Service bulletin MAILW

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10192660
Published by NHTSA	2021-05-10
Manufacturer's number	MAILW
Manufacturer's date	2015-10-26
NHTSA component	EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL

NHTSA's summary

Infiniti is conducting a Voluntary Service Campaign on ~13,807 MY15 Q40 Sedan and Q60 Coupe vehicles to provide a revised Owner's Manual.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Equipment and accessories, Labels and manuals

Vehicles listed
INFINITI Q40	2015
INFINITI Q60	2015

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
ITB11021B	2021-05-10. Service bulletin. SERVICE INFORMATION Temporary tire Flat Spotting is common on New Dealer In-Stock vehicles that have not been occasionally moved. Flat Spotting can occur after the vehicle has been parked (not moved) for a few days, or longer. In most cases it is temporary. In extreme cases it can be permanent. Vehicles should be moved every 30 days, in one direction only, enough to rotate the tires 90° (see Figure 1). Moving vehicles as shown in this bulletin will prevent tire Flat Spotting. See this bulletin for further detail.
ITB09041A	2021-05-10. Service bulletin. IF YOU CONFIRM A refrigerant leak at a refrigerant pipe/hose joint location, ACTIONS 1. Inspect the metal surfaces of the pipe/hose joint for damage or contamination. NOTE: Do not replace a refrigerant pipe, hose, or other A/C component if an o-ring seal will solve the leak incident, if it should occur. 2. If no damage is found to the joint metal surfaces, replace the O-ring seal. See this bulletin for further detail.
ITB09063B	2021-05-10. Service bulletin. SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement "Certification Label" or "VIN Plate / Label" may be needed. These items may be available from Infiniti by request if certain criteria are met. This bulletinlists the criteria and provides an application form for such replacements. See this bulletin for further detail.
ITB15021A	2021-05-10. Service bulletin. SERVICE INFORMATION If the clip for the fuel filler cap tether becomes lost or is detached for any reason, it is no longer necessary to replace the fuel filler cap. The clip or "pin" is now available as a separate service part. NOTE - Do not replace the fuel filler cap if only the pin is needed. See this bulletin for further detail.
ITB09015G	2021-05-10. Service bulletin. SERVICE INFORMATION Design and process changes have been made to improve battery voltage at dealer receipt. Our goal is to deliver vehicles to customers with a 12 volt battery in excellent condition. Proper dealership storage and maintenance of vehicle 12 volt batteries is essential to insuring good battery operating life and customer satisfaction. Dealers are responsible for maintaining vehicles in their inventory. 12 volt batteries in vehicle inventory should always be kept at a full charge to prevent excessive discharge during storage and so they are ready for delivery to customers at any time. See this bulletin for further detail.
MAILWOL	2021-05-10. Service bulletin. Infiniti is conducting a Voluntary Service Campaign on ~13,807 MY15 Q40 Sedan and Q60 Coupe vehicles to provide a revised Owner's Manual.
ITB11042D	2021-05-10. Service bulletin. IF YOU CONFIRM The customer states HomeLink will not operate or has improper operation. ACTIONS 1. To significantly reduce unnecessary repairs, make sure: a. The vehicle is not in "Transit Mode" (if equipped). - Not in Transit Mode: With the turn signal switch is in the OFF (center) position, turn the ignition from OFF to ON. If the turn signal indicators stay OFF (do not illuminate), the vehicle is not in Transit Mode. b. The "Extended Storage Switch" (if equipped) is in the "Customer Delivery" position (pushed in). - The Extended Storage Switch is located on the fuse block that is located in the interior of the vehicle. 2. Confirm the customer is familiar with the HomeLink programming procedure located in the vehicle?s owner?s manual. 3. Test HomeLink operation with special tool HomeLink Transmitter Tester J-41540. See this bulletin for further detail.
ITB11011A	2021-05-10. Service bulletin. SERVICE INFORMATION For QX60 Hybrid Vehicles, go to page 4. Q50, Q70, and M35 Hybrid Vehicles The internal combustion (IC) engine in the Q50, Q70, and M35 Hybrid vehicles is started using a high voltage motor that is integrated into the transmission. The high voltage motor gets its power from the high voltage Lithium-Ion (Li-ion) battery that is mounted between the trunk room and the rear seat. The Li-ion battery cannot be recharged using an external battery charger; therefore it is very important that the battery state of charge (SOC) is properly maintained during extended storage periods. Action must to be taken in order to prevent excessive discharge of the high voltage Li-ion battery during an extended storage period. If the reserve capacity of the Li-ion battery is not sufficient, the hybrid system cannot be started. Perform the Battery Discharge Prevention During Extended Storage procedure in this bulletin once a month (every 30 days). NOTE: A discharged high voltage Li-ion battery is not a warrantable issue. See this bulletin for further detail.
ITB10017D	2021-05-10. Service bulletin. SERVICE INFORMATION If the AV Control Unit needs to be replaced on an Applied Vehicle for any reason, follow the steps in the Service Procedure to configure the Multi AV system. NOTE - The original AV Control Unit must be installed in the vehicle while performing part of this procedure. DO NOT remove the original AV Control Unit until instructed. See this bulletin for further detail.
ITB13054D	2021-05-10. Service bulletin. IF YOU CONFIRM: The MIL is ON with DTC P0101 and/or P010B (MAF SEN/CIRCUIT-B1/B2) and there are no drivability issues. ACTION: 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. NOTE: If this bulletin does apply (the ECM needs to be reprogrammed), do NOT replace the mass air flow sensor(s). See this bulletin for further detail.