Service bulletin S2008000023

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10212472
Published by NHTSA	2022-05-31
Manufacturer's number	S2008000023
Manufacturer's date	2021-06-26
NHTSA component	ENGINE AND ENGINE COOLING:ENGINE:CRANK/CAMSHAFT POSITION SENSOR

NHTSA's summary

No Crank No Start, Click No Start

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine

Vehicles listed
DODGE DURANGO	2020, 2021, 2022
JEEP GRAND CHEROKEE	2020, 2021
JEEP GRAND CHEROKEE 4XE	2022 (the catalog's model; the bulletin names a series or trim of it)

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2023338	2023-06-08. Engine
23V412000	2023-06-08. ENGINE
23V411000	2023-06-08. ENGINE AND ENGINE COOLING
2022217	2022-04-28. Engine
22V284000	2022-04-28. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:GAS RECIRCULATION VALVE (EGR VALVE)
2020371	2020-08-13. Engine

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
9100898	2026-09-17. Service bulletin. Engine PNs: MY 24-26 WD/DT (5.7L) Code P00B is being misdiagnosed and incorrect parts are being installed causing over repair. Refer to SOL S2609000006 The IAFM Foam Engine Valley Cover (PN 53013735AB) does not provide sufficient clearance for proper routing of the MDS solenoid jumper harness (PN 05148163AE). As a result, the harness may become compressed by the foam cover. To prevent unnecessary part replacement, the MDS solenoid jumper harness (PN 05148163AE) should be inspected for damage or pinch conditions prior to replacing the following part numbers: Engine PNs: 68409343AA 68409357AA 68450915AA OCV PNs: 53022338AB Phaser PNs: 53022298AA 53022298AB
9100363 Rev 3	2026-09-03. Service bulletin. Turbocharger Kit Please note that many turbo components are serviceable separately and full turbo replacement may not be required. If the turbo is being inspected for: Noise/Rattle: Inspect heat shield fasteners for looseness and check the wastegate actuator/linkage for binding. The actuator kit is serviced separately. Oil Leak: Inspect the turbo oil feed O-ring area for leaks. O-ring is serviced separately.
113803	2026-08-13. Service bulletin. HOSE AND TUBE - HEATER SUPPLY AND RETURN
112639	2026-07-08. Service bulletin. THROTTLE BODY – NONE
112640	2026-07-08. Service bulletin. THROTTLE BODY – NONE
112842	2026-07-02. Service bulletin. BOLT - HEX FLANGE HEAD
112191	2026-05-28. Service bulletin. COOLER - ENGINE OIL
112192	2026-05-28. Service bulletin. COOLER - ENGINE OIL
18-050-26	2026-04-22. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0300 - Multiple Cylinder Misfire - In Active or Stored status set during cold start catalyst heating. ● P0301 - Cylinder 1 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0302 - Cylinder 2 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0303 - Cylinder 3 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0304 - Cylinder 4 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0305 - Cylinder 5 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0306 - Cylinder 6 Misfire - In Active or Stored status set during cold start catalyst heating. Customers may also comment on one or more of the following: ● Check engine illuminates when fueling the vehicle while the engine is running. ● Vehicle has a noticeable misfire. ● Vehicle idles rough. ● Engine noise. NOTE: Noise is heard coming from the valvetrain. In addition, the following software enhancement is available: ● Update to prevent customers from driving their vehicles while the Electric Park Brake (EPB) is engaged. Engine torque will be limited to prevent the Rear Drive Unit from being damaged. NOTE: Previously, the EPB would remain engaged without any torque limit which could lead to the Rear Drive Unit being damaged/broken. This bulletin involves reprogramming the PCM with the latest available software.
18-049-26	2026-04-22. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must SYMPTOM: exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): ● P0300 - Multiple Cylinder Misfire - In Active or Stored status set during cold start catalyst heating. ● P0301 - Cylinder 1 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0302 - Cylinder 2 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0303 - Cylinder 3 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0304 - Cylinder 4 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0305 - Cylinder 5 Misfire - In Active or Stored status set during cold start catalyst heating. ● P0306 - Cylinder 6 Misfire - In Active or Stored status set during cold start catalyst heating. ● P2066 - Fuel Level Sensor 2 Performance. ● P152F - Engine Hood Switch 2 / Engine Hood Switch 1 Correlation. ● P0401 - EGR System Performance. ● P00FD - Battery B State Of Charge Performance. Customers may also comment on one or more of the following: ● Check engine illuminates when fueling the vehicle while the engine is running. ● Vehicle has a noticeable misfire. ● Vehicle idles rough. ● Engine noise. NOTE: Noise is heard coming from the valvetrain. In addition, the following software enhancements are available: ● Update to prevent customers from driving their vehicles while the Electric Park Brake (EPB) is engaged. Engine torque will be limited to prevent the Rear Drive Unit from being damaged. NOTE: Previously, the EPB would remain engaged without any torque limit which could lead to the Rear Drive Unit being damaged/broken. ● Update to enable customers to operate at high state of charge range between 85 to 92%. This bulletin involves reprogramming the PCM with the latest available software.