# Service bulletin ITB13022A

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10192201
- Published by NHTSA: 2021\-05\-10
- Manufacturer's number: ITB13022A
- Manufacturer's date: 2013\-06\-27
- NHTSA component: ELECTRICAL SYSTEM; POWER TRAIN

## NHTSA's summary

SERVICE INFORMATION \- The Applied Vehicles listed in this bulletin may arrive at the dealer with a "Power Cut OFF Switch" \(see Figure 1\). \- This Power Cut Off Switch should have been removed before the vehicle was shipped to the dealer. In a few cases, a vehicle may arrive at the dealer with the switch still installed. \- If a vehicle arrives at the dealer with a Power Cut Off Switch installed, it must be removed during the vehicle PDI. See this bulletin for further detail.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2013/MC-10192201-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2013/MC-10192201-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Electrical system, Transmission and driveline

## Vehicles listed

- 2013 INFINITI EX35
- 2013 INFINITI G37

## Other bulletins for the same vehicles and component

- [ITB13\-052E](/bulletins/11002539.md), 2024-06-28, Service bulletin: ELECTRICAL SYSTEM. INTELLIGENT KEY NOT DETECTED / ENGINE WILL NOT START This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB13\-006D](/bulletins/11002537.md), 2024-06-28, Service bulletin: ELECTRICAL SYSTEM. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB10\-029C](/bulletins/11001653.md), 2024-06-14, Service bulletin: ELECTRICAL SYSTEM. CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB13\-008D](/bulletins/10233614.md), 2023-04-04, Service bulletin: POWER TRAIN:AXLE HUBS. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE\-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB13\-008C](/bulletins/10222705.md), 2022-10-07, Service bulletin: POWER TRAIN. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE\-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB22\-006](/bulletins/10208943.md), 2022-03-12, Service bulletin: ELECTRICAL SYSTEM; ELECTRICAL SYSTEM:12V/24V/48V BATTERY. BATTERY QUICK CHARGE NOTICE SERVICE INFORMATION When charging the vehicle’s 12 volt battery with the high amperage quick charge function, the ignition should never be ON, or turned ON, while charging. Attempting to start the vehicle, or turning the ignition ON, while using the high amperage quick charge could potentially damage the fuel pump control module. • Only turn the ignition ON when either the ESM or a technical service bulletin service procedure states to do so, and only while using a battery maintainer or smart charger set to reflash mode, or a similar setting. • Battery voltage should not exceed 16V during a reprograming operation.
- [ITB13\-006C](/bulletins/10208930.md), 2022-03-12, Service bulletin: ELECTRICAL SYSTEM. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB10\-029B](/bulletins/10207844.md), 2022-02-09, Service bulletin: ELECTRICAL SYSTEM. CAN COMMUNICATION CODES – DIAGNOSTIC TIPS AND GUIDELINES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB13\-008B](/bulletins/10199137.md), 2021-07-10, Service bulletin: POWER TRAIN. CLICKING NOISE FROM FRONT OR REAR AXLE DURING TAKE\-OFF/ACCELERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
- [ITB14021B](/bulletins/10192822.md), 2021-05-10, Service bulletin: POWER TRAIN; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY. SERVICE INFORMATION Replacement 5\-speed rear wheel drive Automatic Transmission \(A/T\) assemblies and replacement control valves \(valve bodies\) now come with blank Transmission Control Modules \(TCMs\). Blank TCMs come without software and must be programmed \(not reprogrammed\) and then configured after they are installed. When ordering a replacement A/T or control valve, use the Infiniti electronic parts information systems to obtain the correct software program part number See this bulletin for further detail.

JSON: [/v1/bulletins/10192201](/v1/bulletins/10192201)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20ITB13022A&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10192201&vehicle=Service%20bulletin%20ITB13022A)