Service bulletin NTB19-031
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10160160 |
| Published by NHTSA | 2019-05-20 |
| Manufacturer's number | NTB19-031 |
| Manufacturer's date | 2019-04-09 |
| NHTSA component | ELECTRICAL SYSTEM; BACK OVER PREVENTION |
NHTSA's summary
BEEPING NOISE WHILE TRAVELING THROUGH OPEN AREA IF YOU CONFIRM Customer reports continuous beeping noise and/or the Driving Aids screen shown in Figure 1 flashes, especially when driving in open areas similar to Figure 2. ACTION Refer to TABLE A on page 8 to confirm if ICC/ADAS 2 control unit reprogramming is needed.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Electrical system, Backup camera
| NISSAN ROGUE | 2017, 2018 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 19V654000 | 2019-09-12. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| NTB13-106G | 2021-04-08. Service bulletin. CORRECT OPERATION OF AUDIO CONTROLS AND BACK-UP CAMERA REQUIRES CONFIGURATION WITH C-III PLUS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Discard all previous versions of this bulletin. |
|---|---|
| PC499 - 2017 Rog | 2017-08-01. Service bulletin. Front Camera - Quality Assurance Hold ***** Detailed Information ***** Nissan is committed to a high level of customer service and satisfaction. This commitment requires Nissan to periodically place certain specific vehicles on a temporary Quality Assurance (QA) Hold to assure that these vehicles, as delivered to our customers, meet our exacting standards and our customers' expectations. Effective immediately, Nissan is placing a temporary Quality Assurance (QA) Hold on approximately 17 specific MY2017 Rogue (T32) vehicles. ***** What Dealers Should Do ***** 1. Verify if vehicles currently in dealer inventory are affected by this QA Hold using Service Comm I.D. PC499 Note: Dealers should continue to check new arriving inventory for QA Hold applicability. 2. Please do not drive, sell, or trade the specific 2017 Rogue vehicles in Dealer Inventory subject to this QA Hold. 3. No further action is necessary at this time. Nissan will provide an update by October 31st, 2016. |