Service bulletin 23-021-20
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10180267 |
| Published by NHTSA | 2020-09-28 |
| Manufacturer's number | 23-021-20 |
| Manufacturer's date | 2020-08-20 |
| NHTSA component | EQUIPMENT; STRUCTURE; WHEELS; EQUIPMENT ADAPTIVE/MOBILITY |
NHTSA's summary
A-Pillar Water Leak This bulletin involves partially removing both front wheel liners and adding spray foam near the body load beam ends, on each side of the vehicle. Customers may comment on the following:Wet front carpets inside the cabin near the driver, passenger or both, front floor A-pillar areas.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Body and frame, Equipment and accessories, Wheels
| JEEP CHEROKEE | 2020 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| S2208000045 REV.D | 2026-07-02. Service bulletin. Backup Camera Poor Image Quality Inspection |
|---|---|
| S2523000003 REV.A | 2026-04-29. Service bulletin. Door Latch, Handle And Ajar Additional Service Information. |
| 08-075-26 | 2026-03-05. Service bulletin. Rear Taillamp Condensation Clearing Procedure On occasion, vehicle exterior taillamp assemblies get fogged with a light layer of condensation on the SYMPTOM: inside of the lenses Fig. 1. This may be reported after the lamps have been turned on and brought up to operating temperature, turned off and then rapidly cooled by cold water (such as rain, or the water from a vehicle wash). Lens fogging can also occur under certain atmospheric conditions after a vehicle has been parked outside overnight (i.e. a warm humid day followed by clear cool night). This will usually clear as atmospheric conditions change to allow the condensation to change back into a vapor. Turning the taillamps on will usually accelerate this process. This bulletin is to communicate the procedure for rear taillamp condensation clearing. |
| 23-008-25 REV. A | 2025-09-24. Service bulletin. Exterior Front Lamps Condensation Clearing Procedure *Some customers may report that on occasion vehicle exterior front lamps (headlamps, fog lamps, grille lamps, logo lamps or signature lamps) assemblies are fogged with a light layer of condensation on the inside of the lenses* |
| 31-001-25 REV. A | 2025-08-21. Service bulletin. Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates. |
| 31-001-25 REV. B | 2025-08-21. Service bulletin. Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates. |
| 31-001-25 | 2025-08-21. Service bulletin. Aluminum Body Panel Corrosion Repair Aluminum corrosion or bubbling along the leading edge of hood, hinges or other exterior surface areas of the hinges, doors, fenders, swing gates or liftgates |
| 08-220-25 | 2025-07-31. Service bulletin. Rear Taillamp Condensation Clearing Procedure On occasion, vehicle exterior taillamp assemblies are fogged with a light layer of condensation on the inside of the lenses Fig. 1. This may be reported after the lamps have been turned on and brought up to operating temperature, turned off and then rapidly cooled by cold water (such as rain, or the water from a vehicle wash). Lens fogging can also occur under certain atmospheric conditions after a vehicle has been parked outside overnight (i.e. a warm humid day followed by clear cool night). This will usually clear as atmospheric conditions change to allow the condensation to change back into a vapor. Turning the taillamps on will usually accelerate this process. This bulletin is to communicate the procedure for rear taillamp condensation clearing. |
| 23-008-25 | 2025-02-20. Service bulletin. "Headlamp Condensation Clearing Procedure Some customers may report that on occasion, vehicle exterior head lamp assemblies are fogged with a light layer of condensation on the inside of the lenses. " |
| S2523000003 | 2025-01-16. Service bulletin. Door Latch, Handle And Ajar Additional Service Information. |