# Service bulletin 9003059

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10139997
- Published by NHTSA: 2018\-06\-11
- Manufacturer's number: 9003059
- Manufacturer's date: 2017\-03\-29
- NHTSA component: EQUIPMENT:ELECTRICAL

## NHTSA's summary

Park Assist Sensor 1\) Active or Stored DTC of Signal Shape / Waveform Failure fault: B128E\-25, B128F\-25, B1290\-25, B1291\-25, B1292\-25, B1293\-25, B1295\-25, B1296\-25, B1297\-25, and/or B1298\-25, check for snow/mud/ice/obstruction and clean the Sensors, both front and back \(behind bumper\) of sensor. The snow/mud/ice can be behind the bumper, sensor retainer and/or the sensor which may cause customers to think they have an issue since they cleaned the front of the sensor/bumper, but not behind where dirt/mud/ice snow can accumulate. Once the Bumper and Sensors are completely cleaned and clear of snow, mud, ice, and/or obstruction, the sensors must activate in order for the faults to go STORED. After cleaning the Bumper and Sensors, turn off the engine, wait 10 seconds, turn on the engine and then place the vehicle in REVERSE so that the sensors activate. The faults will go STORED. 2\) Active or Stored DTC code of Short to Ground fault: B128E\-11, B128F\-11, B1290\-11, B1291\-11, B1292\-11, B1293\-11, B1294\-11, B1295\-11, B1296\-11, and/or B1298\-11, or if you have an active or stored DTC code of Performance or Incorrect Operation fault: B128E\-92, B128F\-92, B1290\-92, B1291\-92, B1293\-92, B1294\-92, B1295\-92, B1296\-92, B1297\-92, and/or B1298\-92, then check the wiring behind the sensor. Specifically, ensure that the connector behind the park assist sensor is fully mounted. Ensure also, there is no dirt, corrosion, or damage in this connector behind the park assist sensor as this will also cause a Short to Ground fault. With potential wiring issues addressed, the sensors must activate in order for the faults to go STORED. After all sensors are properly connected \(you will likely hear a click once the connector is fully seated on the sensor\), turn off the engine, wait 10 seconds, turn on the engine and then place the vehicle in REVERSE so that the sensors activate. The faults will go STORED.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2017/MC-10139997-9999.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2017/MC-10139997-0001.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Equipment and accessories

## Trouble codes named

B128E, B128F, B1290, B1291, B1292, B1293, B1294, B1295, B1296, B1297, B1298

## Vehicles listed

- 2017 CHRYSLER TOWN AND COUNTRY
- 2017 DODGE JOURNEY
- 2013 to 2017 RAM 1500
- 2014 to 2017 RAM 2500
- 2014 to 2017 RAM 3500
- 2014 to 2017 RAM 4500
- 2014 to 2017 RAM 5500

## Recalls for the same vehicles and component

- [2018230](/recalls/tc/2018230.md), 2018-05-03: Accessories
- [2017663](/recalls/tc/2017663.md), 2017-12-22: Accessories
- [17V824000](/recalls/nhtsa/17V824000.md), 2017-12-21: EQUIPMENT
- [2016214](/recalls/tc/2016214.md), 2016-05-12: Accessories
- [2015476](/recalls/tc/2015476.md), 2015-10-16: Accessories
- [15V461000](/recalls/nhtsa/15V461000.md), 2015-07-23: EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.
- [14V100000](/recalls/nhtsa/14V100000.md), 2014-03-04: EQUIPMENT:OTHER:LABELS

## Other bulletins for the same vehicles and component

- [9100229](/bulletins/10248517.md), 2024-01-08, Service bulletin: EQUIPMENT. LIFTER, Hydraulic Roller Deactivating Please do not replace MDS lifters because the disconnecting pin is not lined up, this is normal and not a defect.
- [Recall06A](/bulletins/10244433.md), 2023-10-30, Service bulletin: ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL; EQUIPMENT:OTHER:LABELS. Emissions Recall 06A \- Vehicle Emission Control Information Label
- [93120](/bulletins/10243209.md), 2023-10-02, Service bulletin: EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. FCA Caribbean Warranty Bulletin ID\-23\-20 "Can / Am" Warranty Coverage \- 594 / 595 / 596 WCC
- [93023](/bulletins/10243208.md), 2023-10-02, Service bulletin: EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Warranty Bulletin D\-16\-03 \- "Can / Am" Warranty Coverage \- 594 / 595 / 596 WCC \(Rev. B\)
- [9100196](/bulletins/10242717.md), 2023-09-25, Service bulletin: EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL. Lubrication and Maintenance Fluids If MOPAR fluids and chemicals are not readily available, please review Service Library for specifications so a suitable alternative can be used
- [1804823](/bulletins/10236933.md), 2023-05-30, Service bulletin: EQUIPMENT; ENGINE AND ENGINE COOLING. wiTECH Small Leak Verification Test \(SLVT\) \- P0456\-EVAP SYSTEM SMALL LEAK
- [2103014](/bulletins/10229964.md), 2023-01-17, Service bulletin: EQUIPMENT; POWER TRAIN. Transmission Quick Learn Procedure
- [0802114](/bulletins/10229928.md), 2023-01-17, Service bulletin: EQUIPMENT; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.. RG3 RG4 RJ3 RJ4 Radio Enhancements
- [0810814](/bulletins/10229890.md), 2023-01-17, Service bulletin: ELECTRICAL SYSTEM; EQUIPMENT. RA2 Radio Software Enhancements This bulletin involves updating the radio's software. A customer may have experience one or more of the following: Not able to change state of heated seats and/or steering wheel during stop event on Stop/Start vehicles. Touchscreen confirmation beep may be too loud \(Grand Cherokee only\). U0208\-00 \- Loss Communication With Heated Seat Control Module \(Cherokee only\).Improvements: Only allow vehicle settings to be changed in run mode. To help insure settings are properly saved. Always gray out text message soft keys for non\-supporting devices. Voice Recognition \(VR\) improved accuracy.
- [0810914](/bulletins/10229888.md), 2023-01-17, Service bulletin: EQUIPMENT; ELECTRICAL SYSTEM. RG2 Or RJ2 Radio Software Enhancements This bulletin involves updating the radio's software. A customer may have experience one or more of the following: Not able to change state of heated seats and/or steering wheel during stop event on Stop/Start vehicles. Touchscreen confirmation beep may be too loud. The radio does not allow selection of the Polish language. The radio fan continually runs at high speed. Customer perception may be the radio fan is too loud.Improvements: Only allow vehicle settings to be changed in run mode. To help insure settings are properly saved. Always gray out text message soft keys for non\-supporting devices. Voice Recognition \(VR\) improved accuracy.

JSON: [/v1/bulletins/10139997](/v1/bulletins/10139997)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%209003059&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10139997&vehicle=Service%20bulletin%209003059)