# Service bulletin NTB21\-074

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10201221
- Published by NHTSA: 2021\-09\-10
- Manufacturer's number: NTB21\-074
- Manufacturer's date: 2021\-08\-06
- NHTSA component: ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL

## NHTSA's summary

IDLE STOP / START SYSTEM FAULT ERROR MESSAGE SERVICE INFORMATION A “Stop / Start System Fault” error message may be displayed on the instrument panel \(Figure 1\), if the seatbelt remains buckled or unbuckled over 10 consecutive drive cycles. • Drive cycle: Driven over 2 mph, and then parked for at least 10 minutes If the Stop / Start System Fault error message is displayed on the meter, in most cases buckling / unbuckling the seat belt with the ignition ON, or in accessory mode, should clear the message. • If buckling / unbuckling the driver’s seatbelt does not resolve the issue, refer to the Electronic Service Manual \(ESM\) to diagnose and repair the vehicle, and clear the Idle Stop System \(ISS\) meter message.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2021/MC-10201221-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2021/MC-10201221-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Electrical system, Instrument cluster

## Vehicles listed

- 2022 NISSAN PATHFINDER

## Other bulletins for the same vehicles and component

- [NTB22\-026](/bulletins/10213684.md), 2022-06-08, Service bulletin: ELECTRICAL SYSTEM:INSTRUMENT PANEL:FUEL GAUGE:FUEL LEVEL FLOAT/SENSOR/SENDING UNIT; ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE \(ECU/ECM\):SOFTWARE; FUEL SYSTEM, DIESEL; FUEL SYSTEM, GASOLINE. SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire “Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly” \(fuel pump assembly\). The fuel level sensor can be replaced separately. • P0460 \(FUEL LEV SEN SLOSH\) • P0461 \(FUEL LEVEL SENSOR\) • P0462 \(FUEL LEVL SEN/CIRC\) • P0463 \(FUEL LEVL SEN/CIRC\) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.

JSON: [/v1/bulletins/10201221](/v1/bulletins/10201221)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20NTB21-074&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10201221&vehicle=Service%20bulletin%20NTB21-074)