WenmarOpen by Wenmar Pro

Service bulletin 18-009-19 REV B

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10162544
Published by NHTSA2019-07-15
Manufacturer's number18-009-19 REV B
Manufacturer's date2019-05-09
NHTSA componentPOWER TRAIN; POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)

NHTSA's summary

Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more of the following DTCs:P0175 - Fuel System 2/1 Rich. P258B - Electronic Vacuum Pump Performance. P0128 - Thermostat Rationality. C0062 - Longitudinal Acceleration Sensor. In addition, the customer may experience one or more of the following:Engine RPM erratic and or bucking, when accelerating after slowing down. Occasional engine shut off while shifting from 4WD low to 2WD. Improvements to the vacuum pump cycle time. Rough idle after cold start.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline, Automatic transmission, Transmission control module

Trouble codes named

C0062, P0128, P0175, P258B

Vehicles listed
RAM 15002019

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
18087232023-10-02. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: ? P0420 - Catalyst System Efficiency Below Threshold Bank 1. ? P0430 - Catalyst System Efficiency Below Threshold Bank 2. This bulletin involves reprogramming the PCM with the latest available software.
18088232023-10-02. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set:? P0420 - Catalyst System Efficiency Below Threshold Bank 1. ? P0430 - Catalyst System Efficiency Below Threshold Bank 2. This bulletin involves reprogramming the PCM with the latest available software.
S18080001522023-04-17. Service bulletin. CEL (Check Engine Lamp) Illuminates, Recent PCM Replace or Flash Update Performed, Diagnostic Trouble Codes (DTCs) P057B Brake Pedal Position Sensor Circuit Performance, P1572 Brake Pedal Stuck, C0042-54 Brake Pedal Missing Calibration
18070222022-12-19. Service bulletin. Flash: Powertrain Control Module (PCM) Updates RAM 1500 PickupThis bulletin applies to vehicles within the following markets/countries: North America, APAC, EMEA and LATAM. This bulletin applies to vehicles equipped with a 3.6L V6 24V VVT Etorque Engine Upgrade I (Sales Code ERG). Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find one or more ofthe following DTCs have been set: P0607 - ECU Internal Performance. P04FC - Crankcase ventilation system performance. U1817 - Lost Communication With Hybrid Powertrain Control Module On D-PT. U0074 - Dedicated Powertrain D-PT Can Bus Off. P0456 - EVAP System Small Leak.If DTC P0456 is present use the wiTECH Small Leak Verification Test (SLVT) to determine ifa leak is present in the system. P06EF - Engine Restart Performance. P0175 - Fuel System 2/1 Rich. P258B - Electronic Vacuum Pump Performance. P0128 - Thermostat Rationality. C0062 - Longitudinal Acceleration Sensor. In addition, customers may experience one or more of the following concerns: A 2-3 kmh (1-2 mph) difference between cruise set speed and the actualvehicle speed (APAC, EMEA and LATAM Only). An inability to tap up cruise control in kph/mph increments. A rough idle during engine warm-up condition. A hesitation during aggressive accelerations after an Electronic Stop/Start(ESS) event and the engine is not fully at warm operational temperature. Engine RPM erratic and or bucking, when accelerating after slowing down. Occasional engine shut off while shifting from 4WD low to 2WD. Improvements to the vacuum pump cycle time. Rough idle after cold start.
S19250000082022-06-27. Service bulletin. Malfunction Indicator Lamp (MIL) Illumination. Diagnostic Trouble Codes (DTCs) P208B ? Reductant Pump 1 Control Performance, and/or P20E8 ? Reductant Pressure Too Low, Set.
18-076-20 REV. A2020-12-28. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or moreof the following Diagnostic Trouble Codes (DTCs) has been set:P0339 - Crankshaft Position Sensor Intermittent. P0335 - Crankshaft Position Sensor Circuit. P258B - Electronic Vacuum Pump Performance. P0456 - EVAP System Small Leak. If DTC P0456 is present use the wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system.The customer may comment on one or more of the following:ECO light does not illuminate in the instrument cluster during Multiple Displacement Solenoid (MDS) event. 2-3 km (1.4 to 1.9 mph) difference between cruise set speed and the actual vehicle speed. ?Ready Not Ready? appearing message in the Electronic Vehicle InformationCenter (EVIC) while driving and before an Engine Stop Start (ESS) event. The engine may exhibit a crank and fail to start situation. Vehicle has a rough idle only after cold start. The radiator cooling fan is stuck on for a long time while driving. Coolant temp/check gauges light illuminated in the Instrument Panel Cluster(IPC). In addition, the following software enhancements are also available:Radiator cooling fan operation strategy. Updated electric vacuum pump calibration to reduce pump wear. Small leak detection in-use monitor performance ratio.
S2025000001 Rev.2020-12-28. Service bulletin. (Rev. B) Malfunction Indicator Lamp Illumination (MIL). Diagnostic Trouble Code (DTC) P203E ? Reductant Level Sensor 1 Circuit Intermittent-Erratic Set.
18-076-20 REV. A2020-12-21. Service bulletin. Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or moreof the following Diagnostic Trouble Codes (DTCs) has been set:P0339 - Crankshaft Position Sensor Intermittent. P0335 - Crankshaft Position Sensor Circuit. P258B - Electronic Vacuum Pump Performance. P0456 - EVAP System Small Leak. If DTC P0456 is present use the wiTECH Small Leak Verification Test (SLVT) to determine if a leak is present in the system.The customer may comment on one or more of the following:ECO light does not illuminate in the instrument cluster during Multiple Displacement Solenoid (MDS) event. 2-3 km (1.4 to 1.9 mph) difference between cruise set speed and the actual vehicle speed. ?Ready Not Ready? appearing message in the Electronic Vehicle InformationCenter (EVIC) while driving and before an Engine Stop Start (ESS) event. The engine may exhibit a crank and fail to start situation. Vehicle has a rough idle only after cold start. The radiator cooling fan is stuck on for a long time while driving. Coolant temp/check gauges light illuminated in the Instrument Panel Cluster(IPC). In addition, the following software enhancements are also available:Radiator cooling fan operation strategy. Updated electric vacuum pump calibration to reduce pump wear. Small leak detection in-use monitor performance ratio.
S1925000008 Rev.2020-12-21. Service bulletin. (Rev. B) Malfunction Indicator Lamp (MIL) Illumination. Diagnostic Trouble Codes (DTCs) P20E8 ? Reductant Pressure Too Low and/or P208B ? Reductant Pump 1 Control Performance Set.
S2025000001 Rev.2020-12-21. Service bulletin. (Rev. B) Malfunction Indicator Lamp Illumination (MIL). Diagnostic Trouble Code (DTC) P203E ? Reductant Level Sensor 1 Circuit Intermittent-Erratic Set.