Service bulletin 9004077
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10162476 |
| Published by NHTSA | 2019-07-15 |
| Manufacturer's number | 9004077 |
| Manufacturer's date | 2019-05-15 |
| NHTSA component | SEATS |
NHTSA's summary
ADJUSTER, Seat For passenger seat exhibiting high fore/aft adjuster effort, please call Randy Olejniczak ar 248-766-4821. If front passenger seat is unbolted, please notice if the seat tracks seem to be out of alignment or not aligned properly with the front mounting holes in the floor pan. If no response in 15 minutes, proceed with repair.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Seats
| DODGE CHALLENGER | 2018, 2019 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 9100263 | 2023-12-18. Service bulletin. Dynamic Sensor Prior to replacing this part, please ensure all the pre-diagnostic & diagnostic procedures have been completed with emphasis on wiring and connector integrity. If codes C006A-28, U0125-00, or C006A-46 are present, warranty analysis suggests a high likelihood of an intermittent connection at or near the wiring connector, especially if the vehicle is a pursuit variant. Please verify wiring per diagnostic procedures, as well as removal & installation guidance called out in the service manual before replacement. |
|---|---|
| 9003704 | 2022-09-26. Service bulletin. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |