Service bulletin 17-NA-179

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10137674
Published by NHTSA	2018-05-21
Manufacturer's number	17-NA-179
Manufacturer's date	2017-05-26
NHTSA component	EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.; BACK OVER PREVENTION: SENSING SYSTEM: CAMERA

NHTSA's summary

This technical bulletin provides a procedure to reprogram the radio to correct brightness with the display for the rear view camera.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance, Equipment and accessories, Backup camera

Vehicles listed
BUICK LACROSSE	2017

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
070601016G	2022-06-13. Service bulletin. This informational bulletin provides information on Internal Engine Noise or Damage After Oil Filter Replacement.
PIC6048N	2022-02-14. Service bulletin. This Preliminary Information communicates to the technician that some customers may comment on the operation of their haptic seat during a Lane Keep Assist event. Lane Keep Assist works differently than Lane Departure Warning. The Lane Keep Assist icon is solid amber, Forward Camera Module is actively commanding a torque to Electronic Power Steering. This means that the driver should also feel some feedback from the steering wheel. No Chimes or haptic in the seat. Lane Keep Assist icon is flashing amber; Forward Camera Module is actively commanding torque to Electronic Power Steering. This will also be accompanied with Lane Departure Warning chimes and haptic in the seat feedback based on the setting chosen in the vehicle settings. This will take place when the vehicle has crossed lane marking by (40 cm) or (15.75 in).
21NA030	2021-05-24. Service bulletin. This service bulletin provides a procedure to correct a customer concern of Engine Noise and/or Belt Squeak, MIL Illuminated.
PIC4996C	2021-04-19. Service bulletin. This PI offers diagnostic tips to a technician when diagnosing a possible fuel level sensor concern. The tech is advised to ohm test the sensor at the terminals located on top of the fuel module while performing a sweep test. If the test fails the technician is instructed to replace the sensor and then perform the sweep test again. If the test passes the technician is instructed to reinstall the fuel module in the tank and if the test fails with the new sensor the technician is advised to replace the fuel module.
PIC6424	2021-01-25. Service bulletin. This Preliminary information communicates a condition where there is only newer hardware available when replacing the Active Safety Control Module. The newer hardware is not compatible with whatis currently loaded into the SPS programming system. Engineering is working on a new software set to address the concern.
17NA326	2020-01-27. Service bulletin. This Technical bulletin provides information for rear brake pad replacement to correct a squeak type noise heard from the rear brakes when cold.
PIT5441C	2019-04-08. Service bulletin. This Preliminary Information communication provides information to the technician the steps to diagnose and repair vehicles that may have an Object Detection System Message Diagnostic Trouble Codes U0075, U026A, U026B, U026C, U0265, U0268, and/or U0269 stored in the active safety module. Technician should inspect his Multiple Diagnostic Interface cable for damage. Technician should use the Multiple Diagnostic Interface on a like vehicle with object detection bus or theEL-47955-1 MDI 1, MDI 2 Self-Test Loopback Adapter,if there are no issues found finish with diagnosing the customer’s concern, if concern is present in the like vehicle replace the Multiple Diagnostic Interface cable.
17NA375	2018-06-04. Service bulletin. This informational bulletin provides a diagnostic tip for rear vision camera image that is grainy, distorted and/or pixelated
17NA331	2018-04-23. Service bulletin. This informational bulletin provides information to the customer about the rear camera guidelines not being present at times due to the VBM taking over the rear camera option.
PIP5331E	2018-02-21. Service bulletin. This Preliminary Information communication provides information on a rattle, tick, or knock type noise. Any drivability concerns they should be addressed prior to the following diagnostic progression. A sound file or video with sound of the noise needs to be made prior to dis-assembly to help isolate to one area in the engine. There are four different steps to diagnosis the concern. This communication was updated to include the 2017 and 2018 model year.