Service bulletin Updated ZH1 U760
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10190456 |
| Published by NHTSA | 2021-04-19 |
| Manufacturer's number | Updated ZH1 U760 |
| Manufacturer's date | 2021-03-15 |
| NHTSA component | AIR BAGS; SEAT BELTS |
NHTSA's summary
DP: In these vehicles, Toyota has received some reports where vehicles may exhibit a brief intermittent shudder during torque converter flex lock up. This shudder may be observed while driving under light throttle conditions between approximately 25 ? 50 mph. Although the Torque Converter is covered by Toyota?s New Vehicle Limited Warranty for 5 years or 60,000 miles (whichever occurs first), we at Toyota care about the customers? ownership experience. Toyota is now extending the warranty coverage for repairs related to Torque Converter Shudder.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Air bags, Seat belts
| TOYOTA RAV4 | 2013, 2014, 2015 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 16V096000 | 2016-02-19. SEAT BELTS:REAR/OTHER |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| TSB003220 | 2023-10-16. Service bulletin. TSB: Replacement certification labels (the vinyl label installed on the driver door or door post) and VIN plates (the metal plate riveted to dashboard) (see Figure 1) for most 1979 ? 2023 model year vehicles may be available provided the requests meet the criteria listed in this Service Bulletin. Follow the Procurement Procedure in this bulletin to request a replacement certification label or VIN plate. |
|---|---|
| T-SB-0094-21 Rev | 2022-12-19. Service bulletin. TSB: Some 2005 ? 2022 model year Toyota vehicles that have undergone water intrusion may exhibit a condition in which a musty smell is present. Follow the procedures in this bulletin to remediate the odor and address this condition. The purpose of this service bulletin is to provide general guidelines and procedures for odor remediation. This service bulletin provides a guide on how to prepare the interior of the vehicle prior to an odor remediation being performed, as well as contact information for an approved vendor who will arrange the remediation, and instructions on how to prepare the interior of the vehicle for reassembly once the remediation has been completed. Refer to all model and model year specific Repair Manuals and the EPA (Environmental Protection Agency) website for the most up-to-date safety and precautionary guidelines. This service bulletin is to provide a general overview and direction for the odor remediation process. |
| Toyota Safety Re | 2021-04-19. Service bulletin. Toyota Safety Recall and Service Campaign - Technician Certification Requirements |
| T-SB-0023-15 Rev | 2021-04-19. Service bulletin. TSB: Some 2013 ? 2015 model year RAV4 vehicles may exhibit a brief shudder intermittently while driving under light loads between approximately 25 and 50 mph. The torque converter and Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) logic have been modified to reduce the possibility of this condition from occurring. Follow the Repair Procedure in this bulletin to address this condition. |
| T-TT-0213-13 | 2018-04-23. Service bulletin. Toyota vehicles are equipped with SRS, including various airbags and in some models, seat belt pre-tensioners, to help reduce the risk of injury in a collision. If a customer expresses any concerns that the SRS airbags or pretensioner devices did not perform as expected, please follow the steps in the recommendations section below. |
| T-SB-0218-17_Rev | 2018-04-02. Service bulletin. TSB: REVISION NOTICE July 20, 2017 Rev1: Applicability has been updated to exclude 2007 ? 2017 model year Avanza vehicles. Some hazardous material treatment and handling regulations at the state and local level define the pre-disposal deployment of airbag and pre-tensioner assemblies as hazardous material treatment. Hazardous material treatment may require special training, certification or licensing in certain areas. TMS recommends that dealership personnel carefully review and follow ALL local and state regulations, and where necessary, contract with Environmental Protection Agency (EPA) Licensed Hazardous Waste Transportation and Disposal facilities. |
| T-SB-0122-11 Rev | 2018-04-02. Service bulletin. Beginning in 1998, Toyota introduced side airbags as optional equipment. Toyota does NOT recommend replacement of original seat covers with non-Toyota leather or other seat cover materials on vehicles due to the following: Seat covers NOT recommended by Toyota may affect side airbag performance, in general or in part, during an accident. Modifications that negatively affect side airbag performance can result in severe occupant injuries. Seat covers are an integral part of this safety system. Replacing fabric seat covers with non-Toyota leather or other seat cover materials may compromise the effectiveness of this safety system. The design of the seat is complex, integrating safety and strength with comfort and luxury. Toyota strongly discourages modifying original equipment seats that have optional side airbags. Additionally, Toyota strongly advises against the installation or use of aftermarket seat covers, which could impair the performance of the side airbags in the event of an accident. |
| T-TT-0213-13 | 2018-04-02. Service bulletin. Toyota vehicles are equipped with Supplemental Restraint Systems (SRS), including various airbags and in some models, seat belt pre-tensioners, to help reduce the risk of injury in a collision. If a customer expresses any concerns that the SRS airbags or pre-tensioner devices did not perform as expected (including an unintended deployment event), please follow the steps in the recommendations section below. |
| T-TT-0280-14 | 2018-04-02. Service bulletin. During Pre-Delivery Service (PDS), it is standard procedure (as outlined in the PDS check sheets) to verify that the Safety Connect system is in ?Shelled Mode? with a green LED illuminated prior to delivering the vehicle. Occasionally settings in the Data Communication Module (in-vehicle DCM), or on the network may prevent the ?Shelled Mode? status. In these potential cases, the vehicle is likely to be in ?Shipping Mode? and a red LED may be detected with or without a DTC. |
| HR1_Dealer Lette | 2018-04-02. Service bulletin. Dealer Letter: Toyota will be sending Safety Recall Follow-Up Notices to remind owners whose vehicles have not yet had campaign repairs completed. |