# Service bulletin TSB 18\-2225

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10153928
- Published by NHTSA: 2019\-03\-04
- Manufacturer's number: TSB 18\-2225
- Manufacturer's date: 2018\-12\-04
- NHTSA component: FUEL SYSTEM, DIESEL

## NHTSA's summary

Some 2017\-2018 F\-Super Duty vehicles equipped with a 6.7L diesel engine built on or before 09\-Jul\-2018 may exhibit an illuminated MIL with DTCs P24AE, P24AF, P24B1, P24B3, P24C6, P24C7, and/or P24DA in the powertrain control module \(PCM\). This may be due to a concern with the diesel particulate matter sensor. Follow the Service Procedure steps to correct the condition.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2018/MC-10153928-0001.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2018/MC-10153928-9999.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Fuel system

## Trouble codes named

P24AE, P24AF, P24B1, P24B3, P24C6, P24C7, P24DA

## Vehicles listed

- 2017 to 2018 FORD F\-250 SD
- 2017 to 2018 FORD F\-350 SD
- 2017 to 2018 FORD F\-450 SD
- 2017 to 2018 FORD F\-550 SD
- 2017 to 2018 FORD F\-650 SD
- 2017 to 2018 FORD F\-750 SD

## Recalls for the same vehicles and component

- [17V170000](/recalls/nhtsa/17V170000.md), 2017-03-13: FUEL SYSTEM, OTHER
- [16V945000](/recalls/nhtsa/16V945000.md), 2016-12-29: FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING
- [16V778000](/recalls/nhtsa/16V778000.md), 2016-10-26: FUEL SYSTEM, DIESEL
- [2016526](/recalls/tc/2016526.md), 2016-10-25: Fuel System

