Service bulletin 9003103
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10139658 |
| Published by NHTSA | 2018-06-11 |
| Manufacturer's number | 9003103 |
| Manufacturer's date | 2014-06-18 |
| NHTSA component | FUEL SYSTEM, GASOLINE |
NHTSA's summary
Part Description: Fuel Pump Module Issue Description: This TechTip applies to ONLY Charger (LD) 2011 thru 2014MY vehicles equipped with sales code AHB- Police Group. For vehicles operating under excessive idling condition an alternative high performance pump is available if the customer prefers. Part number 68103913AB or 68145815AA when used with XDC- Fuel Tank
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Fuel system
| DODGE CHARGER | 2011, 2012, 2013 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 0815223 | 2023-08-21. Service bulletin. Fuel Pump Connector Replacement The technician may experience a crank/no start after the fuel pump module was replaced. This bulletin involves replacing the fuel pump connector harness (pigtail) when replacing the fuel pump module. |
|---|---|
| S2208000131 | 2022-09-26. Service bulletin. No Start Condition After A Fuel Pump Replacement, Multiple Fuel System Level Related DTC?s Setting |
| 0900214REVB | 2022-09-26. Service bulletin. MIL Illumination: P0300, P0302, P0304 or P0306 (X56 Warranty Extension) This bulletin involves checking for excessive cylinder leakage and replacing the cylinder head if necessary. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find that any the following Diagnostic Trouble Codes have been set: P0300- Multiple Cylinder Misfire P0302- Cylinder 2 Misfire P0304- Cylinder 4 Misfire P0306- Cylinder 6 Misfire |
| 9003694 | 2022-08-08. Service bulletin. Oil Pump Assembly If error code P06DD present on any Pentastar V6 application, please inspect oil pump for relief valve failure. See photo attached. If valve is found out of place please call Bob Jackson (248) 944-0466 bob.jackson@fcagroup.com, or Joe Lovell (734) 309-6467 joe.lovell@fcagroup.com before proceeding. If unable to reach after 15 minutes record the following information and proceed with oil pump replacement and hold part for return to FCA via Fastrack system |
| 9002838 | 2022-07-25. Service bulletin. 04627731A$ - Trans Vent Hose The upper end of the transmission vent hose terminates with an open elbow. There is no cap on the end of the vent hose. This is intentional. Some graphics in StarParts may show a vent hose including a cap, but this is incorrect. The actual production vent hose has an open elbow fitting, not a cap. The elbow should be pointing downwards in the vehicle.~ |
| 18-007-13 | 2022-07-25. Service bulletin. MIL Illumination P0300 and/or Engine Runs Rough With Factory Fill Fuel This bulletin involves filling the fuel tank with an additional 5 gallons of fuel, driving vehicle, then completing several start/stop cycles. The vehicles involved in this bulletin may contain factory fill fuel that exceeds allowable Driveability Index (DI) levels. NOTE: A Service Porter will be able to complete all necessary repair procedure steps with the exception of Step 7. Only in situations where Step 7 is necessary, should vehicle be dispatched to a Service Technician to clear DTCs. The MIL lamp may be illuminated and upon further investigation the Technician may find DTC P0300 - Multiple Cylinder Misfire has been set active or stored. The Technician may also notice the engine running rough on initial startup (with or without the MIL illuminated). |
| 18-007-13 REV. A | 2022-07-25. Service bulletin. MIL Illumination P0300 and/or Engine Runs Rough With Factory Fill Fuel This bulletin involves filling the fuel tank with an additional 5 gallons of fuel, driving vehicle, then completing several start/stop cycles. The vehicles involved in this bulletin may contain factory fill fuel that exceeds allowable Driveability Index (DI) levels. The MIL lamp may be illuminated and upon further investigation the Technician may find DTC P0300 - Multiple Cylinder Misfire has been set active or stored. The Technician may also notice the engine running rough on initial startup (with or without the MIL illuminated). |
| 18-039-20 | 2020-05-26. Service bulletin. Possible Driveability Issues due to the Winter-Blend Fuel into the Warmer Season |
| UB4 Rev. 6 | 2020-05-26. Service bulletin. Emissions Recall UB4 Evaporative Emissions Canister |
| 18-067-15 | 2018-11-19. Service bulletin. Flash: PCM Software Enhancements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. A small number of customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the Technician may find one of the following Diagnostic Trouble Codes (DTCs) have been set: ? U0401-00 - Implausible Data Received From ECM/PCM ? P0441 - Evap Purge System Performance ? P0340 - Camshaft Position Sensor Circuit - Bank 1 Sensor 1 This software update also has improvements for fuel pump relay cycling during remote starts. |