Service bulletin SA-010-19
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10154461 |
| Published by NHTSA | 2019-03-11 |
| Manufacturer's number | SA-010-19 |
| Manufacturer's date | 2019-02-25 |
| NHTSA component | VISIBILITY; VISIBILITY:WINDSHIELD WIPER/WASHER |
NHTSA's summary
The new 2019 Mazda3 has new features that may be difficult to understand. This Service Alert provides valuable information to support potential customer concerns. 1. Wiper arm park position is located under the hood. 2. When servicing front wipers, front wiper service mode is required or damage to wiper arms may occur (see Service Information). 3. If wiper arms are replaced, M-MDS is needed for wiper arm adjustment (see Service Information) 4. DO NOT use wiper arms as markers when in dealer inventory.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Glass, wipers and mirrors, Wipers and washers
| MAZDA MAZDA3 | 2019 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| SA-043-26 | 2026-08-04. Service bulletin. This SA supersedes the previously issued SA(s) listed below. The changes are noted in Red. SA-063/24 09/06/24 DESCRIPTION The Blind Spot Monitoring (BSM) system can malfunction with the following symptoms if the rear side radar sensors are installed facing the wrong direction. |
|---|---|
| SA-025-25 | 2025-06-05. Service bulletin. Some vehicles may exhibit wiper blade contact with the A-pillar trim, with or without a chattering noise. This condition may be caused by worn or contaminated wiper blades. It can also be caused by bent wiper arms, or loose wiper arm retaining nuts due to improper handling. Improper handling occurs when pulling on or forcing the wiper arms. Technicians should be aware that while replacement of the wiper blade may resolve some cases, correction of bent components or repositioning of the wiper arms, particularly when the retaining nut is loose, requires additional steps to ensure proper alignment and function. |