WenmarOpen by Wenmar Pro

Service bulletin NTB21-074

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10201221
Published by NHTSA2021-09-10
Manufacturer's numberNTB21-074
Manufacturer's date2021-08-06
NHTSA componentELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL

NHTSA's summary

IDLE STOP / START SYSTEM FAULT ERROR MESSAGE SERVICE INFORMATION A “Stop / Start System Fault” error message may be displayed on the instrument panel (Figure 1), if the seatbelt remains buckled or unbuckled over 10 consecutive drive cycles. • Drive cycle: Driven over 2 mph, and then parked for at least 10 minutes If the Stop / Start System Fault error message is displayed on the meter, in most cases buckling / unbuckling the seat belt with the ignition ON, or in accessory mode, should clear the message. • If buckling / unbuckling the driver’s seatbelt does not resolve the issue, refer to the Electronic Service Manual (ESM) to diagnose and repair the vehicle, and clear the Idle Stop System (ISS) meter message.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Electrical system, Instrument cluster

Vehicles listed
NISSAN PATHFINDER2022

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
NTB22-0262022-06-08. Service bulletin. SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire “Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly” (fuel pump assembly). The fuel level sensor can be replaced separately. • P0460 (FUEL LEV SEN SLOSH) • P0461 (FUEL LEVEL SENSOR) • P0462 (FUEL LEVL SEN/CIRC) • P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.