Service bulletin 9003214

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10144814
Published by NHTSA	2018-09-24
Manufacturer's number	9003214
Manufacturer's date	2015-02-11
NHTSA component	EXTERIOR LIGHTING

NHTSA's summary

Part Description: Heated Backlight Issue Description: By design, the upper 12 inches of the backlight does not defrost on vehicles built prior to MDH 121500. However, for improved clearance with 3 additional inches, the backlight can be replaced with p/n 68145494AF.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Lighting

Vehicles listed
CHRYSLER 200	2015

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
09-003-23	2023-02-13. Service bulletin. 2.4L Excessive Oil Consumption XB1 Warranty Extension The customer may describe one or more of the following: Oil pressure low indicator lamp illumination between oil changes. Excessive oil consumption. This bulletin involves performing an oil consumption verification test and possibly replacing the long block.
2102415	2023-01-09. Service bulletin. Flash: Transmission Diagnostic And Shift Enhancements This bulletin involves reprogramming the Transmission Control Module (TCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination on vehicles equipped with a 948TE 9 speed automatic transmission (sales code DFH or DFJ). Upon further investigation, a technician may find Diagnostic Trouble Codes (DTCs) stored in the TCM memory. ? P0887 - TCM Power Control Circuit High ? P0711 - Transmission Fluid Temperature Sensor A Circuit Range-Performance ? P1DAD - Input Shaft-Output Shaft Direction Correlation In addition to addressing the above DTCs, this TCM calibration update is being released to enable the new wiTECH based ?Transmission Quick Learn? procedure to be performed anytime the transmission adaptation memory cells are cleared or when addressing customer concerns of poor shift quality. It is also being released to improve transmission downshift response time during normal driving.
1800615	2023-01-09. Service bulletin. Flash: 2.4L Powertrain Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following Diagnostic .
2100815-1	2023-01-09. Service bulletin. Transmission Shift Quality C-Clutch Snap Ring This bulletin involves removing the transmission, disassembling, and replacing the C-Clutch snap ring. A small number of customers may experience less than desired shift quality during a 5-4 downshift and/or Malfunction Indicator Lamp (MIL) Illumination. Upon further inspection, the technician may find Diagnostic Trouble Code (DTC) U0402 setting in the Powertrain Control Module (PCM) memory.
2100815	2023-01-09. Service bulletin. Transmission Shift Quality C-Clutch Snap Ring This bulletin involves removing the transmission, disassembling, and replacing the C-Clutch snap ring. A small number of customers may experience less than desired shift quality during a 5-4 downshift and/or Malfunction Indicator Lamp (MIL) Illumination. Upon further inspection, the technician may find Diagnostic Trouble Code (DTC) U0402 setting in the Powertrain Control Module (PCM) memory.
9003214	2023-01-09. Service bulletin. Part Description: Heated Backlight Issue Description: By design, the upper 12 inches of the backlight does not defrost on vehicles built prior to MDH 121500. However, for improved clearance with 3 additional inches, the backlight can be replaced with p/n 68145494AF.
