram the DDM with the latest software level of the Ford Diagnosis and Repair System (FDRS). After reprogramming the DDM, run the DDM configuration application and perform a window learn routine via FDRS. For claiming, use causal part 14B291 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual. |
|---|