Service bulletin 112014
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10149285 |
| Published by NHTSA | 2018-11-26 |
| Manufacturer's number | 112014 |
| Manufacturer's date | 2014-10-01 |
| NHTSA component | ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV) |
NHTSA's summary
Delivery Stop: Crankcase Failure. A Delivery Stop has been issued on certain 2015 model year vehicles with N20/N26 engines produced from September 4, 2014 through October 21, 2014. These vehicles may have a crankcase failure. Approximately 145 vehicles are affected.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Engine, Exhaust and emissions, Crankcase ventilation (PCV)
| BMW 228I | 2014, 2015 |
|---|---|
| BMW 320I | 2013, 2014, 2015 |
| BMW 328I | 2012, 2013, 2014, 2015 |
| BMW 428I | 2014, 2015 |
| BMW 528I | 2012, 2013, 2014, 2015 |
| BMW X1 SAV | 2012 to 2015 |
| BMW X3 | 2013, 2014, 2015 |
| BMW X4 | 2015 |
| BMW Z4 | 2012, 2013, 2014, 2015 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 22V119000 | 2022-03-02. ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL:CRANKCASE (PCV) |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 110215 | 2018-11-13. Service bulletin. SUBJECT Deleting DME Adaptations After Crankshaft Sensor-related Repairs. The erroneous misfire faults are stored, and the Service Engine Soon light (MIL) illuminates The ISTA Service Function to delete the DME adaptations fails to clear the crankshaft incremental wheel adaptation, depending on the current DME software version. This adaptation must be cleared whenever the following repairs are made: 1. Replacement of the crankshaft position sensor 2. Replacement of the incremental sensor wheel on the crankshaft 3. Replacement of the crankshaft 4. Replacement of the crankcase (block) with pistons 5. Replacement of the engine assembly Due to slight tolerance differences with the new replacement hardware and the original learned crankshaft position, values could cause cylinder balance calculation errors by the DME. DME software (the incremental wheel adaptation cannot be cleared) |
|---|---|
| SIB-11-03-08 | 2011-06-11. Service bulletin. BMW: CRANKCASE PRESSURE DIAGNOSIS AND INFORMATION FOR ALL VEHICLES. *RM UPDATED ON 4/24/2013. *KB |