18-023-16	2022-12-19. Service bulletin. Flash: 2.4L Powertrain Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination or one or more of the following conditions. Upon further investigation the technician may find the following Diagnostic Trouble Codes (DTCs) set in the PCM memory: 2015 UF Vehicles with (Sales Codes ED6, ED8) · P050D - Cold Start Rough Idle. · P0335 - Crankshaft Position Sensor Circuit. · P1607 - PCM Internal Shutdown Timer Rationality. · P0133 - O2 Sensor 1/1 Slow Response. · P0456 - EVAP System Small Leak. · P0480 - Cooling Fan 1 Control Circuit/Open. · U0402 - Implausible Data Received From TCM. · P2172 - High Airflow/Vacuum Leak Detected. · P1D73 - AGS Performance. · U0140 - Lost Communication With Body Control Module. · P0441 - Evap Purge System Performance. · P0116 - Engine Coolant Temperature Sensor 1 Performance. In addition to the DTCs above the following improvements have been made: · Engine Startup Flare and Idle Surge. · Improved vehicle acceleration. 2015 PF Vehicles with (Sales Codes ED6, ED8) · P1066 - Cylinder 1 Oil Supply Solenoid Valve Switch Off Time Out Of Range. · P1068 - Cylinder 2 Oil Supply Solenoid Valve Switch Off Time Out Of Range. · P106A - Cylinder 3 Oil Supply Solenoid Valve Switch Off Time Out Of Range. · P106C - Cylinder 4 Oil Supply Solenoid Valve Switch Off Time Out Of Range. · U0401 - Implausible Data Received From ECM/PCM - Signal Invalid. · P1185 - General Pressure Sensor Correlation. · P050D - Cold Start Rough Idle. · P0133 - O2 Sensor 1/1 Slow Response. · P0456 - Evap System Small Leak. · P219A - Bank 1 Air-Fuel Ratio Imbalance. · P2172 - High Airflow/Vacuum Leak Detected. · P1D73 - AGS Performance. · U0140 - Lost Communication With Body Control Module.
1802316REVA	2022-12-19. Service bulletin. Flash: 2.4L Powertrain Diagnostic and System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination or one or more of the following conditions. Upon further investigation the technician may find the following Diagnostic Trouble Codes (DTCs) set in the PCM memory: 2015 UF Vehicles with (Sales Codes ED6, ED8) · P050D - Cold Start Rough Idle. · P0335 - Crankshaft Position Sensor Circuit. · P1607 - PCM Internal Shutdown Timer Rationality. · P0133 - O2 Sensor 1/1 Slow Response. · P0456 - Evap System Small Leak. · P0480 - Cooling Fan 1 Control Circuit/Open. · U0402 - Implausible Data Received From TCM. · P2172 - High Airflow/Vacuum Leak Detected. · P1D73 - AGS Performance. · U0140 - Lost Communication With Body Control Module. · P0441 - Evap Purge System Performance. · P0116 - Engine Coolant Temperature Sensor 1 Performance. In addition to the DTCs above the following improvements have been made: · Engine Startup Flare and Idle Surge. · Improved vehicle acceleration. 2015 PF Vehicles with (Sales Codes ED6, ED8) · P050D - Cold Start Rough Idle. · P0133 - O2 Sensor 1/1 Slow Response. · P0456 - Evap System Small Leak. · P219A - Bank 1 Air-Fuel Ratio Imbalance. · P2172 - High Airflow/Vacuum Leak Detected. · P1D73 - AGS Performance. · U0140 - Lost Communication With Body Control Module. · P0116 - Engine Coolant Temperature Sensor 1 Performance. · P050B - Cold Start Ignition Timing Performance. · P061A - Level 2 Torque Performance. · P2172 - High Airflow/Vacuum Leak Detected (Instantaneous Accumulation). In addition to the DTCs above the following improvements have been made: · Low Idle Speed After Cold Start between -10°C to 0°C (14°F to 32°F).
9003735	2022-10-31. Service bulletin. Cam Phasers, Oil Control Valve For Malfunction Indicator Light (MIL) issues related to 2012-2017 3.6L Pentastar engines, please note that there is a new diagnostic procedure available in DealerCONNECT for P-codes in relationship to cam phasers. Please use this new information for trouble shooting of cam phasers and oil control valves for MIL on issues.
21-008-15A	2022-09-26. Service bulletin. Transmission Shift Quality C-Clutch Snap Ring This bulletin involves removing the transmission, disassembling, and replacing the C-Clutch snap ring. A small number of customers may experience less than desired shift quality during a 5-4 downshift and/or Malfunction Indicator Lamp (MIL) Illumination. Upon further inspection, the technician may find Diagnostic Trouble Code (DTC) U0402 setting in the Powertrain Control Module (PCM) memory.