# Service bulletin TSB018017

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10152203
- Published by NHTSA: 2018\-12\-17
- Manufacturer's number: TSB018017
- Manufacturer's date: 2017\-01\-04
- NHTSA component: LANE DEPARTURE

## NHTSA's summary

TSB: Some 2015 ? 2017 model year Camry and Camry HV vehicles equipped with blind spot monitor may exhibit a blind spot monitor mirror indicator illuminating without an object in the detection area. Follow the Repair Procedure in this bulletin to address this condition.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2017/MC-10152203-9999.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2017/MC-10152203-0001.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Driver assistance

## Vehicles listed

- 2015 to 2017 TOYOTA CAMRY

## Other bulletins for the same vehicles and component

- [TTT063620](/bulletins/10214323.md), 2022-06-21, Service bulletin: BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care \(TCMC\) brake pads may exhibit a groan or squeak noise in various driving conditions
- [T\-SB\-0088\-21](/bulletins/10203533.md), 2021-11-15, Service bulletin: FORWARD COLLISION AVOIDANCE: SENSING SYSTEM: RADAR; BACK OVER PREVENTION: SENSING SYSTEM: RADAR. TSB: For proper calibration of the millimeter wave radar sensor, the vehicle and radar target must be on a level surface with a consistent plane. If a level surface with a consistent plane is not available, use the Floor Slope Compensation Procedure in this service bulletin in conjunction with the appropriate model and model year Repair Manual instructions when adjusting the millimeter wave radar sensor.
- [T\-TT\-0636\-20 Rev](/bulletins/10190453.md), 2021-04-19, Service bulletin: BACK OVER PREVENTION; SERVICE BRAKES. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care \(TCMC\) brake pads may exhibit a groan or squeak noise in various driving conditions.
- [T\-TT\-0636\-20](/bulletins/10187241.md), 2021-02-16, Service bulletin: BACK OVER PREVENTION; SERVICE BRAKES. TT: Some Toyota vehicles installed with Toyota Complete Maintenance Care \(TCMC\) brake pads may exhibit a groan or squeak noise in various driving conditions.
- [T\-TT\-0603\-20](/bulletins/10173988.md), 2020-04-20, Service bulletin: BACK OVER PREVENTION; EQUIPMENT. TT: For proper calibration of the millimeter wave radar sensor, the vehicle must be on a level surface. If a level surface is not available, this tech tip should be used in conjunction with the repair manual to set the angle of the front millimeter wave radar sensor and reflector height before performing beam axis adjustment.
- [T\-SB\-0049\-16](/bulletins/10140637.md), 2018-06-11, Service bulletin: ELECTRICAL SYSTEM; EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL; LANE DEPARTURE: BLIND SPOT DETECTION. TSB: Some 2015 ? 2016 model year Avalon, Camry, Sienna, and Tundra vehicles equipped with Blind Spot Monitor may exhibit a Blind Spot Monitor Warning message with Diagnostic Trouble Code \(DTC\) C1AB2 Short to Ground in Outer Mirror Indicator \(Master\) or C1AB3 Short to Ground in Outer Mirror Indicator \(Slave\) stored. Follow the Repair Procedure in this bulletin to address this condition.
- [T\-TT\-0010\-10 Rev](/bulletins/10132812.md), 2018-04-02, Service bulletin: BACK OVER PREVENTION; ENGINE. Tech Tip: Low battery voltage can contribute to a MIL "ON" condition for P0335 \(Crankshaft Position Sensor Circuit\) and/or P0340 \(Camshaft Position Sensor Circuit\) due to inconsistent rotational speed of the engine's crankshaft.
- [T\-TT\-0419\-16](/bulletins/10132647.md), 2018-04-02, Service bulletin: BACK OVER PREVENTION; VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:REAR WINDOW. TT: Some vehicles may experience static noise when listening to the radio and the rear defogger is activated.
- [T\-SB\-0010\-15](/bulletins/10132605.md), 2018-04-02, Service bulletin: BACK OVER PREVENTION; SERVICE BRAKES, HYDRAULIC. TSB: Some 2015 model year Camry vehicles equipped with the 2AR\-FE engine may exhibit an intermittent service brake warning light ?ON? condition and stored Diagnostic Trouble Code \(DTC\) C1441. Customers may also notice the light will illuminate as the vehicle is being started, and some customers may notice a noise or feeling similar to the ABS activating during normal braking. The Brake Booster has been updated to address this condition.

JSON: [/v1/bulletins/10152203](/v1/bulletins/10152203)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%20TSB018017&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10152203&vehicle=Service%20bulletin%20TSB018017)