Service bulletin 1804622
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10212381 |
| Published by NHTSA | 2022-05-31 |
| Manufacturer's number | 1804622 |
| Manufacturer's date | 2022-03-05 |
| NHTSA component | ENGINE AND ENGINE COOLING; EQUIPMENT ADAPTIVE/MOBILITY; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM); ELECTRICAL SYSTEM |
NHTSA's summary
Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic Trouble Code (DTC):P06EF - Engine Restart Performance. Customers may experience the following:Long engine crank after an Engine Stop/Start (ESS) event.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Engine, Equipment and accessories, Transmission and driveline, Automatic transmission, Transmission control module
Trouble codes named
P06EF
| JEEP CHEROKEE | 2018 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 9003783 | 2022-10-31. Service bulletin. Shifter - Automatic Transmission If a 2015 - 18MY KL ONLY is brought in with a ?Service Shifter? message on the cluster and/or the following DTCs are present indicating loss of communication with the shifter: U0103, U0103-87. Prior to beginning any repair, please call John Zbranchik at 248-576-0756 or Pablo Flores at 248-576-3972. If no reply contact Dil Weerasinha at 248-944-5967 or Jay Nagle 248-576-5657. If you are unable to contact any of the above, and all the DTCs related to loss of comm are STORED, first perform a vehicle scan with a wiTECH tool or similar and email the log to john.zbranchik@fcagroup.com and pablo.flores1@fcagroup.com. Ensure all stored DTCs in the vehicle are recorded in the log. Use the tool to clear all codes and ensure the ?Service Shifter? message does not return. If this is the first occurrence of this issue on this vehicle, do NOT replace the shifter at this time. If any DTCs related to loss of comm with the shifter are ACTIVE, a full bus log is highly desired. Please contact a regional tech representative to acquire this log. After the log is acquired, or if this is not feasible, check for loose/bent pins, spread terminals on both the male pin cavity in the shifter and the female connector from the body harness take out and all grounds. If no issues are found, replace the shifter and return it to the Quality Engineering Center (QEC). |
|---|