## Other bulletins for the same vehicles and component

- [SSM 50448](/bulletins/10207140.md), 2022-02-04, Service bulletin: FUEL SYSTEM, DIESEL; POWER TRAIN; ENGINE AND ENGINE COOLING:ENGINE:DIESEL. Some 2017\-2022 F\-Super\-Duty vehicles equipped with a 6.7L diesel engine may exhibit a hard start, lack of power and/or runs rough concern with an illuminated malfunction indicator light \(MIL\) and diagnostic trouble codes \(DTCs\) P0087 and/or P008A. This may be due to low fuel level or fuel gelling in cold ambient temperatures. If no root cause is determined after normal Powertrain Control/Emissions Diagnosis \(PC/ED\) pinpoint test MA, recommend that the customer use a different brand of fuel and use Motorcraft® PM\-23\-A Diesel Fuel Anti\-Gel and Performance Improver. Inform the customer that bio\-diesel blended fuels have a higher occurrence of fuel gelling. Fuel gelling and or low fuel conditions causing a P0087 and/or P008A is not covered under warranty.
- [SSM 49846](/bulletins/10198625.md), 2021-07-02, Service bulletin: FUEL SYSTEM, GASOLINE. Some 2017\-2019 F\-Super Duty/F\-650/F\-750 vehicles may exhibit an illuminated malfunction indicator lamp \(MIL\) with diagnostic trouble code \(DTC\) P24D1 stored in the powertrain control module \(PCM\). To correct the condition, replace the particulate matter sensor. Refer to Workshop Manual \(WSM\), Section 303\-14. For F\-650/F\-750 vehicles, use LC4Z\-5L216\-A. For F\-Super Duty pickup and 203" wheelbase chassis cab vehicles, use LC3Z\-5L216\-C. For F\-Super Duty 145/179/192" wheelbase chassis cab vehicles, use LC3Z\-5L216\-B. For F\-Super Duty 168/169/193/205" wheelbase chassis cab vehicles, use LC3Z\-5L216\-A. For claiming, use causal part 5L239 and applicable labor operations in Section 10 of the Service Labor Time Standards \(SLTS\) Manual.
- [SSM 49065](/bulletins/10179325.md), 2020-09-04, Service bulletin: ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM; FUEL SYSTEM, DIESEL. Some 2011\-2020 F\-Super Duty, 2015\-2019 Transit, 2016\-2021 F\-650/F\-750 and 2018\-2020 F\-150 vehicles equipped with a 6.7L, 3.2L or 3.0L engine may exhibit an illuminated MIL with diagnostic trouble codes \(DTCs\) P207F, P20EE, P229F, P2201 and/or P24AE. This may be a result of using aftermarket cleaning liquids or tools for the exhaust gas recirculation \(EGR\) cooler or intake. Ford does not recommend the cleaning of diesel intakes or EGR coolers using any aftermarket tool that injects a cleaning foam or liquid substance into the EGR cooler or intake. Using these types of fluids can result in sodium poisoning of the NOx and particulate matter \(PM\) sensors resulting in degraded operation and permanent damage to the after treatment system. Use of these cleaning tools may void the emissions warranty of the hot end after treatment exhaust system and the attached emissions sensors.
- [TSB\-20\-2105](/bulletins/10174401.md), 2020-05-05, Service bulletin: FUEL SYSTEM, GASOLINE; ENGINE AND ENGINE COOLING. Some 2017\-2019 F\-Super Duty chassis cab vehicles equipped with a 6.7L engine and an aft of axle fuel tank operating in dusty conditions may exhibit a crank/no start concern with the fuel level showing over 1/4 tank full or the fuel gauge only registers up to 1/2 tank after filling with fuel. For vehicles equipped with an auxiliary fuel delivery source, the customer may also experience the inability to deliver fuel using this equipment. This may be due to dirt being trapped around the dust cap on the front or rear rollover valve \(ROV\) preventing "make\-up air" from entering the fuel tank. To correct the condition, follow the Service Procedure steps to replace the fuel tank and possibly also the fuel pump/sender unit.
- [SSM 47836](/bulletins/10156889.md), 2019-04-08, Service bulletin: FUEL SYSTEM, DIESEL; ENGINE AND ENGINE COOLING:ENGINE:DIESEL. Some 2011\-2019 F\-Super Duty 6.7L diesel equipped vehicles may exhibit a ticking/tapping noise traced to the reductant injector.
- [SSM 47836](/bulletins/10155577.md), 2019-04-01, Service bulletin: FUEL SYSTEM, DIESEL. Some 2011\-2019 F\-Super Duty 6.7L diesel equipped vehicles may exhibit a ticking/tapping noise traced to the reductant injector.
- [SSM 47712](/bulletins/10153949.md), 2019-03-04, Service bulletin: ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL; ENGINE AND ENGINE COOLING:ENGINE:DIESEL; FUEL SYSTEM, DIESEL. Some 2017\-2019 F\-Super Duty and 2016\-2019 F650\-750 with 6.7L diesel engines, 2015\-2019 Transit with 3.2L diesel engines and 2018\-2019 F\-150 with 3.0L diesel engines may exhibit an illuminated malfunction indicator lamp \(MIL\) with diagnostic trouble code \(DTC\) P206C in the powertrain control module \(PCM\). Review of repair data supports that P206C is often the result of incorrect diesel exhaust fluid \(DEF\) concentration. Per Powertrain Control/Emissions Diagnosis \(PC/ED\) Pinpoint Test \(PPT\) RJ, a DEF concentration reading below 28% will set P206C and cause vehicle derate. If low concentration is suspected, drain fluid and replace with known good DEF before replacing any parts. Low concentration of DEF is not a warrantable condition.
- [TSB 19\-2006](/bulletins/10153919.md), 2019-03-04, Service bulletin: ENGINE AND ENGINE COOLING:ENGINE:DIESEL; ELECTRICAL SYSTEM; FUEL SYSTEM, DIESEL. Some 2016\-2018 F\-650/F\-750 vehicles equipped with a 6.7L diesel engine built on or before 23\-Apr\-2018 may exhibit an inaccurate DEF level gauge with no DEF level related diagnostic trouble codes \(DTCs\) in the powertrain control module \(PCM\). Follow the Service Procedure steps to correct the condition.
- [SSM 47402](/bulletins/10144202.md), 2018-09-10, Service bulletin: FUEL SYSTEM, DIESEL; EQUIPMENT. When performing diagnostics for DTCs P2201, P2452, P2459, P246C and/or P2463, a manual regeneration and diesel particulate filter \(DPF\) parameter reset using the appropriate scan tool may need to be performed. To perform the manual regeneration, go to the Toolbox tab \> Powertrain \> Service Functions \> Diesel Particulate Regeneration System \> DPF Manual Regeneration. The scan tool may indicate that a regeneration of the DPF is not recommended at this time, selecting YES on this screen will allow the regeneration process to complete. To perform the DPF parameter reset, go to the Toolbox tab \> Powertrain \> Service Functions \> Diesel Particulate Regeneration System \> DPF Parameter Reset.
- [SSM 47346](/bulletins/10143088.md), 2018-07-23, Service bulletin: EQUIPMENT; FUEL SYSTEM, DIESEL; ENGINE AND ENGINE COOLING:ENGINE:DIESEL; ENGINE AND ENGINE COOLING:EXHAUST SYSTEM. Some 2017\-2018 F\-Super Duty vehicles equipped with a 6.7L diesel engine built on or before 6\-Dec\-2017 may exhibit an exhaust odor in the vehicle cabin. This may be due to a leak at the turbocharger inlet clamps. Performing a pressurized smoke test on the exhaust system will aid in locating the source of a leak. While performing the smoke test, the use of a small mirror can help identify leaks underneath the clamps. Refer to the Powertrain Control/Emissions Diagnosis \(PC/ED\) Manual Pinpoint Test KA, Step KA3. Note that the turbo charger is not a contributing factor in the exhaust leak issue.

JSON: [/v1/bulletins/10153928](/v1/bulletins/10153928)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20TSB%2018-2225&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10153928&vehicle=Service%20bulletin%20TSB%2018-2225)