# Service bulletin 17NA317

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

- Type: Service bulletin
- NHTSA id: 10137574
- Published by NHTSA: 2018\-05\-21
- Manufacturer's number: 17NA317
- Manufacturer's date: 2018\-04\-06
- NHTSA component: ELECTRICAL SYSTEM:WIRING

## NHTSA's summary

This technical bulletin provides a procedure to repair the crankshaft positioning sensor wiring harness by installing a new wiring harness.

## The document

- [NHTSA's copy of the document (PDF)](https://static.nhtsa.gov/odi/tsbs/2018/MC-10137574-9999.pdf)
- [If that address does not open, try this one](https://static.nhtsa.gov/odi/tsbs/2018/MC-10137574-0001.pdf)

The document is the manufacturer's. This site does not hold it.

## Components

Electrical system, Wiring and fuses

## Vehicles listed

- 2018 BUICK ENCLAVE
- 2018 BUICK LACROSSE
- 2018 BUICK REGAL
- 2018 CADILLAC XT5
- 2018 CHEVROLET TRAVERSE
- 2018 GMC ACADIA

## Other bulletins for the same vehicles and component

- [PIT5962](/bulletins/10230693.md), 2023-01-30, Service bulletin: ELECTRICAL SYSTEM:WIRING. This Preliminary information communicates a GM part number for reflective high temperature heat or insulating tape when repairing wiring harnesses.
- [17\-NA\-292](/bulletins/10190242.md), 2021-04-14, Service bulletin: ELECTRICAL SYSTEM:WIRING:RELAYS/SOLENOIDS; ELECTRICAL SYSTEM:WIRING. Malfunction Indicator Lamp \(MIL\) Illuminated \- DTC P3409 and/or P3433 Condition Some customers may comment that the MIL is illuminated. The technician may find one or more of the following DTCs set: • P3409 • P3433 Cause This condition may be caused by a wiring issue with both/either the cylinder 2 deactivation solenoid oil control valve circuit and/or the cylinder 5 deactivation solenoid oil control valve circuit. These codes may be active or stored in history. • This may also be a repeat concern. Correction Note: When replacing the solenoids, ensure there are no terminal issues at the connector. To correct this condition, refer to the information below: • If vehicle was built between 4/13/2017 and 8/7/2017, it will be necessary to replace both right and left bank Cylinder Deactivation Solenoids \(AFM OCV\). • If vehicle was built outside the date range, check for any terminal issues at the connector. If no trouble found, follow SI diagnostics for the applicable DTC.
- [16NA051](/bulletins/10171876.md), 2020-03-02, Service bulletin: EQUIPMENT ADAPTIVE/MOBILITY; ELECTRICAL SYSTEM:WIRING; EQUIPMENT. This technical bulletin provides a procedure for connector kit and ambient air temperature sensor harness replacement to correct a MIL Illuminated with DTCs and active shutters being inoperative.
- [PIT5606G](/bulletins/10164761.md), 2019-09-16, Service bulletin: ELECTRICAL SYSTEM:WIRING; VISIBILITY. This Preliminary information communicates an Intermittent No Crank, No Start, or Reduced Power loss of data multiple U codes or Intermittent Power Door Locks inoperative, unwanted seat or mirror movement. Inspect harness for chaffed by the I\-shaft at the base of the steering column. If chaffed, repair damaged wires and zip tie the harness away from the I\-shaft. Also Inspect the HVAC drain hose is properly routed and not plugged.
- [17NA292](/bulletins/10159608.md), 2019-05-13, Service bulletin: ENGINE AND ENGINE COOLING; ELECTRICAL SYSTEM:WIRING. This technical bulletin provides a procedure to inspect the wires and/or replace the Valve Rocker Arm Oil Control Valves if the DTCs listed are set.
- [100089005G](/bulletins/10159575.md), 2019-05-13, Service bulletin: ELECTRICAL SYSTEM:WIRING. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs.
- [100089005H](/bulletins/10154629.md), 2019-03-18, Service bulletin: ELECTRICAL SYSTEM:WIRING. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs.
- [17\-NA\-256](/bulletins/10140382.md), 2018-06-11, Service bulletin: ELECTRICAL SYSTEM:WIRING; ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ELECTRICAL SYSTEM: INTEGRATED TRAILER BRAKE CONTROL. This informational bulletin explains where to locate the trailer brake controller blunt ends on the instrument panel wiring harness.
- [18058](/bulletins/10139286.md), 2018-06-04, Service bulletin: ELECTRICAL SYSTEM:WIRING; ELECTRICAL SYSTEM. 18058 \- Service Update. Certain vehicles may have been built with a missing high\-speed controller area network \(CAN\) BUS bridge \(jumper\) wire at the body control module \(BCM\) connector. Vehicles without these circuits can have intermittent communication issues on the CAN BUS, affecting functionality of several electronic modules, leading to various electrical concerns including a walk home failure. Install missing circuits to BCM connector X6.
- [17NA292](/bulletins/10134583.md), 2018-04-23, Service bulletin: ELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ELECTRICAL SYSTEM:WIRING. This technical bulletin provides a procedure to inspect the wires and/or replace the Valve Rocker Arm Oil Control Valves if the DTCs listed are set.

JSON: [/v1/bulletins/10137574](/v1/bulletins/10137574)

[Report an error on this page](https://github.com/wenmar-pro/wenmar-open/issues/new?template=data_correction.yml&title=Data%20correction%3A%20Service%20bulletin%2017NA317&page=https%3A%2F%2Fopen.wenmarpro.com%2Fbulletins%2F10137574&vehicle=Service%20bulletin%2017NA317)